We have shown that in presence of a cosmic magnetic field the bounds on baryon dark matter cross-section ($\hat \sigma$), dark-matter mass ($m_d$) and values of the magnetic field ($B_0$) can strongly influence each other. This requires to rework the bounds on $\hat \sigma\,$, $m_d$ and $B_0$ which can explain the observed absorption signal by EDGES collaboration. The upper limit on the magnetic field strength can modify in presence of baryon-dark matter interaction cross-section. In the presence of a strong magnetic field, a large baryon-dark matter interaction cross-section is required to balance magnetic heating of gas to explain the EDGES signal as compared to a weak magnetic field. Subsequently, the strong magnetic-fields can even erase the 21 cm signal--this gives an upper bound on the strength of magnetic-fields, dark-matter mass and baryon-dark matter cross-section. In the special case when $\hat \sigma$=0, one can recover the bound on magnetic field strength calculated in [1]. In this work we find that the allowed range of the primordial magnetic field can increase by three orders of magnitude in comparison with [1]. We get upper bound on the magnetic field strength: $3.48\times10^{-6}$ G for the dark matter mass $\lesssim 10^{-2}$ GeV.

We confront admixture of dark matter inside neutron star using gravitational wave constraints coming from binary neutron star merger. We consider a relativistic mean field model including $\sigma-\omega-\rho$ meson interaction with NL3 parameterization. We study fermionic dark matter interacting with nucleonic matter via Higgs portal mechanism. We show that admixture of dark matter inside the neutron star soften the equation state and lower the value of tidal deformability. Gravitational wave GW170817 observation puts an upper bound on tidal deformability of a binary neutron star with low spin prior at 90\% confidence level, which disfavors stiff equation of state such as Walecka model with NL3 parameterization. However, we show that Walecka model with NL3 parameterization with a fermionic dark matter component satisfy the tidal deformability bound coming from the GW170817 observation.

The EDGES experiment has detected the global absorption signal of 21 cm line at $z\sim17$ in cosmic dawn era and reported its amplitude larger than the standard cosmological prediction. One of the possible explanation requires that the baryons were much cooler than the standard scenario. This requires an interaction between the dark and baryonic sectors with some appropriate cross-section, $ \hat{\sigma} $. In this work, we examine the role that dissipative effects of cosmic fluid might play in influencing the 21 cm signal. We show that the presence of viscous dissipation of dark matter can significantly affect the energy transfer between the baryonic and dark matter fluids. It is demonstrated that the inclusion of the dissipative mechanism in the dark sector, strongly modify the earlier constraints on dark matter mass and $ \hat{\sigma} $ obtain from EDGES observation. Further, we argue that EDGES absorption signal can put an independent bound on dark matter viscosity which is many order of magnitude larger than the maximum viscosity allowed by the structure formation.

The project "Novel Astronomical Instrumentation through photonic Reformatting" is a DFG-funded collaboration to exploit the recognized potential of photonics solutions for a radically new approach to astronomical instrumentation for optical/infrared high precision spectroscopy and high angular resolution imaging. We present a project overview and initial development results from our Adaptive Optics-photonic test bed, Ultrafast Laser Inscribed waveguides for interferometric beam combination and 3D printing structures for astronomical instrumentation. The project is expected to lead to important technological breakthroughs facilitating uniquely functionality and technical solutions for the next generation of instrumentation.

We consider scenarios in which the annihilation of self-conjugate spin-1 dark matter to a Standard Model fermion-antifermion final state is chirality suppressed, but where this suppression can be lifted by the emission of an additional photon via internal bremsstrahlung. We find that this scenario can only arise if the initial dark matter state is polarized, which can occur in the context of self-interacting dark matter. In particular, this is possible if the dark matter pair forms a bound state that decays to its ground state before the constituents annihilate. We show that the shape of the resulting photon spectrum is the same as for self-conjugate spin-0 and spin-1/2 dark matter, but the normalization is less heavily suppressed in the limit of heavy mediators.

We have initiated the High-Altitude Ballooning programme at Indian Institute of Astrophysics, Bangalore, in the year 2011 with the primary purpose of developing and flying low-cost scientific payloads on a balloon-borne platform. The main aim is the observations of extended nearby objects (e.g. comets) and of diffuse sources (e.g. zodiacal light or airglow) with wide field of view (FOV) UV instruments from near space (20 to 30 km). A brief summary and the results of the tethered flights carried out at IIA CREST campus are given in Ref.~1. Here we present an overview of the nine free-flying balloon experiments conducted from March 2013 to November 2014. We describe the launch procedures, payloads, methods of tracking and recovery. Since we fall in the light balloon category --- payload weight is limited to less than 6 kg --- we use the 3-D printer to fabricate lightweight boxes and structures for our experiments. We discuss the flight and scientific data obtained from different launches and the development of the in-house lightweight sensors and controllers, as well as a fully-fledged 2-axis pointing and stabilization system, for the flights.

We have developed a lightweight low-cost attitude sensor, based on a Raspberry Pi, built with readily available commercial components. It can be used in experiments where weight and power are constrained, such as in high- altitude lightweight balloon flights. This attitude sensor will be used as a major building block in a closed-loop control system with driver motors to stabilize and point cameras and telescopes for astronomical observations from a balloon-borne payload.

We have begun a program of high altitude ballooning at the Indian Institute of Astrophysics, Bangalore. Recent advances in balloons as well as in electronics have made possible scientific payloads at costs accessible to university departments. The primary purpose of this activity is to test low-cost ultraviolet (UV) payloads for eventual space flight, but to also explore phenomena occurring in the upper atmosphere, including sprites and meteorite impacts, using balloon-borne payloads. This paper discusses the results of three tethered balloon experiments carried out at the CREST campus of IIA, Hosakote and our plans for the future. We also describe the stages of payload development for these experiments.

A steradian of the southern sky has been imaged at 151.5 MHz using the Mauritius Radio Telescope (MRT). These images show systematics in positional errors of sources when compared to source positions in the Molonglo Reference Catalogue (MRC). We have applied two-dimensional homography to correct for systematic positional errors in the image domain and thereby avoid re-processing the visibility data. Positions of bright (above 15-{\sigma}) point sources, common to MRT catalogue and MRC, are used to set up an over-determined system to solve for the homography matrix. After correction the errors are found to be within 10% of the beamwidth for these bright sources and the systematics are eliminated from the images. This technique will be of relevance to the new generation radio telescopes where, owing to huge data rates, only images after a certain integration would be recorded as opposed to raw visibilities. It is also interesting to note how our investigations cued to possible errors in the array geometry. The analysis of positional errors of sources showed that MRT images are stretched in declination by ~1 part in 1000. This translates to a compression of the baseline scale in the visibility domain. The array geometry was re-estimated using the astrometry principle. The estimates show an error of ~1 mm/m, which results in an error of about half a wavelength at 150 MHz for a 1 km north-south baseline. The estimates also indicate that the east-west arm is inclined by an angle of ~40 arcsec to the true east-west direction.

This paper describes a 50 MHz system being developed for GMRT to provide imaging capability in the frequency range 30-90MHz. Due to its larger collecting area and higher antenna efficiency, the low frequency GMRT system will be several times more sensitive than the present 74 MHz VLA system and is likely to remain a competitive instrument in this frequency band. In the first phase of this project, receiver systems consisting of V-dipole feeds and front-ends have been installed on four of the thirty GMRT antennas. Test observations were carried out on a number of bright 3C sources. The initial results are encouraging. This paper will also describe results of simultaneous observations carried out using the existing GMRT correlator, the new GMRT software correlator and a system employing digitization and direct recording of signals at two antenna bases.

A 12-metre Preloaded Parabolic Dish antenna, in which the backup structure is formed by preloading its radial and circumferential members, has been designed, built and commissioned by the Raman Research Institute, Bangalore. This paper reports the first-ever photogrammetric measurements of gravity-induced deformation in the primary reflector of an antenna built using this novel concept of preloading the backup structure. Our experience will be of relevance to radio astronomy and deep space network applications that require building lightweight and economical steerable parabolic antennas.

The Mauritius Radio Telescope (MRT) images show systematics in the positional errors of sources when compared to source positions in the Molonglo Reference Catalogue (MRC). We have applied two-dimensional homography to correct positional errors in the image domain and avoid re-processing the visibility data. Positions of bright (above 15-$\sigma$) sources, common to MRT and MRC catalogues, are used to set up an over-determined system to solve for the 2-D homography matrix. After correction, the errors are found to be within 10% of the beamwidth for these bright sources and the systematics are eliminated from the images.