We apply the independent component analysis (ICA) to the real data from a gravitational wave detector for the first time. Specifically we use the iKAGRA data taken in April 2016, and calculate the correlations between the gravitational wave strain channel and 35 physical environmental channels. Using a couple of seismic channels which are found to be strongly correlated with the strain, we perform ICA. Injecting a sinusoidal continuous signal in the strain channel, we find that ICA recovers correct parameters with enhanced signal-to-noise ratio, which demonstrates usefulness of this method. Among the two implementations of ICA used here, we find the correlation method yields the optimal result for the case environmental noises act on the strain channel linearly.

High-speed impact ejecta at velocities comparable to the impact velocity are expected to contribute to material transport between planetary bodies and deposition of ejecta far from the impact crater. We investigated the behavior of high-speed ejecta produced at angles of 45 and 90 degrees, using both experimental and numerical methods. The experimental system developed at the Planetary Exploration Research Center of Chiba Institute of Technology (Japan) allowed us to observe the initial growth of the ejecta. We succeeded in imaging high-speed ejecta at 0.2 $\mathrm{{\mu}}$s intervals for impacts of polycarbonate projectiles of 4.8 mm diameter onto a polycarbonate plate at an impact velocity of ~4 km s$^{-1}$. Smoothed particle hydrodynamics (SPH) simulations of various numerical resolutions were conducted for the same impact conditions as pertaining to the experiments. We compared the morphology and velocities of the ejecta for the experiments and simulations, and we confirmed a close match for high-resolution simulations (with $\geq10^6$ SPH particles representing the projectile). According to the ejecta velocity distributions obtained from our high-resolution simulations, the ejection velocities of the high-speed ejecta for oblique impacts are much greater than those for vertical impacts. The translational motion of penetrating projectiles parallel to the target surface in oblique impacts could cause long-term, sustained acceleration at the root of the ejecta.

Dry lakebeds might constitute large volatile reservoirs on Mars. Hypervelocity impacts onto ancient dry lakebeds would have affected the volatile distribution on Mars. We developed a new experimental method to investigate the response of evaporitic minerals (halite and gypsum) to impact shocks in an open system. This technique does not result in chemical contamination from the operation of the gas gun. The technique is termed the two-valve method and the gun system is located in the Planetary Exploration Research Center, Chiba Institute of Technology, Japan. We detected the vaporization of halite at 31 GPa and devolatilization from gypsum at 11 GPa, suggesting that impact-induced volatile release from dry lakebeds has periodically occurred throughout Martian history. The vaporization of halite deposits might have enhanced the production of perchlorates, which are found globally on Mars. The water loss from gypsum possibly explains the coexisting types of Ca-sulfates found in Gale Crater.

KAGRA is a second-generation interferometric gravitational-wave detector with 3-km arms constructed at Kamioka, Gifu in Japan. It is now in its final installation phase, which we call bKAGRA (baseline KAGRA), with scientific observations expected to begin in late 2019. One of the advantages of KAGRA is its underground location of at least 200 m below the ground surface, which brings small seismic motion at low frequencies and high stability of the detector. Another advantage is that it cools down the sapphire test mass mirrors to cryogenic temperatures to reduce thermal noise. In April-May 2018, we have operated a 3-km Michelson interferometer with a cryogenic test mass for 10 days, which was the first time that km-scale interferometer was operated at cryogenic temperatures. In this article, we report the results of this "bKAGRA Phase 1" operation. We have demonstrated the feasibility of 3-km interferometer alignment and control with cryogenic mirrors.

The recent detections of gravitational waves (GWs) reported by LIGO/Virgo collaborations have made significant impact on physics and astronomy. A global network of GW detectors will play a key role to solve the unknown nature of the sources in coordinated observations with astronomical telescopes and detectors. Here we introduce KAGRA (former name LCGT; Large-scale Cryogenic Gravitational wave Telescope), a new GW detector with two 3-km baseline arms arranged in the shape of an "L", located inside the Mt. Ikenoyama, Kamioka, Gifu, Japan. KAGRA's design is similar to those of the second generations such as Advanced LIGO/Virgo, but it will be operating at the cryogenic temperature with sapphire mirrors. This low temperature feature is advantageous for improving the sensitivity around 100 Hz and is considered as an important feature for the third generation GW detector concept (e.g. Einstein Telescope of Europe or Cosmic Explorer of USA). Hence, KAGRA is often called as a 2.5 generation GW detector based on laser interferometry. The installation and commissioning of KAGRA is underway and its cryogenic systems have been successfully tested in May, 2018. KAGRA's first observation run is scheduled in late 2019, aiming to join the third observation run (O3) of the advanced LIGO/Virgo network. In this work, we describe a brief history of KAGRA and highlights of main feature. We also discuss the prospects of GW observation with KAGRA in the era of O3. When operating along with the existing GW detectors, KAGRA will be helpful to locate a GW source more accurately and to determine the source parameters with higher precision, providing information for follow-up observations of a GW trigger candidate.

Major construction and initial-phase operation of a second-generation gravitational-wave detector KAGRA has been completed. The entire 3-km detector is installed underground in a mine in order to be isolated from background seismic vibrations on the surface. This allows us to achieve a good sensitivity at low frequencies and high stability of the detector. Bare-bones equipment for the interferometer operation has been installed and the first test run was accomplished in March and April of 2016 with a rather simple configuration. The initial configuration of KAGRA is named {\it iKAGRA}. In this paper, we summarize the construction of KAGRA, including the study of the advantages and challenges of building an underground detector and the operation of the iKAGRA interferometer together with the geophysics interferometer that has been constructed in the same tunnel.

KAGRA is a 3-km interferometric gravitational wave telescope located in the Kamioka mine in Japan. It is the first km-class gravitational wave telescope constructed underground to reduce seismic noise, and the first km-class telescope to use cryogenic cooling of test masses to reduce thermal noise. The construction of the infrastructure to house the interferometer in the tunnel, and the initial phase operation of the interferometer with a simple 3-km Michelson configuration have been completed. The first cryogenic operation is expected in 2018, and the observing runs with a full interferometer are expected in 2020s. The basic interferometer configuration and the current status of KAGRA are described.

The nature of electroweak (EW) phase transition (PT) is of great importance. It may give a clue to the origin of baryon asymmetry if EWPT is strong first order. Although it is second order within the standard model (SM), a great many extensions of the SM are capable of altering the nature. Thus, gravitational wave (GW), which is supposed to be relics of strong first order PT, is a good complementary probe to new physics beyond SM (BSM). We in this paper elaborate the patterns of strong first order EWPT in the next to simplest extension to the SM Higgs sector, by introducing a $Z_3$-symmetric singlet scalar. We find that, in the $Z_3$-symmetric limit, the tree level barrier could lead to strong first order EWPT either via three or two-step PT. Moreover, they could produce two sources of GW, despite of the undetectability from the first-step strong first order PT for the near future GW experiments. But the other source with significant supercooling which then gives rise to $\alpha\sim{\cal O}(0.1)$ almost can be wholly covered by future space-based GW interferometers such as eLISA, DECIGO and BBO.

We study the three-dimensional (3D) compact U(1) lattice gauge theory coupled with $N$-flavor Higgs fields by means of the Monte Carlo simulations. This model is relevant to multi-component superconductors, antiferromagnetic spin systems in easy plane, inflational cosmology, etc. It is known that there is no phase transition in the N=1 model. For N=2, we found that the system has a second-order phase transition line $\tilde{c}_1(c_2)$ in the $c_2$(gauge coupling)$-c_1$(Higgs coupling) plane, which separates the confinement phase and the Higgs phase. Numerical results suggest that the phase transition belongs to the universality class of the 3D XY model as the previous works by Babaev et al. and Smiseth et al. suggested. For N=3, we found that there exists a critical line similar to that in the N=2 model, but the critical line is separated into two parts; one for $c_2 < c_{2{\rm tc}}=2.4\pm 0.1$ with first-order transitions, and the other for $ c_{2{\rm tc}} < c_2$ with second-order transitions, indicating the existence of a tricritical point. We verified that similar phase diagram appears for the N=4 and N=5 systems. We also studied the case of anistropic Higgs coupling in the N=3 model and found that there appear two second-order phase transitions or a single second-order transition and a crossover depending on the values of the anisotropic Higgs couplings. This result indicates that an "enhancement" of phase transition occurs when multiple phase transitions coincide at a certain point in the parameter space.

According to our common understandings, the original surface of a short-period comet nucleus has been lost by sublimation processes during its close approaches to the Sun. Sublimation results in the formation of a dust mantle on the retreated surface and in chemical differentiation of ices over tens or hundreds of meters below the mantle. In the course of NASA's Deep Impact mission, optical and infrared imaging observations of the ejecta plume were conducted by several researchers, but their interpretations of the data came as a big surprise: (1) The nucleus of comet 9P/Tempel 1 is free of a dust mantle, but maintains its pristine crust of submicron-sized carbonaceous grains; (2) Primordial materials are accessible already at a depth of several tens of cm with abundant silicate grains of submicrometer sizes. In this study, we demonstrate that a standard model of cometary nuclei explains well available observational data: (1) A dust mantle with a thickness of ~1-2 m builds up on the surface, where compact aggregates larger than tens of micrometers dominate; (2) Large fluffy aggregates are embedded in chemically differentiated layers as well as in the deepest part of the nucleus with primordial materials. We conclude that the Deep Impact results do not need any peculiar view of a comet nucleus.