In this paper, results of 2.5-dimensional magnetohydrodynamical simulations are reported for the magnetic reconnection of non-perfectly antiparallel magnetic fields. The magnetic field has a component perpendicular to the computational plane, that is, guide field. The angle theta between magnetic field lines in two half regions is a key parameter in our simulations whereas the initial distribution of the plasma is assumed to be simple; density and pressure are uniform except for the current sheet region. Alfven waves are generated at the reconnection point and propagate along the reconnected field line. The energy fluxes of the Alfven waves and magneto-acoustic waves (slow mode and fast mode) generated by the magnetic reconnection are measured. Each flux shows the similar time evolution independent of theta. The percentage of the energies (time integral of energy fluxes) carried by the Alfven waves and magneto-acoustic waves to the released magnetic energy are calculated. The Alfven waves carry 38.9%, 36.0%, and 29.5% of the released magnetic energy at the maximum (theta=80^\circ) in the case of beta=0.1, 1, and 20 respectively, where beta is the plasma beta (the ratio of gas pressure to magnetic pressure). The magneto-acoustic waves carry 16.2% (theta=70^\circ), 25.9% (theta=60^\circ), and 75.0% (theta=180^\circ) of the energy at the maximum. Implications of these results for solar coronal heating and acceleration of high-speed solar wind are discussed.

We report the results of 3-dimensional magnetohydrodynamic (MHD) simulations of a jet formation by the interaction between an accretion disk and a large scale magnetic field. The disk is not treated as a boundary condition but is solved self-consistently. To investigate the stability of MHD jet, the accretion disk is perturbed with a non-axisymmetric sinusoidal or random fluctuation of the rotational velocity. The dependences of the jet velocity $(v_z)$, mass outflow rate $(\dot{M}_w)$, and mass accretion rate $(\dot{M}_a)$ on the initial magnetic field strength in both non-axisymmetric cases are similar to those in the axisymmetric case. That is, $v_z \propto B_0^{1/3}$, $\dot{M}_w \propto B_0$ and $\dot{M}_a \propto B_0^{1.4}$ where $B_0$ is the initial magnetic field strength. The former two relations are consistent with the Michel's steady solution, $v_z \propto (B_0^2/\dot{M}_w)^{1/3}$, although the jet and accretion do not reach the steady state. In both perturbation cases, a non-axisymmetric structure with $m=2$ appears in the jet, where $m$ means the azimuthal wave number. This structure can not be explained by Kelvin-Helmholtz instability and seems to originate in the accretion disk. Non-axisymmetric modes in the jet reach almost constant levels after about 1.5 orbital periods of the accretion disk, while all modes in the accretion disk grow with oscillation. As for the angular momentum transport by Maxwell stress, the vertical component, $<B_\phi B_z/4\pi>$, is comparable to the radial component, $<B_\phi B_r/4\pi>$, in the wide range of initial magnetic field strength.

We propose a new mechanism to explain the radio Arc and threads in the Galactic Center by current sheets produced by local magnetic shears due to interaction of a moving cloud and the vertical field based on three-dimensional magneto-hydrodynamical simulations. Magnetic reconnetion and acceleration of cosmic-ray electrons in the current sheet will result in high contrast of radio emissivity inside and outside the Arc and threads.

Distributions of Faraday rotation measure (FRM) and the projected magnetic field derived by a 3-dimensional simulation of MHD jets are investigated based on our "sweeping magnetic twist model". FRM and Stokes parameters were calculated to be compared with radio observations of large scale wiggled AGN jets on kpc scales. We propose that the FRM distribution can be used to discuss the 3-dimensional structure of magnetic field around jets and the validity of existing theoretical models, together with the projected magnetic field derived from Stokes parameters. In the previous paper, we investigated the basic straight part of AGN jets by using the result of a 2-dimensional axisymmetric simulation. The derived FRM distribution has a general tendency to have a gradient across the jet axis, which is due to the toroidal component of the magnetic field generated by the rotation of the accretion disk. In this paper, we consider the wiggled structure of the AGN jets by using the result of a 3-dimensional simulation. Our numerical results show that the distributions of FRM and the projected magnetic field have a clear correlation with the large scale structure of the jet itself, namely, 3-dimensional helix. Distributions, seeing the jet from a certain direction, show a good matching with those in a part of 3C449 jet. This suggests that the jet has a helical structure and that the magnetic field (especially the toroidal component) plays an important role in the dynamics of the wiggle formation because it is due to a current-driven helical kink instability in our model.

Using the numerical data of MHD simulation for AGN jets based on our ``sweeping magnetic twist model'', we calculated the Faraday rotation measure (FRM) and the Stokes parameters to compare with observations. We propose that the FRM distribution can be used to discuss the 3-dimensional structure of magnetic field around jets, together with the projected magnetic field derived from the Stokes parameters. In the present paper, we supposed the basic straight part of AGN jet, and used the data of axisymmetric simulation. The FRM distribution we derived has a general tendency to have gradient across the jet axis, which is due to the toroidal component of the helical magnetic field generated by the rotation of the accretion disk. This kind of gradient in the FRM distribution is actually observed in some AGN jets (e.g. Asada et al. 2002), which suggests helical magnetic field around the jets and thus supports our MHD model. Following this success, we are now extending our numerical observation to the wiggled part of the jets using the data of 3-dimensional simulation based on our model in the following paper.