This paper presents highly precise measurements of thermal expansion of a "hybrid" carbon-fiber reinforced silicon carbide composite, HB-Cesic\textregistered - a trademark of ECM, in the temperature region of \sim310-10K. Whilst C/SiC composites have been considered to be promising for the mirrors and other structures of space-borne cryogenic telescopes, the anisotropic thermal expansion has been a potential disadvantage of this material. HB-Cesic\textregistered is a newly developed composite using a mixture of different types of chopped, short carbon-fiber, in which one of the important aims of the development was to reduce the anisotropy. The measurements indicate that the anisotropy was much reduced down to 4% as a result of hybridization. The thermal expansion data obtained are presented as functions of temperature using eighth-order polynomials separately for the horizontal (XY-) and vertical (Z-) directions of the fabrication process. The average CTEs and their dispersion (1{\sigma}) in the range 293-10K derived from the data for the XY- and Z-directions were 0.805$\pm$0.003\times10$^{-6}$ K$^{-1}$ and 0.837\pm0.001\times10$^{-6}$ K$^{-1}$, respectively. The absolute accuracy and the reproducibility of the present measurements are suggested to be better than 0.01\times10$^{-6}$ K$^{-1}$ and 0.001\times(10)^{-6} K^{-1}, respectively. The residual anisotropy of the thermal expansion was consistent with our previous speculation regarding carbon-fiber, in which the residual anisotropy tended to lie mainly in the horizontal plane.

We report on the performance of an analog application-specific integrated circuit (ASIC) developed aiming for the front-end electronics of the X-ray CCDcamera system onboard the next X-ray astronomical satellite, ASTRO-H. It has four identical channels that simultaneously process the CCD signals. Distinctive capability of analog-to-digital conversion enables us to construct a CCD camera body that outputs only digital signals. As the result of the front-end electronics test, it works properly with low input noise of =<30 uV at the pixel rate below 100 kHz. The power consumption is sufficiently low of about 150 mW/chip. The input signal range of 720 mV covers the effective energy range of the typical X-ray photon counting CCD (up to 20 keV). The integrated non-linearity is 0.2% that is similar as those of the conventional CCDs in orbit. We also performed a radiation tolerance test against the total ionizing dose (TID) effect and the single event effect. The irradiation test using 60Co and proton beam showed that the ASIC has the sufficient tolerance against TID up to 200 krad, which absolutely exceeds the expected amount of dose during the period of operating in a low-inclination low-earth orbit. The irradiation of Fe ions with the fluence of 5.2x10^8 Ion/cm2 resulted in no single event latchup (SEL), although there were some possible single event upsets. The threshold against SEL is higher than 1.68 MeV cm^2/mg, which is sufficiently high enough that the SEL event should not be one of major causes of instrument downtime in orbit.

We report here the in orbit performance of the CCD camera (MAXI/SSC) onboard the International Space Station (ISS). It was commissioned in August, 2009. This is the first all-sky survey mission employing X-ray CCDs. It consists of 32 CCDs each of which is 1 inch square. It is a slit camera with a field of view of 1deg.5x 90deg and scans the sky as the rotation of the ISS. The CCD on the SSC is cooled down to the working temperature around -60degC by the combination of the peltier cooler, a loop heat pipe and a radiator. The standard observation mode of the CCD is in a parallel sum mode (64-binning). The CCD functions properly although it suffers an edge glow when the Sun is near the field of view (FOV) which reduces the observation efficiency of the SSC down to about 30%. The performance of the CCD is continuously monitored both by the Mn-K X-rays and by the Cu-K X-rays. There are many sources detected, not only point sources but extended sources. Due to the lack of the effective observation time, we need more observation time to obtain an extended emission analysis extraction process.

Solid-state Slit Camera (SSC) is an X-ray camera onboard the MAXI mission of the International Space Station. Two sets of SSC sensors view X-ray sky using charge-coupled devices (CCDs) in 0.5--12\,keV band. The total area for the X-ray detection is about 200\,cm$\rm ^2$ which is the largest among the missions of X-ray astronomy. The energy resolution at the CCD temperature of $-$70 \degc is 145\,eV in full width at the half maximum (FWHM) at 5.9\,keV, and the field of view is 1\deg .5 (FWHM) $\times$ 90\deg for each sensor. The SSC could make a whole-sky image with the energy resolution good enough to resolve line emissions, and monitor the whole-sky at the energy band of $<$ 2\,keV for the first time in these decades.

The MAXI (Monitor of All-sky X-ray Image) mission is the first astronomical payload to be installed on the Japanese Experiment Module-Exposed Facility (JEM-EF) on the ISS. It is scheduled for launch in the middle of 2009 to monitor all-sky X-ray objects on every ISS orbit. MAXI will be more powerful than any previous X-ray All Sky Monitor (ASM) payloads, being able to monitor hundreds of AGN. MAXI will provide all sky images of X-ray sources of about 20 mCrab in the energy band of 2-30 keV from observation on one ISS orbit (90 min), about 4.5 mCrab for one day, and about 1 mCrab for one month. A final detectability of MAXI could be 0.2 mCrab for 2 year observations.

One of the advantages of the X-ray Imaging Spectrometer (XIS) system on board Suzaku is its low and stable non-X-ray background (NXB). In order to make the best use of this advantage, modeling the NXB spectra with high accuracy is important to subtract them from the spectra of on-source observations. We construct an NXB database by collecting XIS events when the dark Earth covers the XIS FOV. The total exposure time of the NXB data is about 785 ks for each XIS. It is found that the count rate of the NXB anti-correlates with the cut-off-rigidity and correlates with the count rate of the PIN upper discriminator (PIN-UD) in Hard X-ray Detector on board Suzaku. We thus model the NXB spectrum for a given on-source observation by employing either of these parameters and obtain a better reproducibility of the NXB for the model with PIN-UD than that with the cut-off-rigidity. The reproducibility of the NXB model with PIN-UD is 4.55-5.63% for each XIS NXB in the 1-7 keV band and 2.79-4.36% for each XIS NXB in the 5-12 keV band for each 5 ks exposure of the NXB data. This NXB reproducibility is much smaller than the spatial fluctuation of the cosmic X-ray background in the 1-7 keV band, and is almost comparable to that in the 5-12 keV band.

We study the total gravitating mass distribution in the central region of 23 clusters of galaxies with Chandra. Using a new deprojection technique, we measure the temperature and gas density in the very central region of the clusters as a function of radius without assuming any particular models. Under the assumptions of hydrostatic equilibrium and spherical symmetry, we obtain the deprojected mass profiles of these clusters. The mass profiles are nicely scalable with a characteristic radius ($r_{200}$) and mass ($M_{200}$) on the large scale of $r>0.1r_{200}$. In contrast, the central ($r<0.1r_{200}$) mass profiles have a large scatter even after the scaling. The inner slope $\alpha$ of the total mass density profile ($\rho(r) \propto r^{-\alpha}$) is derived from the slope of the integrated mass profile. The values of the inner slope $\alpha$ at the radius of $0.02r_{200}$ ($\alpha_0$) span a wide range from 0 to 1.2. For 6 out of 20 clusters, $\alpha_0$ is lower than unity at a 90 % confidence level. CDM simulations predict that the inner slope $\alpha$ is in the range $1<\alpha<2$, which is inconsistent with our results. We also found that the gas fraction near the center of a cluster has a negative correlation with $\alpha_0$. Our result suggests that the gas-rich clusters in the central region tend to have a flat core.

Saturn's largest satellite, Titan, transited the Crab Nebula on 5 January 2003. We observed this astronomical event with the {\it Chandra} X-ray Observatory. An ``occultation shadow'' has clearly been detected and is found to be larger than the diameter of Titan's solid surface. The difference gives a thickness for Titan's atmosphere of 880 $\pm$ 60 km. This is the first measurement of Titan's atmospheric extent at X-ray wavelengths. The value measured is consistent with or slightly larger than those estimated from earlier Voyager observations at other wavelengths. We discuss the possibility of temporal variations in the thickness of Titan's atmosphere.

We investigate the relation between the properties of Brightest Cluster Galaxies (BCGs) and those of their host clusters. To quantify the properties of cluster hot gas, we employ the parameter $Z$ of the fundamental plane of X-ray clusters. It is found that the offset of the BCG from the peak of cluster X-ray emission is larger for smaller $Z$ clusters. The parameter $Z$ (not the redshift {\it z}), which mainly depends on virial density $\rho_{\rm {vir}}$, is considered to represent the formation epoch of a cluster. We thus consider that the offset of the BCG is correlated with the dynamical equilibrium state of its host cluster. On the contrary, no significant correlation is found between the absolute optical magnitude of the BCG and the parameter $Z$. If the extreme brightness of the BCG is mainly acquired in the course of cluster evolution by environmental effect, BCGs are expected to be brighter in large $Z$ clusters. Our result is not consistent with this simplified view. On the contrary, it is possible that the extreme brightness of the BCG is likely to be determined in the early history of cluster collapse.

We have investigated the background properties of EPIC-pn onboard XMM-Newton to establish the background subtraction method. Count rates of the background vary violently by two orders of magnitude at the maximum, while during the most quiet period, these are stable within 8 % at a 1 $\sigma$ level. The overall spectrum is dominated by particle events above 5 keV, and its spatial variation is also found. The long-term variation of the background is also investigated with CAL CLOSED data, where the filter wheel was in closed position with the internal calibration source illuminating the sensitive area. The average background count rate decreased by 20 % from March 2000 to January 2001, but it regained in February 2001. For the modeling of the background spectrum, we investigate relations between the 2.0--7.0 keV count rate and some characteristic parameters. The 2.0--7.0 keV background count rate shows a good correlation with the count rate of events outside the field of view. This correlation is usable for the modeling of the background.

Understanding a background is crucial in particular for a study of low surface brightness objects. In order to establish the background subtraction method, we have studied properties of the EPIC background. Count rates of the background vary violently by two order of magnitude at the maximum, while during the most quiet period, these are stable within 8 % at a 1 $\sigma$ level. The overall spectrum is dominated by particle events above 5 keV, and its spatial variation is also found. The long-term variation of the background is also investigated with CAL CLOSED data, which is the data of calibration source with filter closed. The average background count rate decreased by 20 % from March 2000 to January 2001, but it regained in February 2001. For the modeling of the background spectrum, we investigate correlations between the 2-10 keV count rate and some characteristic parameters. The PN background shows a good correlation with some parameters. On the other hands, the MOS background does not shows a clear correlation. Further investigation is needed for the MOS background. Our final goal is to establish a method to predict the background, for which these results will be reflected in the background generator.

We observed the nearest gravitational lensing cluster candidate, A 3408 (${\it z}=0.042$), with ASCA. The projected mass profile of A 3408 was determined from the ICM temperature and the $\beta$-model parameters obtained with ASCA, assuming that the hot gas is spherically symmetric and in hydrostatic equilibrium. The projected mass within an arc radius, $r_{\rm arc}$, of 110 kpc is $M(r_{\rm arc})=1.2^{+0.8}_{-0.4} \times10^{13} \MO$. This is 18 -- 45% of the mass previously derived from a lensing analysis by Campusano et al. (1998, AAA 069.160.189) without any X-ray information. The primary cause of this discrepancy is in their assumption that the center of the cluster potential coincides with the position of the brightest cluster galaxy (BCG), while we reveal the BCG position to be 60$''$ outside of the X-ray center. We further calculated a model for the source galaxy position and the gravitational potential that can reproduce both the X-ray data and the arc image. In this model, the magnification factor of the lens for the source galaxy was evaluated to be ${\Delta}m=$ 0.07$\pm$0.03 mag; i.e., the source galaxy is slightly magnified by the lens cluster A 3408.