Normalized to: Jiao, C.
[1]
oai:arXiv.org:2003.02056 [pdf] - 2059290
Three-dimensional simulations of accretion flow in the progenitor of
Tycho's supernova
Submitted: 2020-03-04
We run three-dimensional numerical simulations for the accretion flow around
the white dwarf (WD) in the progenitor system of Tycho's supernova (SN). The
mass of the WD, mass of the companion star, and the orbital period are set to
be 1$M_{\odot}$, 1.6$M_{\odot}$, and 0.794 day, respectively, based on
theoretical and observational researches of Tycho's SN remnant (SNR). We find
that when the magnetic field in the accreted material is negligible, outflowing
wind is concentrated near the equatorial plane. When the magnetic field has
energy equipartition with internal energy, polar wind is comparable with the
equatorial wind. A carefully chosen magnetic field between the above two cases
($B=5.44\times10^3 \rm{G}$) can roughly reproduce the latitude-dependent wind
required to form the peculiar periphery of Tycho's SNR.
[2]
oai:arXiv.org:1504.06468 [pdf] - 1182987
Comparison between RHD simulation of supercritical accretion flows and
steady model with outflows
Submitted: 2015-04-24
We apply our two-dimensional (2D), radially self-similar steady-state
accretion flow model to the analysis of hydrodynamic simulation results of
supercritical accretion flows. Self-similarity is checked and the input
parameters for the model calculation, such as advective factor and heat
capacity ratio, are obtained from time-averaged simulation data. Solutions of
the model are then calculated and compared with the simulation results. We find
that in the converged region of the simulation, excluding the part too close to
the black hole, the radial distribution of azimuthal velocity $v_\phi$, density
$\rho$ and pressure $p$ basically follows the self-similar assumptions, i.e.
they are roughly proportional to $r^{-0.5}$, $r^{-n}$, and $r^{-(n+1)}$,
respectively, where $n\sim0.85$ for the mass injection rate of
$1000L_\mathrm{E}/c^2$, and $n\sim0.74$ for $3000L_\mathrm{E}/c^2$. The
distribution of $v_r$ and $v_\theta$ agrees less with self-similarity, possibly
due to convective motions in the $r\theta$ plane. The distribution of velocity,
density and pressure in $\theta$ direction obtained by the steady model agrees
well with the simulation results {within the calculation boundary of the steady
model}. Outward mass flux in the simulations is overall directed toward polar
angle of 0.8382 rad ($\sim 48.0^\circ$) for $1000L_\mathrm{E}/c^2$, and 0.7852
rad ($\sim 43.4^\circ$) for $3000L_\mathrm{E}/c^2$, and $\sim$94\% of the mass
inflow are driven away as outflow, while outward momentum and energy fluxes are
focused around the polar axis. Part of these fluxes lie in the region that are
not calculated by the steady model, and special attention should be paid when
the model is applied.
[3]
oai:arXiv.org:1209.0524 [pdf] - 1151086
The correlations between optical variability and physical parameters of
quasars in SDSS Stripe 82
Submitted: 2012-09-04
We investigate the optical variability of 7658 quasars from SDSS Stripe 82.
Taking advantage of a larger sample and relatively more data points for each
quasar, we estimate variability amplitudes and divide the sample into small
bins of redshift, rest-frame wavelength, black hole mass, Eddington ratio and
bolometric luminosity respectively, to investigate the relationships between
variability and these parameters. An anti-correlation between variability and
rest-frame wavelength is found. The variability amplitude of radio-quiet
quasars shows almost no cosmological evolution, but that of radio-loud ones may
weakly anti-correlate with redshift. In addition, variability increases as
either luminosity or Eddington ratio decreases. However, the relationship
between variability and black hole mass is uncertain; it is negative when the
influence of Eddington ratio is excluded, but positive when the influence of
luminosity is excluded. The intrinsic distribution of variability amplitudes
for radio-loud and radio-quiet quasars are different. Both radio-loud and
radio-quiet quasars exhibit a bluer-when-brighter chromatism. Assuming that
quasar variability is caused by variations of accretion rate, the
Shakura-Sunyaev disk model can reproduce the tendencies of observed
correlations between variability and rest-frame wavelength, luminosity as well
as Eddington ratio, supporting that changes of accretion rate plays an
important role in producing the observed optical variability. However, the
predicted positive correlation between variability and black hole mass seems to
be inconsistent with the observed negative correlation between them in small
bins of Eddington ratio, which suggests that other physical mechanisms may
still need to be considered in modifying the simple accretion disk model.
[4]
oai:arXiv.org:1103.4237 [pdf] - 364126
On the structure of Accretion Disks with Outflows
Submitted: 2011-03-22
In order to study the outflows from accretion disks, we solve the set of
hydrodynamic equations for accretion disks in the spherical coordinates
($r\theta\phi$) to obtain the explicit structure along the $\theta$ direction.
Using self-similar assumptions in the radial direction, we change the equations
to a set of ordinary differential equations (ODEs) about the
$\theta$-coordinate, which are then solved with symmetrical boundary conditions
in the equatorial plane, and the velocity field is obtained. The $\alpha$
viscosity prescription is applied and an advective factor $f$ is used to
simplify the energy equation.The results display thinner, quasi-Keplerian disks
for Shakura-Sunyaev Disks (SSDs) and thicker, sub-Keplerian disks for Advection
Dominated Accretion Flows (ADAFs) and slim disks, which are consistent with
previous popular analytical models. However, an inflow region and an outflow
region always exist, except when the viscosity parameter $\alpha$ is too large,
which supports the results of some recent numerical simulation works. Our
results indicate that the outflows should be common in various accretion disks
and may be stronger in slim disks, where both advection and radiation pressure
are dominant. We also present the structure dependence on the input parameters
and discuss their physical meanings. The caveats of this work and possible
improvements in the future are discussed.
[5]
oai:arXiv.org:0811.2451 [pdf] - 315325
Global Slim Accretion Disk Solutions Revisited
Submitted: 2008-11-14
We show that there exists a maximal possible accretion rate, beyond which
global slim disk solutions cannot be constructed because in the vertical
direction the gravitational force would be unable to balance the pressure force
to gather the accreted matter. The principle for this restriction is the same
as that for the Eddington luminosity and the corresponding critical accretion
rate, which were derived for spherical accretion by considering the same force
balance in the radial direction. If the assumption of hydrostatic equilibrium
is waived and vertical motion is included, this restriction may become even
more serious as the value of the maximal possible accretion rate becomes
smaller. Previous understanding in the literature that global slim disk
solutions could stand for any large accretion rates is due to the
overestimation of the vertical gravitational force by using an approximate
potential. For accretion flows with large accretion rates at large radii,
outflows seem unavoidable in order for the accretion flow to reduce the
accretion rate and follow a global solution till the central black hole.