We present a publicly-available toolkit of flight-proven hardware and software to retrieve 5 TB of data or small physical samples from a stratospheric balloon platform. Before launch, a capsule is attached to the balloon, and rises with it. Upon remote command, the capsule is released and descends via parachute, continuously transmitting its location. Software to predict the trajectory can be used to select a safe but accessible landing site. We dropped two such capsules from the SuperBIT telescope, in September 2019. The capsules took ~37 minutes to descend from ~30 km altitude. They drifted 32 km and 19 km horizontally, but landed within 300 m and 600 m of their predicted landing sites. We found them easily, and successfully recovered the data. We welcome interest from other balloon teams for whom the technology would be useful.

At a fraction the total cost of an equivalent orbital mission, scientific balloon-borne platforms, operating above 99.7% of the Earth's atmosphere, offer attractive, competitive, and effective observational capabilities -- namely space-like resolution, transmission, and backgrounds -- that are well suited for modern astronomy and cosmology. SuperBIT is a diffraction-limited, wide-field, 0.5 m telescope capable of exploiting these observing conditions in order to provide exquisite imaging throughout the near-IR to near-UV. It utilizes a robust active stabilization system that has consistently demonstrated a 1 sigma sky-fixed pointing stability at 48 milliarcseconds over multiple 1 hour observations at float. This is achieved by actively tracking compound pendulations via a three-axis gimballed platform, which provides sky-fixed telescope stability at < 500 milliarcseconds and corrects for field rotation, while employing high-bandwidth tip/tilt optics to remove residual disturbances across the science imaging focal plane. SuperBIT's performance during the 2019 commissioning flight benefited from a customized high-fidelity science-capable telescope designed with exceptional thermo- and opto-mechanical stability as well as tightly constrained static and dynamic coupling between high-rate sensors and telescope optics. At the currently demonstrated level of flight performance, SuperBIT capabilities now surpass the science requirements for a wide variety of experiments in cosmology, astrophysics and stellar dynamics.

This paper proposes a cloud architecture for the correlation of wide bandwidth VLBI data. Cloud correlation facilitates processing of entire experiments in parallel using flexibly allocated and practically unlimited compute resources. This approach offers a potential improvement over dedicated correlation clusters, which are constrained by a fixed number of installed processor nodes and playback units. Additionally, cloud storage offers an alternative to maintaining a fleet of hard-disk drives that might be utilized intermittently. We describe benchmarks of VLBI correlation using the DiFX-2.5.2 software on the Google Cloud Platform to assess cloud-based correlation performance. The number of virtual CPUs per Virtual Machine was varied to determine the optimum configuration of cloud resources. The number of stations was varied to determine the scaling of correlation time with VLBI arrays of different sizes. Data transfer rates from Google Cloud Storage to the Virtual Machines performing the correlation were also measured. We also present an example cloud correlation configuration. Current cloud service and equipment pricing data is used to compile cost estimates allowing an approximate economic comparison between cloud and cluster processing. The economic comparisons are based on cost figures which are a moving target, and are highly dependent on factors such as the utilization of cluster and media, which are a challenge to estimate. Our model suggests that shifting to the cloud is an alternative path for high data rate, low duty cycle wideband VLBI correlation that should continue to be explored. In the production phase of VLBI correlation, the cloud has the potential to significantly reduce data processing times and allow the processing of more science experiments in a given year for the petabyte-scale data sets increasingly common in both astronomy and geodesy VLBI applications.

We report the detection of a single burst from the first-discovered repeating Fast Radio Burst source, FRB 121102, with CHIME/FRB, which operates in the frequency band 400-800 MHz. The detected burst occurred on 2018 November 19 and its emission extends down to at least 600 MHz, the lowest frequency detection of this source yet. The burst, detected with a significance of 23.7$\sigma$, has fluence 12$\pm$3 Jy ms and shows complex time and frequency morphology. The 34 ms width of the burst is the largest seen for this object at any frequency. We find evidence of sub-burst structure that drifts downward in frequency at a rate of -3.9$\pm$0.2 MHz ms$^{-1}$. Our best fit tentatively suggests a dispersion measure of 563.6$\pm$0.5 pc cm$^{-3}$, which is ${\approx}$1% higher than previously measured values. We set an upper limit on the scattering time at 500 MHz of 9.6 ms, which is consistent with expectations from the extrapolation from higher frequency data. We have exposure to the position of FRB 121102 for a total of 11.3 hrs within the FWHM of the synthesized beams at 600 MHz from 2018 July 25 to 2019 February 25. We estimate on the basis of this single event an average burst rate for FRB 121102 of 0.1-10 per day in the 400-800 MHz band for a median fluence threshold of 7 Jy ms in the stated time interval.

The discovery of a repeating Fast Radio Burst (FRB) source, FRB 121102, eliminated models involving cataclysmic events for this source. No other repeating FRB has yet been detected in spite of many recent FRB discoveries and follow-ups, suggesting repeaters may be rare in the FRB population. Here we report the detection of six repeat bursts from FRB 180814.J0422+73, one of the 13 FRBs detected by the Canadian Hydrogen Intensity Mapping Experiment (CHIME) FRB project during its pre-commissioning phase in July and August 2018. These repeat bursts are consistent with originating from a single position on the sky, with the same dispersion measure (DM), ~189 pc cm-3. This DM is approximately twice the expected Milky Way column density, and implies an upper limit on the source redshift of 0.1, at least a factor of ~2 closer than FRB 121102. In some of the repeat bursts, we observe sub-pulse frequency structure, drifting, and spectral variation reminiscent of that seen in FRB 121102, suggesting similar emission mechanisms and/or propagation effects. This second repeater, found among the first few CHIME/FRB discoveries, suggests that there exists -- and that CHIME/FRB and other wide-field, sensitive radio telescopes will find -- a substantial population of repeating FRBs.

We report on laboratory test results of the Compact Water Vapor Radiometer (CWVR) prototype for the NSF's Karl G. Jansky Very Large Array (VLA), a five-channel design centered around the 22 GHz water vapor line. Fluctuations in precipitable water vapor cause fluctuations in atmospheric brightness emission, which are assumed to be proportional to phase fluctuations of the astronomical signal seen by an antenna. Water vapor radiometry consists of using a radiometer to measure variations in the atmospheric brightness emission to correct for the phase fluctuations. The CWVR channel isolation requirement of < -20 dB is met, indicating < 1% power leakage between any two channels. Gain stability tests indicate that Channel 1 needs repair, and that the fluctuations in output counts for Channel 2 to 5 are negatively correlated to the CWVR enclosure ambient temperature, with a change of ~ 405 counts per 1 degree C change in temperature. With temperature correction, the single channel and channel difference gain stability is < 2 x 10^-4, and the observable gain stability is < 2.5 x 10^-4 over t = 2.5 - 10^3 sec, all of which meet the requirements. Overall, the test results indicate that the CWVR meets specifications for dynamic range, channel isolation, and gain stability to be tested on an antenna. Future work consists of building more CWVRs and testing the phase correlations on the VLA antennas to evaluate the use of WVR for not only the VLA, but also the Next Generation Very Large Array (ngVLA).

We present the first set of maps and band-merged catalog from the Herschel Stripe 82 Survey (HerS). Observations at 250, 350, and 500 micron were taken with the Spectral and Photometric Imaging Receiver (SPIRE) instrument aboard the Herschel Space Observatory. HerS covers 79 deg$^2$ along the SDSS Stripe 82 to a depth of 13.0, 12.9, and 14.8 mJy beam$^{-1}$ (including confusion) at 250, 350, and 500 micron, respectively. HerS was designed to measure correlations with external tracers of the dark matter density field --- either point-like (i.e., galaxies selected from radio to X-ray) or extended (i.e., clusters and gravitational lensing) --- in order to measure the bias and redshift distribution of intensities of infrared-emitting dusty star-forming galaxies and AGN. By locating HeRS in Stripe 82, we maximize the overlap with available and upcoming cosmological surveys. The band-merged catalog contains 3.3x10$^4$ sources detected at a significance of >3 $\sigma$ (including confusion noise). The maps and catalog are available at http://www.astro.caltech.edu/hers/

We present the status of MUSIC, the MUltiwavelength Sub/millimeter Inductance Camera, a new instrument for the Caltech Submillimeter Observatory. MUSIC is designed to have a 14', diffraction-limited field-of-view instrumented with 2304 detectors in 576 spatial pixels and four spectral bands at 0.87, 1.04, 1.33, and 1.98 mm. MUSIC will be used to study dusty star-forming galaxies, galaxy clusters via the Sunyaev-Zeldovich effect, and star formation in our own and nearby galaxies. MUSIC uses broadband superconducting phased-array slot-dipole antennas to form beams, lumped-element on-chip bandpass filters to define spectral bands, and microwave kinetic inductance detectors to senseincoming light. The focal plane is fabricated in 8 tiles consisting of 72 spatial pixels each. It is coupled to the telescope via an ambient temperature ellipsoidal mirror and a cold reimaging lens. A cold Lyot stop sits at the image of the primary mirror formed by the ellipsoidal mirror. Dielectric and metal mesh filters are used to block thermal infrared and out-of-band radiation. The instrument uses a pulse tube cooler and 3He/3He/4He closed-cycle cooler to cool the focal plane to below 250 mK. A multilayer shield attenuates Earth's magnetic field. Each focal plane tile is read out by a single pair of coaxes and a HEMT amplifier. The readout system consists of 16 copies of custom-designed ADC/DAC and IF boards coupled to the CASPER ROACH platform. We focus on recent updates on the instrument design and results from the commissioning of the full camera in 2012.

It has been speculated that cosmic string networks could produce ultra-high energy cosmic rays as a by-product of their evolution. By making use of recent work on the evolution of such networks, it will be shown that the flux of cosmic rays from cosmologically useful, that is GUT scale strings, is too small to be used as a test for strings with any foreseeable technology.