Normalized to: Bronikowska, M.

**4** article(s) in total. **127** co-authors, from **1** to **3** common article(s). Median position in authors list is **11,5**.

[1] oai:arXiv.org:1911.13049 [pdf] - 2030649

(704) Interamnia: A transitional object between a dwarf planet and a
typical irregular-shaped minor body

Comments: Accepted for publication in Astronomy and Astrophysics

Submitted: **2019-11-29**, last modified: **2019-12-18**

With an estimated diameter in the 320 to 350 km range, (704) Interamnia is
the fifth largest main belt asteroid and one of the few bodies that fills the
gap in size between the four largest bodies with $D$ > 400 km (Ceres, Vesta,
Pallas and Hygiea) and the numerous smaller bodies with $D$ $\lesssim$ 200 km.
However, despite its large size, little is known about the shape and spin state
of Interamnia and, therefore, about its bulk composition and past collisional
evolution. We aimed to test at what size and mass the shape of a small body
departs from a nearly ellipsoidal equilibrium shape (as observed in the case of
the four largest asteroids) to an irregular shape as routinely observed in the
case of smaller ($D$ $\lesssim$ 200 km) bodies. We observed Interamnia as part
of our ESO VLT/SPHERE large program (ID: 199.C-0074) at thirteen different
epochs. In addition, several new optical lightcurves were recorded. These data,
along with stellar occultation data from the literature, were fed to the
All-Data Asteroid Modeling (ADAM) algorithm to reconstruct the 3D-shape model
of Interamnia and to determine its spin state. Interamnia's volume-equivalent
diameter of 332 $\pm$ 6 km implies a bulk density of $\rho$=1.98 $\pm$ 0.68
gcm$^{-3}$ , which suggests that Interamnia - like Ceres and Hygiea - contains
a high fraction of water ice, consistent with the paucity of apparent craters.
Our observations reveal a shape that can be well approximated by an ellipsoid,
and that is compatible with a fluid hydrostatic equilibrium at the 2 $\sigma$
level. The rather regular shape of Interamnia implies that the size and mass
limit, under which the shapes of minor bodies with a high amount of water ice
in the subsurface become irregular, has to be searched among smaller ($D$
$\lesssim$ 300km) less massive ($m$ $\lesssim$ 3x10$^{19}$ kg) bodies.

[2] oai:arXiv.org:1711.01893 [pdf] - 1590799

Photometric survey, modelling, and scaling of long-period and
low-amplitude asteroids

Comments: Accepted in astronomy astrophys. 39 pages, 49 figures

Submitted: **2017-11-06**

The available set of spin and shape modelled asteroids is strongly biased
against slowly rotating targets and those with low lightcurve amplitudes. As a
consequence of these selection effects, the current picture of asteroid spin
axis distribution, rotation rates, or radiometric properties, might be affected
too.
To counteract these selection effects, we are running a photometric campaign
of a large sample of main belt asteroids omitted in most previous studies. We
determined synodic rotation periods and verified previous determinations. When
a dataset for a given target was sufficiently large and varied, we performed
spin and shape modelling with two different methods.
We used the convex inversion method and the non-convex SAGE algorithm,
applied on the same datasets of dense lightcurves. Unlike convex inversion, the
SAGE method allows for the existence of valleys and indentations on the shapes
based only on lightcurves.
We obtained detailed spin and shape models for the first five targets of our
sample: (159) Aemilia, (227) Philosophia, (329) Svea, (478) Tergeste, and (487)
Venetia. When compared to stellar occultation chords, our models obtained an
absolute size scale and major topographic features of the shape models were
also confirmed. When applied to thermophysical modelling, they provided a very
good fit to the infrared data and allowed their size, albedo, and thermal
inertia to be determined.
Convex and non-convex shape models provide comparable fits to lightcurves.
However, some non-convex models fit notably better to stellar occultation
chords and to infrared data in sophisticated thermophysical modelling (TPM). In
some cases TPM showed strong preference for one of the spin and shape
solutions. Also, we confirmed that slowly rotating asteroids tend to have
higher-than-average values of thermal inertia.

[3] oai:arXiv.org:1707.07503 [pdf] - 1593563

Shape and spin determination of Barbarian asteroids

Comments:

Submitted: **2017-07-24**

Context. The so-called Barbarian asteroids share peculiar, but common
polarimetric properties, probably related to both their shape and composition.
They are named after (234) Barbara, the first on which such properties were
identified. As has been suggested, large scale topographic features could play
a role in the polarimetric response, if the shapes of Barbarians are
particularly irregular and present a variety of scattering/incidence angles.
This idea is supported by the shape of (234) Barbara, that appears to be deeply
excavated by wide concave areas revealed by photometry and stellar
occultations. Aims. With these motivations, we started an observation campaign
to characterise the shape and rotation properties of Small Main- Belt Asteroid
Spectroscopic Survey (SMASS) type L and Ld asteroids. As many of them show long
rotation periods, we activated a worldwide network of observers to obtain a
dense temporal coverage. Methods. We used light-curve inversion technique in
order to determine the sidereal rotation periods of 15 asteroids and the con-
vergence to a stable shape and pole coordinates for 8 of them. By using
available data from occultations, we are able to scale some shapes to an
absolute size. We also study the rotation periods of our sample looking for
confirmation of the suspected abundance of asteroids with long rotation
periods. Results. Our results show that the shape models of our sample do not
seem to have peculiar properties with respect to asteroids with similar size,
while an excess of slow rotators is most probably confirmed.

[4] oai:arXiv.org:1609.03968 [pdf] - 1580242

Probability of coincidental similarity among the orbits of small bodies
- I. Pairing

Comments: 11 pages, 16 figures, 33 references. Submitted to Planetery and Space
Science

Submitted: **2016-09-13**

Probability of coincidental clustering among the orbits of comets, asteroids
and meteoroids depends on many factors like: the size of the orbital sample
searched for clusters or the size of the identified group, it is different for
groups of 2,3,4, ... members. Probability of coincidental clustering is
assessed by the numerical simulation, therefore, it depends also on the method
used for the synthetic orbits generation.
We tested the impact of some of these factors. For a given size of the
orbital sample we have assessed probability of random pairing among several
orbital populations of different sizes. We have found how these probabilities
vary with the size of the orbital samples.
Finally, keeping fixed size of the orbital sample we have shown that the
probability of random pairing can be significantly different for the orbital
samples obtained by different observation techniques. Also for the user
convenience we have obtained several formulae which, for given size of the
orbital sample, one can use to calculate the similarity threshold corresponding
to the small value of the probability of coincidental similarity among two
orbits.