sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Bresson, Y.

Normalized to: Bresson, Y.

10 article(s) in total. 226 co-authors, from 1 to 9 common article(s). Median position in authors list is 6,5.

[1]  oai:arXiv.org:1610.08287  [pdf] - 1503526
Hierarchical fringe tracker to co-phase and coherence very large optical interferometers
Comments: SPIE Astronomical Telescopes and Instrumentation conference, 10 - 15 June 2018 ;10 pages, 9 figures
Submitted: 2016-10-26
The full scientific potential of the VLTI with its second generation instruments MATISSE and GRAVITY require fringe tracking up to magnitudes K>14 with the UTs and K>10 with the ATs. The GRAVITY fringe tracker (FT) will be limited to K~10.5 with UTs and K~7.5 with ATs, for fundamental conceptual reasons: the flux of each telescope is distributed among 3 cophasing pairs and then among 5 spectral channels for coherencing. To overcome this limit we propose a new FT concept, called Hierarchical Fringe Tracker (HFT) that cophase pairs of apertures with all the flux from two apertures and only one spectral channel. When the pair is cophased, most of the flux is transmitted as if it was produced by an unique single mode beam and then used to cophase pairs of pairs and then pairs of groups. At the deeper level, the flux is used in an optimized dispersed fringe device for coherencing. On the VLTI such a system allows a gain of about 3 magnitudes over the GRAVITY FT. On interferometers with more apertures such as CHARA (6 telescopes) or a future Planet Formation Imager (12 to 20 telescopes), the HFT would be even more decisive, as its performance does not decrease with the number of apertures. It would allow building a PFI reaching a coherent magnitude H~10 with 16 apertures with diameters smaller than 2 m. We present the HFT concept, the first steps of its feasibility demonstration from computer simulations and the optical design of a 4 telescopes HFT prototype.
[2]  oai:arXiv.org:1608.02350  [pdf] - 1531216
An overview of the mid-infrared spectro-interferometer MATISSE: science, concept, and current status
Comments: SPIE Astronomical Telescopes and Instrumentation conference, June 2016, 11 pages, 6 Figures
Submitted: 2016-08-08
MATISSE is the second-generation mid-infrared spectrograph and imager for the Very Large Telescope Interferometer (VLTI) at Paranal. This new interferometric instrument will allow significant advances by opening new avenues in various fundamental research fields: studying the planet-forming region of disks around young stellar objects, understanding the surface structures and mass loss phenomena affecting evolved stars, and probing the environments of black holes in active galactic nuclei. As a first breakthrough, MATISSE will enlarge the spectral domain of current optical interferometers by offering the L and M bands in addition to the N band. This will open a wide wavelength domain, ranging from 2.8 to 13 um, exploring angular scales as small as 3 mas (L band) / 10 mas (N band). As a second breakthrough, MATISSE will allow mid-infrared imaging - closure-phase aperture-synthesis imaging - with up to four Unit Telescopes (UT) or Auxiliary Telescopes (AT) of the VLTI. Moreover, MATISSE will offer a spectral resolution range from R ~ 30 to R ~ 5000. Here, we present one of the main science objectives, the study of protoplanetary disks, that has driven the instrument design and motivated several VLTI upgrades (GRA4MAT and NAOMI). We introduce the physical concept of MATISSE including a description of the signal on the detectors and an evaluation of the expected performances. We also discuss the current status of the MATISSE instrument, which is entering its testing phase, and the foreseen schedule for the next two years that will lead to the first light at Paranal.
[3]  oai:arXiv.org:1410.4822  [pdf] - 884094
Hierarchical fringe tracking
Comments: SPIE Astronomical Telescopes and Instrumentation conference, June 2014; 9 pages, 5 figures
Submitted: 2014-10-17
The limiting magnitude is a key issue for optical interferometry. Pairwise fringe trackers based on the integrated optics concepts used for example in GRAVITY seem limited to about K=10.5 with the 8m Unit Telescopes of the VLTI, and there is a general "common sense" statement that the efficiency of fringe tracking, and hence the sensitivity of optical interferometry, must decrease as the number of apertures increases, at least in the near infrared where we are still limited by detector readout noise. Here we present a Hierarchical Fringe Tracking (HFT) concept with sensitivity at least equal to this of a two apertures fringe trackers. HFT is based of the combination of the apertures in pairs, then in pairs of pairs then in pairs of groups. The key HFT module is a device that behaves like a spatial filter for two telescopes (2TSF) and transmits all or most of the flux of a cophased pair in a single mode beam. We give an example of such an achromatic 2TSF, based on very broadband dispersed fringes analyzed by grids, and show that it allows piston measures from very broadband fringes with only 3 to 5 pixels per fringe tracker. We show the results of numerical simulation indicating that our device is a good achromatic spatial filter and allowing a first evaluation of its coupling efficiency, which is similar to this of a single mode fiber on a single aperture. Our very preliminary results indicate that HFT has a good chance to be a serious candidate for the most sensitive fringe tracking with the VLTI and also interferometers with much larger number of apertures. On the VLTI the first rough estimate of the magnitude gain with regard to the GRAVITY internal FT is between 2.5 and 3.5 magnitudes in K, with a decisive impact on the VLTI science program for AGNs, Young stars and planet forming disks.
[4]  oai:arXiv.org:1403.4207  [pdf] - 797543
DISCO: a Spatio-Spectral Recombiner for Pupil Remapping Interferometry
Comments: Improving the performances of current optical interferometers \& future designs, France (2013)
Submitted: 2014-03-17
Pupil-remapping is a new high-dynamic range imaging technique that has recently demonstrated feasibility on sky. The current prototypes present however deceiving limiting magnitude, restricting the current use to the brightest stars in the sky. We propose to combine pupil-remapping with spatio-spectral encoding, a technique first applied to the VEGA/CHARA interferometer. The result is an instrument proposal, called "Dividing Interferometer for Stars Characterizations and Observations" (DISCO). The idea is to take profit of wavelength multiplexing when using a spectrograph in order to pack as much as possible the available information, yet providing a potential boost of 1.5 magnitude if used in existing prototypes. We detail in this paper the potential of such a concept.
[5]  oai:arXiv.org:1303.0973  [pdf] - 1165004
The secondary eclipses of WASP-19b as seen by the ASTEP 400 telescope from Antarctica
Comments: Accepted for publication in Astronomy and Astrophysics, 13 pages, 13 figures
Submitted: 2013-03-05
The ASTEP (Antarctica Search for Transiting ExoPlanets) program was originally aimed at probing the quality of the Dome C, Antarctica for the discovery and characterization of exoplanets by photometry. In the first year of operation of the 40 cm ASTEP 400 telescope (austral winter 2010), we targeted the known transiting planet WASP-19b in order to try to detect its secondary transits in the visible. This is made possible by the excellent sub-millimagnitude precision of the binned data. The WASP-19 system was observed during 24 nights in May 2010. The photometric variability level due to starspots is about 1.8% (peak-to-peak), in line with the SuperWASP data from 2007 (1.4%) and larger than in 2008 (0.07%). We find a rotation period of WASP-19 of 10.7 +/- 0.5 days, in agreement with the SuperWASP determination of 10.5 +/- 0.2 days. Theoretical models show that this can only be explained if tidal dissipation in the star is weak, i.e. the tidal dissipation factor Q'star > 3.10^7. Separately, we find evidence for a secondary eclipse of depth 390 +/- 190 ppm with a 2.0 sigma significance, a phase consistent with a circular orbit and a 3% false positive probability. Given the wavelength range of the observations (420 to 950 nm), the secondary transit depth translates into a day side brightness temperature of 2690(-220/+150) K, in line with measurements in the z' and K bands. The day side emission observed in the visible could be due either to thermal emission of an extremely hot day side with very little redistribution of heat to the night side, or to direct reflection of stellar light with a maximum geometrical albedo Ag=0.27 +/- 0.13. We also report a low-frequency oscillation well in phase at the planet orbital period, but with a lower-limit amplitude that could not be attributed to the planet phase alone, and possibly contaminated with residual lightcurve trends.
[6]  oai:arXiv.org:1008.4218  [pdf] - 1034480
Fresnel diffraction in an interferometer: application to MATISSE
Comments: 8 pages- to appear in Proceedings of SPIE Astronomical Telescopes and Instrumentation 2010
Submitted: 2010-08-25
While doing optical study in an instrument similar to the interferometers dedicated to the Very Large Telescope (VLT), we have to take care of the pupil and focus conjugations. Modules with artificial sources are designed to simulate the stellar beams, in terms of collimation and pupil location. They constitute alignment and calibration tools. In this paper, we present such a module in which the pupil mask is not located in a collimated beam thus introducing Fresnel diffraction. We study the instrumental contrast taking into account the spatial coherence of the source, and the pupil diffraction. The considered example is MATISSE, but this study can apply to any other instrument concerned with Fresnel diffraction.
[7]  oai:arXiv.org:0902.2158  [pdf] - 21304
Study of the atmospheric refraction in a single mode instrument - Application to AMBER/VLTI
Comments: Mon. Not. R. Astron. Soc. (2009) accepted
Submitted: 2009-02-12
This paper presents a study of the atmospheric refraction and its effect on the light coupling efficiency in an instrument using single-mode optical fibers. We show the analytical approach which allowed us to assess the need to correct the refraction in J- and H-bands while observing with an 8-m Unit Telescope. We then developed numerical simulations to go further in calculations. The hypotheses on the instrumental characteristics are those of AMBER (Astronomical Multi BEam combineR), the near infrared focal beam combiner of the Very Large Telescope Interferometric mode (VLTI), but most of the conclusions can be generalized to other single-mode instruments. We used the software package caos (Code for Adaptive Optics Systems) to take into account the atmospheric turbulence effect after correction by the ESO system MACAO (Multi-Application Curvature Adaptive Optics). The opto-mechanical study and design of the system correcting the atmospheric refraction on AMBER is then detailed. We showed that the atmospheric refraction becomes predominant over the atmospheric turbulence for some zenith angles z and spectral conditions: for z larger than 30{\circ} in J-band for example. The study of the optical system showed that it allows to achieve the required instrumental performance in terms of throughput in J- and H-bands. First observations in J-band of a bright star, alpha Cir star, at more than 30{\circ} from zenith clearly showed the gain to control the atmospheric refraction in a single mode instrument, and validated the operating law.
[8]  oai:arXiv.org:0807.3717  [pdf] - 394279
Optical configuration and analysis of the AMBER/VLTI instrument
Comments: 14 pages
Submitted: 2008-07-23
This paper describes the design goals and engineering efforts that led to the realization of AMBER (Astronomical Multi BEam combineR) and to the achievement of its present performance. On the basis of the general instrumental concept, AMBER was decomposed into modules whose functions and detailed characteristics are given. Emphasis is put on the spatial filtering system, a key element of the instrument. We established a budget for transmission and contrast degradation through the different modules, and made the detailed optical design. The latter confirmed the overall performance of the instrument and defined the exact implementation of the AMBER optics. The performance was assessed with laboratory measurements and commissionings at the VLTI, in terms of spectral coverage and resolution, instrumental contrast higher than 0.80, minimum magnitude of 11 in K, absolute visibility accuracy of 1%, and differential phase stability of 1E-3 rad over one minute.
[9]  oai:arXiv.org:astro-ph/0610936  [pdf] - 86360
Direct constraint on the distance of y2 Velorum from AMBER/VLTI observations
Comments:
Submitted: 2006-10-31
In this work, we present the first AMBER observations, of the Wolf-Rayet and O (WR+O) star binary system y2 Velorum. The AMBER instrument was used with the telescopes UT2, UT3, and UT4 on baselines ranging from 46m to 85m. It delivered spectrally dispersed visibilities, as well as differential and closure phases, with a resolution R = 1500 in the spectral band 1.95-2.17 micron. We interpret these data in the context of a binary system with unresolved components, neglecting in a first approximation the wind-wind collision zone flux contribution. We show that the AMBER observables result primarily from the contribution of the individual components of the WR+O binary system. We discuss several interpretations of the residuals, and speculate on the detection of an additional continuum component, originating from the free-free emission associated with the wind-wind collision zone (WWCZ), and contributing at most to the observed K-band flux at the 5% level. The expected absolute separation and position angle at the time of observations were 5.1±0.9mas and 66±15° respectively. However, we infer a separation of 3.62+0.11-0.30 mas and a position angle of 73+9-11°. Our analysis thus implies that the binary system lies at a distance of 368+38-13 pc, in agreement with recent spectrophotometric estimates, but significantly larger than the Hipparcos value of 258+41-31 pc.
[10]  oai:arXiv.org:astro-ph/0509208  [pdf] - 1456440
First AMBER/VLTI observations of hot massive stars
Comments:
Submitted: 2005-09-08
AMBER is the first near infrared focal instrument of the VLTI. It combines three telescopes and produces spectrally resolved interferometric measures. This paper discusses some preliminary results of the first scientific observations of AMBER with three Unit Telescopes at medium (1500) and high (12000) spectral resolution. We derive a first set of constraints on the structure of the circumstellar material around the Wolf Rayet Gamma2 Velorum and the LBV Eta Carinae.