sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Bonnin, Xavier

Normalized to: Bonnin, X.

4 article(s) in total. 50 co-authors, from 1 to 2 common article(s). Median position in authors list is 5,5.

[1]  oai:arXiv.org:1902.00300  [pdf] - 2090582
MASER: A Science Ready Toolbox for Low Frequency Radio Astronomy
Comments: Submitted to Data Science Journal special issue after PV2018 conference
Submitted: 2019-02-01, last modified: 2020-02-25
MASER (Measurements, Analysis, and Simulation of Emission in the Radio range) is a comprehensive infrastructure dedicated to time-dependent low frequency radio astronomy (up to about 50 MHz). The main radio sources observed in this spectral range are the Sun, the magnetized planets (Earth, Jupiter, Saturn), and our Galaxy, which are observed either from ground or space. Ground observatories can capture high resolution data streams with a high sensitivity. Conversely, space-borne instruments can observe below the ionospheric cut-off (at about 10 MHz) and can be placed closer to the studied object. Several tools have been developed in the last decade for sharing space physics data. Data visualization tools developed by various institutes are available to share, display and analyse space physics time series and spectrograms. The MASER team has selected a sub-set of those tools and applied them to low frequency radio astronomy. MASER also includes a Python software library for reading raw data from agency archives.
[2]  oai:arXiv.org:2001.03476  [pdf] - 2046465
Density Fluctuations in the Solar Wind Based on Type III Radio Bursts Observed by Parker Solar Probe
Comments: 12 pages, 10 figures, accepted for publication in ApJS
Submitted: 2020-01-10
Radio waves are strongly scattered in the solar wind, so that their apparent sources seem to be considerably larger and shifted than the actual ones. Since the scattering depends on the spectrum of density turbulence, better understanding of the radio wave propagation provides indirect information on the relative density fluctuations $\epsilon=\langle\delta n\rangle/\langle n\rangle$ at the effective turbulence scale length. Here, we have analyzed 30 type III bursts detected by Parker Solar Probe (PSP). For the first time, we have retrieved type III burst decay times $\tau_{\rm{d}}$ between 1 MHz and 10 MHz thanks to an unparalleled temporal resolution of PSP. We observed a significant deviation in a power-law slope for frequencies above 1 MHz when compared to previous measurements below 1 MHz by the twin-spacecraft Solar TErrestrial RElations Observatory (STEREO) mission. We note that altitudes of radio bursts generated at 1 MHz roughly coincide with an expected location of the Alfv\'{e}n point, where the solar wind becomes super-Alfv\'{e}nic. By comparing PSP observations and Monte Carlo simulations, we predict relative density fluctuations $\epsilon$ at the effective turbulence scale length at radial distances between 2.5$R_\odot$ and 14$R_\odot$ to range from $0.22$ and $0.09$. Finally, we calculated relative density fluctuations $\epsilon$ measured in situ by PSP at a radial distance from the Sun of $35.7$~$R_\odot$ during the perihelion \#1, and the perihelion \#2 to be $0.07$ and $0.06$, respectively. It is in a very good agreement with previous STEREO predictions ($\epsilon=0.06-0.07$) obtained by remote measurements of radio sources generated at this radial distance.
[3]  oai:arXiv.org:1804.10499  [pdf] - 1824862
Simulating Jupiter-satellite decametric emissions with ExPRES: a parametric study
Comments: 14 pages, 2 figures, Planetary Radio Emissions VIII
Submitted: 2018-04-27
The high latitude radio emissions produced by the Cyclotron Maser Instability (CMI) in Jupiter's magnetosphere extend from a few kHz to 40 MHz. Part of the decametric emissions is of auroral origin, and part is driven by the moons Io, Europa and Ganymede. After summarizing the method used to identify Jupiter-satellite radio emissions, which consists in comparing space- and ground-based radio observations to ExPRES simulations of CMI-driven emissions in the time-frequency plane, we present a parametric study of the free parameters required by the ExPRES code (electron distribution function and resonant energy, magnetic field model, lead angle, and altitude of the ionospheric cut-off) in order to assess the accuracy of our simulations in the Io-Jupiter case. We find that Io-DAM arcs are fairly modeled by loss-cone driven CMI with electrons of 1-10 keV energy, using the ISaAC, VIPAL or VIP4 magnetic field model and a simple sinusoidal lead angle model. The altitude of the ionospheric cut-off has a marginal impact on the simulations. We discuss the impact of our results on the identification of Europa-DAM and Ganymede-DAM emissions.
[4]  oai:arXiv.org:1202.2072  [pdf] - 494029
Automation of the filament tracking in the framework of the HELIO project
Comments:
Submitted: 2012-02-09, last modified: 2012-03-29
We present a new method to automatically track filaments over the solar disk. The filaments are first detected on Meudon Spectroheliograph H{\alpha} images of the Sun, applying the technique developed by Fuller, Aboudarham, and Bentley (Solar phys. 227, 61, 2005). This technique combines cleaning processes, image segmentation based on region growing, and morphological parameter ex- traction, including the determination of filament skeletons. The coordinates of the skeleton pixels, given in a heliocentric system, are then converted to a more appropriate reference frame that follows the rotation of the Sun surface. In such a frame, a co-rotating filament is always located around the same position, and its skeletons (extracted from each image) are thus spatially close, forming a group of adjacent features. In a third step, the shape of each skeleton is compared with its neighbours using a curve-matching algorithm. This step will permit us to define the probability [P ] that two close filaments in the co-rotating frame are actually the same one observed on two different images. At the end, the pairs of features, for which the corresponding probability is greater than a threshold value, are associated using tracking identification indexes.On a representative sample of filaments, the good agreement between automated and manual tracking confirms the reliability of the technique to be applied on large data sets. Especially, this code is already used in the framework of the Heliophysics Integrated Observatory (HELIO) to populate a catalogue dedicated to solar and heliospheric features (HFC). An extension of this method to others filament observations, and possibly the sunspots, faculae, and coronal holes tracking can be also envisaged.