sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Billings, Tashalee

Normalized to: Billings, T.

9 article(s) in total. 147 co-authors, from 1 to 8 common article(s). Median position in authors list is 12,0.

[1]  [pdf] - 2100679
Measuring HERA's primary beam in-situ: methodology and first results
Comments: 22 pages, 22 figures, accepted for publication in ApJ
Submitted: 2020-05-25
The central challenge in 21~cm cosmology is isolating the cosmological signal from bright foregrounds. Many separation techniques rely on the accurate knowledge of the sky and the instrumental response, including the antenna primary beam. For drift-scan telescopes such as the Hydrogen Epoch of Reionization Array \citep[HERA, ][]{DeBoer2017} that do not move, primary beam characterization is particularly challenging because standard beam-calibration routines do not apply \citep{Cornwell2005} and current techniques require accurate source catalogs at the telescope resolution. We present an extension of the method from \citet{Pober2012} where they use beam symmetries to create a network of overlapping source tracks that break the degeneracy between source flux density and beam response and allow their simultaneous estimation. We fit the beam response of our instrument using early HERA observations and find that our results agree well with electromagnetic simulations down to a -20~dB level in power relative to peak gain for sources with high signal-to-noise ratio. In addition, we construct a source catalog with 90 sources down to a flux density of 1.4~Jy at 151~MHz.
[2]  [pdf] - 2099320
Detection of Cosmic Structures using the Bispectrum Phase. II. First Results from Application to Cosmic Reionization Using the Hydrogen Epoch of Reionization Array
Comments: 22 pages, 12 figures (including sub-figures). Accepted for publication in PhRvD. Abstract may be slightly abridged compared to the actual manuscript due to length limitations on arXiv
Submitted: 2020-05-20
Characterizing the epoch of reionization (EoR) at $z\gtrsim 6$ via the redshifted 21 cm line of neutral Hydrogen (HI) is critical to modern astrophysics and cosmology, and thus a key science goal of many current and planned low-frequency radio telescopes. The primary challenge to detecting this signal is the overwhelmingly bright foreground emission at these frequencies, placing stringent requirements on the knowledge of the instruments and inaccuracies in analyses. Results from these experiments have largely been limited not by thermal sensitivity but by systematics, particularly caused by the inability to calibrate the instrument to high accuracy. The interferometric bispectrum phase is immune to antenna-based calibration and errors therein, and presents an independent alternative to detect the EoR HI fluctuations while largely avoiding calibration systematics. Here, we provide a demonstration of this technique on a subset of data from the Hydrogen Epoch of Reionization Array (HERA) to place approximate constraints on the IGM brightness temperature. From this limited data, at $z=7.7$ we infer "$1\sigma$" upper limits on the IGM brightness temperature to be $\le 316$ "pseudo" mK at $\kappa_\parallel=0.33\,\textrm{"pseudo"}\,h$ Mpc$^{-1}$ (data-limited) and $\le 1000$ "pseudo" mK at $\kappa_\parallel=0.875\,\textrm{"pseudo"}\,h$ Mpc$^{-1}$ (noise-limited). The "pseudo" units denote only an approximate and not an exact correspondence to the actual distance scales and brightness temperatures. By propagating models in parallel to the data analysis, we confirm that the dynamic range required to separate the cosmic HI signal from the foregrounds is similar to that in standard approaches, and the power spectrum of the bispectrum phase is still data-limited (at $\gtrsim 10^6$ dynamic range) indicating scope for further improvement in sensitivity as the array build-out continues.
[3]  [pdf] - 2097404
Foreground modelling via Gaussian process regression: an application to HERA data
Comments: 15 pages, 15 figures, 1 table, Accepted to MNRAS
Submitted: 2020-04-13, last modified: 2020-05-12
The key challenge in the observation of the redshifted 21-cm signal from cosmic reionization is its separation from the much brighter foreground emission. Such separation relies on the different spectral properties of the two components, although, in real life, the foreground intrinsic spectrum is often corrupted by the instrumental response, inducing systematic effects that can further jeopardize the measurement of the 21-cm signal. In this paper, we use Gaussian Process Regression to model both foreground emission and instrumental systematics in $\sim 2$ hours of data from the Hydrogen Epoch of Reionization Array. We find that a simple co-variance model with three components matches the data well, giving a residual power spectrum with white noise properties. These consist of an "intrinsic" and instrumentally corrupted component with a coherence-scale of 20 MHz and 2.4 MHz respectively (dominating the line of sight power spectrum over scales $k_{\parallel} \le 0.2$ h cMpc$^{-1}$) and a baseline dependent periodic signal with a period of $\sim 1$ MHz (dominating over $k_{\parallel} \sim 0.4 - 0.8$h cMpc$^{-1}$) which should be distinguishable from the 21-cm EoR signal whose typical coherence-scales is $\sim 0.8$ MHz.
[4]  [pdf] - 2067038
Redundant-Baseline Calibration of the Hydrogen Epoch of Reionization Array
Comments: 23 Pages, 19 Figures
Submitted: 2020-03-18
In 21 cm cosmology, precision calibration is key to the separation of the neutral hydrogen signal from bright astrophysical foregrounds. If not properly calibrated, each antenna element's complex gain can impart spectral structure on otherwise spectrally-smooth foregrounds, complicating that statistical separation. The Hydrogen Epoch of Reionization Array (HERA), an interferometer specialized for 21 cm cosmology and now under construction in South Africa, was designed to be largely calibrated using the self-consistency of repeated measurements of the same interferometric modes. This technique, known as redundant-baseline calibration resolves most of the internal degrees of freedom in the calibration problem. It assumes, however, on antenna elements with identical primary beams placed precisely on a redundant grid. In this work, we review the detailed implementation of the algorithms enabling redundant-baseline calibration and report results with HERA data. We quantify the effects of real-world non-redundancy and how they compare to the idealized scenario in which redundant measurements differ only in their noise realizations. Finally, we study how non-redundancy can produce spurious temporal structure in our calibration solutions---both in data and in simulations---and present strategies for mitigating that structure.
[5]  [pdf] - 2054054
Absolute Calibration Strategies for the Hydrogen Epoch of Reionization Array and Their Impact on the 21 cm Power Spectrum
Comments: Accepted to ApJ
Submitted: 2019-10-28, last modified: 2020-01-04
We discuss absolute calibration strategies for Phase I of the Hydrogen Epoch of Reionization Array (HERA), which aims to measure the cosmological 21 cm signal from the Epoch of Reionization (EoR). HERA is a drift-scan array with a 10 degree wide field of view, meaning bright, well-characterized point source transits are scarce. This, combined with HERA's redundant sampling of the uv plane and the modest angular resolution of the Phase I instrument, make traditional sky-based and self-calibration techniques difficult to implement with high dynamic range. Nonetheless, in this work we demonstrate calibration for HERA using point source catalogues and electromagnetic simulations of its primary beam. We show that unmodeled diffuse flux and instrumental contaminants can corrupt the gain solutions, and present a gain smoothing approach for mitigating their impact on the 21 cm power spectrum. We also demonstrate a hybrid sky and redundant calibration scheme and compare it to pure sky-based calibration, showing only a marginal improvement to the gain solutions at intermediate delay scales. Our work suggests that the HERA Phase I system can be well-calibrated for a foreground-avoidance power spectrum estimator by applying direction-independent gains with a small set of degrees of freedom across the frequency and time axes.
[6]  [pdf] - 1931014
Electrical and electromagnetic co-simulations of the HERA Phase I receiver system including the effects of mutual coupling, and impact on the EoR window
Comments: 25 pages, 29 figures - Submitted to MNRAS
Submitted: 2019-08-06
The detection of the Epoch of Reionization (EoR) delay power spectrum using a "foreground avoidance method" highly depends on the instrument chromaticity. The systematic effects induced by the radio-telescope spread the foreground signal in the delay domain, which contaminates the EoR window theoretically observable. Therefore, it is essential to understand and limit these chromatic effects. This paper describes a method to simulate the frequency and time responses of an antenna, by simultaneously taking into account the analogue RF receiver, the transmission cable, and the mutual coupling caused by adjacent antennas. Applied to the Hydrogen Epoch of Reionization Array (HERA), this study reveals the presence of significant reflections at high delays caused by the 150-m cable which links the antenna to the back-end. Besides, it shows that waves can propagate from one dish to another one through large sections of the array because of mutual coupling. In this more realistic approach, the simulated system time response is attenuated by a factor $10^{4}$ after a characteristic delay which depends on the size of the array and on the antenna position. Ultimately, the system response is attenuated by a factor $10^{5}$ after 1400 ns because of the reflections in the cable, which corresponds to characterizable ${k_\parallel}$-modes above 0.7 $h \rm{Mpc}^{-1}$ at 150 MHz. Thus, this new study shows that the detection of the EoR signal with HERA Phase I will be more challenging than expected. On the other hand, it improves our understanding of the telescope, which is essential to mitigate the instrument chromaticity.
[7]  [pdf] - 1958034
The HERA-19 Commissioning Array: Direction Dependent Effects
Comments: 21 pages, 12 figures, submitted to ApJ
Submitted: 2018-02-07, last modified: 2019-06-10
Foreground power dominates the measurements of interferometers that seek a statistical detection of highly-redshifted HI emission from the Epoch of Reionization (EoR). The chromaticity of the instrument creates a boundary in the Fourier transform of frequency (proportional to $k_\parallel$) between spectrally smooth emission, characteristic of the strong synchrotron foreground (the "wedge"), and the spectrally structured emission from HI in the EoR (the "EoR window"). Faraday rotation can inject spectral structure into otherwise smooth polarized foreground emission, which through instrument effects or miscalibration could possibly pollute the EoR window. Using data from the HERA 19-element commissioning array, we investigate the polarization response of this new instrument in the power spectrum domain. We perform a simple image-based calibration based on the unpolarized diffuse emission of the Global Sky Model, and show that it achieves qualitative redundancy between the nominally-redundant baselines of the array and reasonable amplitude accuracy. We construct power spectra of all fully polarized coherencies in all pseudo-Stokes parameters. We compare to simulations based on an unpolarized diffuse sky model and detailed electromagnetic simulations of the dish and feed, confirming that in Stokes I, the calibration does not add significant spectral structure beyond the expected level. Further, this calibration is stable over the 8 days of observations considered. Excess power is seen in the power spectra of the linear polarization Stokes parameters which is not easily attributable to leakage via the primary beam, and results from some combination of residual calibration errors and actual polarized emission. Stokes V is found to be highly discrepant from the expectation of zero power, strongly pointing to the need for more accurate polarized calibration.
[8]  [pdf] - 1686778
Development of Aluminum LEKIDs for Balloon-Borne Far-IR Spectroscopy
Comments: accepted for publication in Journal of Low Temperature Physics
Submitted: 2018-03-06, last modified: 2018-04-16
We are developing lumped-element kinetic inductance detectors (LEKIDs) designed to achieve background-limited sensitivity for far-infrared (FIR) spectroscopy on a stratospheric balloon. The Spectroscopic Terahertz Airborne Receiver for Far-InfraRed Exploration (STARFIRE) will study the evolution of dusty galaxies with observations of the [CII] 158 $\mu$m and other atomic fine-structure transitions at $z=0.5-1.5$, both through direct observations of individual luminous infrared galaxies, and in blind surveys using the technique of line intensity mapping. The spectrometer will require large format ($\sim$1800 detectors) arrays of dual-polarization sensitive detectors with NEPs of $1 \times 10^{-17}$ W Hz$^{-1/2}$. The low-volume LEKIDs are fabricated with a single layer of aluminum (20 nm thick) deposited on a crystalline silicon wafer, with resonance frequencies of $100-250$ MHz. The inductor is a single meander with a linewidth of 0.4 $\mu$m, patterned in a grid to absorb optical power in both polarizations. The meander is coupled to a circular waveguide, fed by a conical feedhorn. Initial testing of a small array prototype has demonstrated good yield, and a median NEP of $4 \times 10^{-18}$ W Hz$^{-1/2}$.
[9]  [pdf] - 1459468
Instrumental performance and results from testing of the BLAST-TNG receiver, submillimeter optics, and MKID arrays
Comments: Presented at SPIE Millimeter, Submillimeter, and Far-Infrared Detectors and Instrumentation for Astronomy VIII, June 29th, 2016
Submitted: 2016-08-18
Polarized thermal emission from interstellar dust grains can be used to map magnetic fields in star forming molecular clouds and the diffuse interstellar medium (ISM). The Balloon-borne Large Aperture Submillimeter Telescope for Polarimetry (BLASTPol) flew from Antarctica in 2010 and 2012 and produced degree-scale polarization maps of several nearby molecular clouds with arcminute resolution. The success of BLASTPol has motivated a next-generation instrument, BLAST-TNG, which will use more than 3000 linear polarization sensitive microwave kinetic inductance detectors (MKIDs) combined with a 2.5m diameter carbon fiber primary mirror to make diffraction-limited observations at 250, 350, and 500 $\mu$m. With 16 times the mapping speed of BLASTPol, sub-arcminute resolution, and a longer flight time, BLAST-TNG will be able to examine nearby molecular clouds and the diffuse galactic dust polarization spectrum in unprecedented detail. The 250 $\mu$m detector array has been integrated into the new cryogenic receiver, and is undergoing testing to establish the optical and polarization characteristics of the instrument. BLAST-TNG will demonstrate the effectiveness of kilo-pixel MKID arrays for applications in submillimeter astronomy. BLAST-TNG is scheduled to fly from Antarctica in December 2017 for 28 days and will be the first balloon-borne telescope to offer a quarter of the flight for "shared risk" observing by the community.