Observations show that the time of onset of dust formation in classical novae depends strongly on their speed class, with dust typically taking longer to form in slower novae. Using empirical relationships between speed class, luminosity and ejection velocity, it can be shown that dust formation timescale is expected to be essentially independent of speed class. However, following a nova outburst the spectrum of the central hot source evolves, with an increasing proportion of the radiation being emitted short-ward of the Lyman limit. The rate at which the spectrum evolves also depends on the speed class. We have therefore refined the simple model by assuming photons at energies higher than the Lyman limit are absorbed by neutral hydrogen gas internal to the dust formation sites, therefore preventing these photons reaching the nucleation sites. With this refinement the dust formation timescale is theoretically dependent on speed class and the results of our theoretical modification agree well with the observational data. We consider two types of carbon-based dust, graphite and amorphous carbon, with both types producing similar relationships. Our results can be used to predict when dust will form in a nova of a given speed class and hence when observations should optimally be taken to detect the onset of dust formation.

We report new observations of the far infrared and submillimeter water vapor emission of NML Cygnus based on data gathered with the Infrared Space Observatory and the Submillimeter Wave Astronomy Satellite. We compare the emission from NML Cyg to that previously published for VY CMa and W Hya in an attempt to establish the validity of recently proposed models for the outflow from evolved stars. The data obtained support the contention by Ivezi\'{c} & Elitzur (1995, 1997) that the atmospheres of evolved stars obey a set of scaling laws in which the optical depth of the outflow is the single most significant scaling parameter, affecting both the radiative transfer and the dynamics of the outflow. Specifically, we provide observations comparing the water vapor emission from NML Cyg, VY CMa and W Hya, and find, to the extent permitted by the quality of our data, that the results are in reasonable agreement with a model developed by Zubko & Elitzur (2000). Using this model we derive a mass loss based on the dust opacities, spectral line fluxes, and outflow velocities of water vapor observed in the atmospheres of these oxygen-rich giants. For VY CMa and NML Cyg we also obtain an estimate of the stellar mass.

We present new interstellar dust models which have been derived by simultaneously fitting the far-ultraviolet to near-infrared extinction, the diffuse infrared (IR) emission and, unlike previous models, the elemental abundance constraints on the dust for different interstellar medium abundances, including solar, F and G star, and B star abundances. The fitting problem is a typical ill-posed inversion problem, in which the grain size distribution is the unknown, which we solve by using the method of regularization. The dust model contains various components: PAHs, bare silicate, graphite, and amorphous carbon particles, as well as composite particles containing silicate, organic refractory material, water ice, and voids. The optical properties of these components were calculated using physical optical constants. As a special case, we reproduce the Li & Draine (2001) results, however their model requires an excessive amount of silicon, magnesium, and iron to be locked up in dust: about 50 ppm (atoms per million of H atoms), significantly more than the upper limit imposed by solar abundances of these elements, about 34, 35, and 28 ppm, respectively. A major conclusion of this paper is that there is no unique interstellar dust model that simultaneously fits the observed extinction, diffuse IR emission, and abundances constraints.

A viable interstellar dust model - characterized by the composition, morphology, and size distribution of the dust grains and by the abundance of the different elements locked up in the dust - should fit all observational constraints arising primarily from the interactions of the dust with incident radiation or the ambient gas. In spite of the many different manifestations of these interactions, we still lack a comprehensive dust model that is consistent with {\it all} the observational constraints. An important advance towards the construction of such a model was recently made by Zubko, Dwek, and Arendt (2003, ZDA03) who, for the first time, included the average interstellar extinction, the diffuse infrared emission, {\it and} the interstellar abundances as explicit constraints in the construction of models consisting of astrophysical dust particles without any predetermined functional form for their grain size distribution. The results showed the existence of many distinct dust models that satisfy a basic set of observational constraints. X-ray halos, produced primarily by small angle scattering off large dust particles along the line of sight to bright X-ray sources, probe dust properties largely inaccessible at other wavelengths. In this contribution we briefly review the microscopic physics and the macroscopic effects that determine the intensity and spatial profile of X-ray halos. Focusing on the X-ray halo around the bright source GX~13+1, we show that halo observations can be used to discriminate between the different, currently viable, ZDA03 dust models. X-ray halos may therefore be an essential constraint that need to be explicitly included in all future dust models.

We construct a self-consistent model for the wind around W Hya by solving the coupled equations describing the hydrodynamics and dust radiative transfer problems. The model matches simultaneously the observed continuum radiation and wind velocity profile. The water line emission is calculated next using the water abundance as the only free parameter, fitted from the ISO observations of Neufeld et al. (1996) and Barlow et al. (1996). The gas temperature is determined from a thermal balance calculation that includes water as one of its main components. Our model successfully fits all the observed water lines, resolving a major discrepancy between the modeling results of the two observing teams. The mass loss rate is 2.3 x 10^{-6} M_solar yr^{-1}, the water abundance is 1.0 x 10^{-4} and the ortho:para ratio is 1:1.3.

Spectropolarimetry from the near IR to the far UV of light scattered by dust provides a valuable diagnostic of the dust composition, grain size distribution and spatial distribution. To facilitate the use of this diagnostic, we present detailed calculations of the intensity and polarization spectral signature of light scattered by optically thin and optically thick dust in various geometries. The polarized light radiative transfer calculations are carried out using the adding-doubling method for a plane-parallel slab, and are extended to an optically thick sphere by integrating over its surface. The calculations are for the Mathis, Rumple & Nordsieck Galactic dust model, and cover the range from 1 $\mu m$ to 500 \AA. We find that the wavelength dependence of the scattered light intensity provides a sensitive probe of the optical depth of the scattering medium, while the polarization wavelength dependence provides a probe of the grain scattering properties, which is practically independent of optical depth. We provide a detailed set of predictions, including polarization maps, which can be used to probe the properties of dust through imaging spectropolarimetry in the near IR to far UV of various Galactic and extragalactic objects. In a following paper we use the codes developed here to provide predictions for the dependence of the intensity and polarization on grain size distribution and composition.

We present here dust models for the Small Magellanic Cloud bar calculated for the first time with the regularization approach. A simple mixture of the core-mantle and/or composite grains (mostly made from silicates and organic refractory) together with silicon nanoparticles is consistent with the following: 1) the observed extinction toward AzV 398 (a typical SMC bar sightline), 2) the elemental abundances, and 3) the strength of the interstellar radiation field. We predict the expected albedo and asymmetry parameter of the models, which can be tested in future observations. The proposed dust models can also be tested by looking for the expected extended red emission.

The new observational data on interstellar dust, obtained during the past few years, in particular, revised ISM elemental abundances, the polarization curve from the far UV to the near IR, spectra of dust infrared emission, extended red emission (ERE), are in serious conflict with existing dust models. We proposed here to use the regularization approach as a base for developing a modern dust model, which attempts to self-consistently explain most of the available observational data.

To examine a recently proposed hypothesis that silicon nanoparticles are the source of extended red emission (ERE) in the interstellar medium, we performed a detailed modeling of the mean Galactic extinction in the presence of silicon nanoparticles. For this goal we used the appropriate optical constants of nanosized Si, essentially different from those of bulk Si due to quantum confinement. It was found that a dust mixture of silicon nanoparticles, bare graphite grains, silicate core-organic refractory mantle grains and three-layer silicate-water ice-organic refractory grains works well in explaining the extinction and, in addition, results in the acceptable fractions of UV/visible photons absorbed by silicon nanoparticles: 0.071-0.081. Since these fractions barely agree with the fraction of UV/visible photons needed to excite the observed ERE, we conclude that the intrinsic photon conversion efficiency of the photoluminescence by silicon nanoparticles must be near 100%, if they are the source of the ERE.