A Drag-Free CubeSat mission has been proposed to demonstrate the feasibility of a Gravitational Reference Sensor (GRS) with an optical readout for a 3 units (3U) spacecraft. A purely drag-free object is defined by the absence of all external forces other than gravity, which are shielded by the spacecraft. In a real case, the TM will still be affected by disturbances. Several of them are passively reduced by the design of the TM housing. This system is a thick-walled aluminium box that holds the shadow sensors and shields the TM. The housing has an effect on the mechanical, thermal and magnetic environment around the TM. All of them have been analysed. The mechanical vibrations have to fit the launch environment and the modes have to be outside of the measurement range (0.0001 - 1 Hz). The magnetic field has to be reduced by a 0.01 factor. The temperature difference between internal opposing surfaces, determining pressure on the TM, has to be below 10^-3(1 mHz/f)1/3 K Hz^-1/2. The housing, together with the TM, the sensors and the UV LEDs for charging control, constitutes the GRS, which would then fit into a 1U. The other 2Us are occupied by the caging mechanism that constraints the TM during launch, the thrusters, the Attitude Determination And Control System (ADACS) and the electronics. The Drag-Free CubeSat will be the result of the combined efforts of Stanford, University of Florida, KACST and NASA and will be the first drag-free mission with an optical readout and the first GRS designed within the limits of a 3U small satellite. In the first section, this paper briefly updates on the main characteristics and systems of the project. Particular emphasis is then given to the recently designed housing, its expected performance and the open issues.

The Laser Interferometer Space Antenna (LISA) is a proposed space mission for the detection of gravitational waves. It consists of three drag-free satellites flying in a triangular constellation. A gravitational reference sensor is used in conjunction with a laser interferometer to measure the distance between test masses inside the three satellites. Other future space mission such as DECIGO and BBO also require a gravitational reference sensor. The Modular Gravitational Reference Sensor (MGRS) is being designed for these purposes and consists of two different optical sensors and a UV LED charge management system. The Differential Optical Shadow Sensor (DOSS) is one of the optical sensors and measures the position of a spherical test mass with respect to the surrounding satellite. This measurement is used for the drag-free feedback control loop. This paper describes the most recent, third generation of the experimental setup for the DOSS that uses a fiber coupled super luminescent LED, an integrated mounting structure and lock-in amplification. The achieved sensitivity is 10 nm/Hz^(1/2) above 300 mHz, and 20 nm/Hz^(1/2) for frequencies above 30 mHz.

We describe a new space gravitational wave observatory design called LAGRANGE that maintains all important LISA science at about half the cost and with reduced technical risk. It consists of three drag-free spacecraft in the most stable geocentric formation, the Earth-Moon L3, L4, and L5 Lagrange points. Fixed antennas allow continuous contact with the Earth, solving the problem of communications bandwidth and latency. A 70 mm diameter AuPt sphere with a 35 mm gap to its enclosure serves as a single inertial reference per spacecraft, which is operated in "true" drag-free mode (no test mass forcing). This is the core of the Modular Gravitational Reference Sensor whose other advantages are: a simple caging design based on the DISCOS 1972 drag-free mission, an all optical read-out with pm fine and nm coarse sensors, and the extensive technology heritage from the Honeywell gyroscopes, and the DISCOS and Gravity Probe B drag-free sensors. An Interferometric Measurement System, designed with reflective optics and a highly stabilized frequency standard, performs the inter-test mass ranging and requires a single optical bench with one laser per spacecraft. Two 20 cm diameter telescopes per spacecraft, each with in-field pointing, incorporate novel technology developed for advanced optical systems by Lockheed Martin, who also designed the spacecraft based on a multi-flight proven bus structure. Additional technological advancements include the drag-free propulsion, thermal control, charge management systems, and materials. LAGRANGE sub-systems are designed to be scalable and modular, making them interchangeable with those of LISA or other gravitational science missions. We plan to space qualify critical technologies on small and nano satellite flights, with the first launch (UV-LED Sat) in 2013.