sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Zangrilli, L.

Normalized to: Zangrilli, L.

3 article(s) in total. 10 co-authors. Median position in authors list is 3,0.

[1]  oai:arXiv.org:2004.05075  [pdf] - 2101464
Spectral signatures of chromospheric condensation in a major solar flare
Comments: Accepted for publication by the Astrophysical Journal - 9th April 2020
Submitted: 2020-04-10
We study the evolution of chromospheric line and continuum emission during the impulsive phase of the X-class SOL2014-09-10T17:45 solar flare. We extend previous analyses of this flare to multiple chromospheric lines of Fe I, Fe II, Mg II, C I, and Si II, observed with IRIS, combined with radiative-hydrodynamical (RHD) modeling. For multiple flaring kernels, the lines all show a rapidly evolving double-component structure: an enhanced, emission component at rest, and a broad, highly red-shifted component of comparable intensity. The red-shifted components migrate from 25-50 km s$^{-1}$ towards the rest wavelength within $\sim$30 seconds. Using Fermi hard X-ray observations, we derive the parameters of an accelerated electron beam impacting the dense chromosphere, using them to drive a RHD simulation with the RADYN code. As in Kowalski et al. 2017a, our simulations show that the most energetic electrons penetrate into the deep chromosphere, heating it to T$\sim$10,000 K, while the bulk of the electrons dissipate their energy higher, driving an explosive evaporation, and its counterpart condensation -- a very dense (n$_e \sim 2 \times 10^{14}$ cm$^{-3}$), thin layer (30--40 km thickness), heated to 8--12,000 K, moving towards the stationary chromosphere at up to 50 km s$^{-1}$. The synthetic Fe II 2814.45A profiles closely resemble the observational data, including a continuum enhancement, and both a stationary and a highly red-shifted component, rapidly moving towards the rest wavelength. Importantly, the absolute continuum intensity, ratio of component intensities, relative time of appearance, and red-shift amplitude, are sensitive to the model input parameters, showing great potential as diagnostics.
[2]  oai:arXiv.org:1608.07408  [pdf] - 1492803
Evolution of active region outflows throughout an active region lifetime
Comments: 13 pages, Astronomy and Astrophysics accepted
Submitted: 2016-08-26
We have shown previously that SOHO/UVCS data allow us to detect active region (AR) outflows at coronal altitudes higher than those reached by other instrumentation. These outflows are thought to be a component of the slow solar wind. Our purpose is to study the evolution of the outflows in the intermediate corona from AR 8100, from the time the AR first forms until it dissolves, after several transits at the solar limb. Data acquired by SOHO/UVCS at the time of the AR limb transits, at medium latitudes and at altitudes ranging from 1.5 to 2.3 R_sun, were used to infer the physical properties of the outflows through the AR evolution. To this end, we applied the Doppler dimming technique to UVCS spectra. These spectra include the H I Lyman alpha line and the O VI doublet lines at 1031.9 and 1037.6 A. Plasma speeds and electron densities of the outflows were inferred over several rotations of the Sun. AR outflows are present in the newly born AR and persist throughout the entire AR life. Moreover, we found two types of outflows at different latitudes, both possibly originating in the same negative polarity area of the AR. We also analyzed the behavior of the Si XII 520 A line along the UVCS slit in an attempt to reveal changes in the Si abundance when different regions are traversed. Although we found some evidence for a Si enrichment in the AR outflows, alternative interpretations are also plausible. Our results demonstrate that outflows from ARs are detectable in the intermediate corona throughout the whole AR lifetime. This confirms that outflows contribute to the slow wind.
[3]  oai:arXiv.org:1407.3052  [pdf] - 1215611
Preliminary results on the characterization and performances of ZBLAN fiber for infrared spectrographs
Comments: 11 pages, 5 figures, 1 table. Presented at SPIE Astronomical Telescope + Instrumentation 2014 (Ground-based and Airbone Instrumentation for Astronomy 5, 9147-231). To be published in Proceeding of SPIE Volume 9147
Submitted: 2014-07-11
Present telescopes and future extremely large telescopes make use of fiber-fed spectrographs to observe at optical and infrared wavelengths. The use of fibers largely simplifies the interfacing of the spectrograph to the telescope. At a high spectral resolution (R>50,000) the fibers can be used to achieve very high spectral accuracy. GIANO is an infrared (0.95-2.5\mu m) high resolution (R=50,000) spectrometer[1] [2] [3] that was recently commissioned at the TNG telescope (La Palma). This instrument was designed and built for direct feeding from the telescope [4]. However, due to constraints imposed on the telescope interfacing during the pre-commissioning phase, it had to be positioned on the rotating building, far from the telescope focus. Therefore, a new interface to the telescope, based on IR-transmitting ZBLAN fibers with 85 \mu m core, was developed. In this article we report the first, preliminary results of the effects of these fibers on the quality of the recorded spectra with GIANO and with a similar spectrograph that we set-up in the laboratory. The effects can be primarily associated to modal-noise (MN) that, in GIANO, is much more evident than in optical spectrometers, because of the much longer wavelengths.