Potential microbial contamination of Martian moons, Phobos and Deimos, which can be brought about by transportation of Mars ejecta produced by meteoroid impacts on the Martian surface, has been comprehensively assessed in a statistical approach, based on the most probable history of recent major gigantic meteoroid collisions on the Martian surface. This article is the first part of our study to assess potential microbial density in Mars ejecta departing from the Martian atmosphere, as a source of the second part where statistical analysis of microbial contamination probability is conducted. Potential microbial density on the Martian surface as the source of microorganisms was estimated by analogy to the terrestrial areas having the similar arid and cold environments, from which a probabilistic function was deduced as the asymptotic limit. Microbial survival rate during hypervelocity meteoroid collisions was estimated by numerical analysis of impact phenomena with and without taking internal friction and plastic deformation of the colliding meteoroid and the target ground into consideration. Trajectory calculations of departing ejecta through the Martian atmosphere were conducted with taking account of aerodynamic deceleration and heating by the aid of computational fluid dynamic analysis. It is found that Mars ejecta smaller than 0.03 m in diameter hardly reach the Phobos orbit due to aerodynamic deceleration, or mostly sterilized due to significant aerodynamic heating even though they can reach the Phobos orbit and beyond. Finally, the baseline dataset of microbial density in Mars ejecta departing for Martian moons has been presented for the second part of our study.

This paper presents a case study of microbe transportation in the Mars-satellites system. We examined the spatial distribution of potential impact-transported microbes on the Martian moons using impact physics by following a companion study (Fujita et al.). We used sterilization data from the precede studies. We considered that the microbes came mainly from the Zunil crater on Mars. We found that 70-80% of the microbes are likely to be dispersed all over the moon surface and are rapidly sterilized due to radiation except for those microbes within a thick ejecta deposit produced by meteoroids. The other 20-30% might be shielded from radiation by thick regolith layers that formed at collapsed layers in craters produced by Mars rock impacts. The total number of potentially surviving microbes at the thick ejecta deposits is estimated to be 3-4 orders of magnitude lower than at the Mars rock craters. The microbe concentration is irregular in the horizontal direction and is largely depth-dependent due to the radiation sterilization. The surviving fraction of transported microbes would be only 1 ppm on Phobos and 100 ppm on Deimos, suggesting that the transport processes and radiation severely affect microbe survival. The microbe sampling probability from the Martian moons was also investigated. We suggest that sample return missions from the Martian moons are classified into Unrestricted Earth-Return missions for 30 g samples and 10 cm depth sampling, even in our conservative scenario. We also conducted a full statistical analysis for sampling the regolith of Phobos to include the effects of uncertainties in input parameters on the sampling probability. The most likely probability of microbial contamination for return samples is estimated to be two orders of magnitude lower than the criterion defined by the planetary protection policy of the Committee on Space Research (COSPAR).

Since its inception six decades ago, astrobiology has diversified immensely to encompass several scientific questions including the origin and evolution of Terran life, the organic chemical composition of extraterrestrial objects, and the concept of habitability, among others. The detection of life beyond Earth forms the main goal of astrobiology, and a significant one for space exploration in general. This goal has galvanized and connected with other critical areas of investigation such as the analysis of meteorites and early Earth geological and biological systems, materials gathered by sample-return space missions, laboratory and computer simulations of extraterrestrial and early Earth environmental chemistry, astronomical remote sensing, and in-situ space exploration missions. Lately, scattered efforts are being undertaken towards the R&D of the novel and as-yet-space-unproven life-detection technologies capable of obtaining unambiguous evidence of extraterrestrial life, even if it is significantly different from Terran life. As the suite of space-proven payloads improves in breadth and sensitivity, this is an apt time to examine the progress and future of life-detection technologies.

The fabrication of an ultralow-density hydrophobic silica aerogel for the intact capture cosmic dust during the Tanpopo mission is described. The Tanpopo experiment performed on the International Space Station orbiting the Earth includes the collection of terrestrial and interplanetary dust samples on a silica aerogel capture medium exposed to space for later ground-based biological and chemical analyses. The key to the mission's success is the development of high-performance capture media, and the major challenge is to satisfy the mechanical requirements as a spacecraft payload while maximizing the performance for intact capture. To this end, an ultralow-density (0.01 g cm$^{-3}$) soft aerogel was employed in combination with a relatively robust 0.03 g cm$^{-3}$ aerogel. A procedure was also established for the mass production of double-layer aerogel tiles formed with a 0.01 g cm$^{-3}$ surface layer and a 0.03 g cm$^{-3}$ open-topped, box-shaped base layer, and 60 aerogel tiles were manufactured. The fabricated aerogel tiles have been demonstrated to be suitable as flight hardware with respect to both scientific and safety requirements.

In this paper, we report the progress in developing a silica-aerogel-based cosmic dust capture panel for use in the Tanpopo experiment on the International Space Station (ISS). Previous studies revealed that ultralow-density silica aerogel tiles comprising two layers with densities of 0.01 and 0.03 g/cm$^3$ developed using our production technique were suitable for achieving the scientific objectives of the astrobiological mission. A special density configuration (i.e., box framing) aerogel with a holder was designed to construct the capture panels. Qualification tests for an engineering model of the capture panel as an instrument aboard the ISS were successful. Sixty box-framing aerogel tiles were manufactured in a contamination-controlled environment.

We are developing a silica-aerogel-based cosmic dust collector for use in the Tanpopo experiment to be conducted on the International Space Station. The mass production of simple two-layer hydrophobic aerogels was undertaken in a contamination-controlled environment, yielding more than 100 undamaged products. The collector, comprising an aerogel tile and holder panel, was designed to resist launch vibration and to conform to an exposure attachment. To this end, a box-framing aerogel with inner and outer densities of 0.01 and 0.03 g/cm$^3$, respectively, was fabricated. The aerogel mounted in the panel passed random vibration tests at the levels of the acceptance and qualification tests for launch. It also withstood the pressure changes expected in the airlock on the International Space Station.

Hydrophobic silica aerogels with ultra-low densities have been designed and developed as cosmic dust capture media for the Tanpopo mission which is proposed to be carried out on the International Space Station. Glass particles as a simulated cosmic dust with 30 \mu m in diameter and 2.4 g/cm^3 in density were successfully captured by the novel aerogel at a velocity of 6 km/s. Background levels of contaminated DNA in the ultra-low density aerogel were lower than the detection limit of a polymerase chain reaction assay. These results show that the manufactured aerogel has good performance as a cosmic dust collector and sufficient quality in respect of DNA contamination. The aerogel is feasible for the biological analyses of captured cosmic dust particles in the astrobiological studies.