Shock-induced changes in ordinary chondrite meteorites related to impacts or planetary collisions are known to be capable of altering their optical properties. Thus, one can hypothesize that a significant portion of the ordinary chondrite material may be hidden within the observed dark C/X asteroid population. The exact pressure-temperature conditions of the shock-induced darkening are not well constrained. Thus, we experimentally investigate the gradual changes in the chondrite material optical properties as a function of the shock pressure. A spherical shock experiment with Chelyabinsk LL5 was performed in order to study the changes in its optical properties. The spherical shock experiment geometry allows for a gradual increase of shock pressure from $\sim$15 GPa at a rim toward hundreds of gigapascals in the center. Four distinct zones were observed with an increasing shock load. The optical changes are minimal up to $\sim$50 GPa. In the region of $\sim$50--60 GPa, shock darkening occurs due to the troilite melt infusion into silicates. This process abruptly ceases at pressures of $\sim$60 GPa due to an onset of silicate melting. At pressures higher than $\sim$150 GPa, recrystallization occurs and is associated with a second-stage shock darkening due to fine troilite-metal eutectic grains. The shock darkening affects the ultraviolet, visible, and near-infrared (UV, VIS, and NIR) region while changes to the MIR spectrum are minimal. Shock darkening is caused by two distinct mechanisms with characteristic pressure regions, which are separated by an interval where the darkening ceases. This implies a reduced amount of shock-darkened material produced during the asteroid collisions.

The fall of the Annama meteorite occurred early morning (local time) on April 19, 2014 on the Kola Peninsula (Russia). Based on mineralogy and physical properties, Annama is a typical H chondrite. It has a high Ar-Ar age of 4.4 Ga. Its cosmic ray exposure history is atypical as it is not part of the large group of H chondrites with a prominent 7 - 8 Ma peak in the exposure age histograms. Instead, its exposure age is within uncertainty of a smaller peak at 30 \pm 4 Ma. The results from short-lived radionuclides are compatible with an atmosperic pre-entry radius of 30 - 40 cm. However, based on noble gas and cosmogenic radionuclide data, Annama must have been part of a larger body (radius >65 cm) for a large part of its cosmic ray exposure history. The 10Be concentration indicates a recent (3 - 5 Ma) breakup which may be responsible for the Annama parent body size reduction to 30 - 35 cm pre-entry radius.

The mineralogy and physical properties of Chelyabinsk meteorites (fall, February 15, 2013) are presented. Three types of meteorite material are present, described as the light-colored, dark-colored, and impact-melt lithologies. All are of LL5 composition with the impact-melt lithology being close to whole-rock melt and the dark-colored lithology being shock-darkened due to partial melting of iron metal and sulfides. This enables us to study the effect of increasing shock on material with identical composition and origin. Based on the magnetic susceptibility, the Chelyabinsk meteorites are richer in metallic iron as compared to other LL chondrites. The measured bulk and grain densities and the porosity closely resemble other LL chondrites. Shock darkening does not have a significant effect on the material physical properties, but causes a decrease of reflectance and decrease in silicate absorption bands in the reflectance spectra. This is similar to the space weathering effects observed on asteroids. However, compared to space weathered materials, there is a negligible to minor slope change observed in impact-melt and shock-darkened meteorite spectra. Thus, it is possible that some dark asteroids with invisible silicate absorption bands may be composed of relatively fresh shock-darkened chondritic material.

We derive an analytical expression of the inter-arrival time distribution for a non-homogeneous Poisson process (NHPP). This expression is exact and is applicable to any time interval, finite or infinite. As an illustration, we present simulation results for three different intensity functions.