Visual observations of meteor showers have been carried out for many decades by astronomers. Modern developments in imaging systems have advanced our knowledge about the shower dynamics and their origin. We have made an attempt to make a portable video recording system to observe meteor showers. The system consists of a camera capable of recording the rapid motion of meteors entering the Earths atmosphere. The camera is interfaced with a laptop using an open source software like VirtualDub. The initial testing was carried out while observing Geminid meteor shower in December, 2010 from the base of Mahuli fort (Lat: $19.47{\deg}$ N, Long: $73.26{\deg}$ E) near Asangaon, India. Here, we present few of the meteors recorded during this event, followed by a preliminary analysis of the shower. The portable video recording system enables to capture meteors at a remote location. This system will strengthen traditional visual observation methods used by astronomers in India. Future coordinated studies with a multi-station approach using such systems will assist in deriving the parameters associated with meteor shower activity and its impact on the Earth's atmosphere. Therefore, we propose long term and simultaneous multi-station video observations in the Indian subcontinent for continuous monitoring and better understanding of meteor dynamics.

Temporal variation of secondary cosmic rays (SCR) flux was measured during the several full and new moon and days close to them at Department of Physics, University of Mumbai, Mumbai (Geomagnetic latitude: 10.6 N), India. The measurements were done by using NaI (Tl) scintillation detector with energy threshold of 200 keV. The SCR flux shows sudden enhancement for approximately about 2 hour in counts during couple of events out of all experimental observations. The maximum Enhancement SCR flux is about 200% as compared to the diurnal trend of SCR temporal variations. Weather parameters (temperature and relative humidity) were continuously monitored during all observation. The influences of geomagnetic field, interplanetary parameters and tidal effect on SCR flux have been considered. Summed spectra corresponding to enhancement duration indicates appearance of atmospheric radioactivity which shows single gamma ray line. Detail investigation revealed the presence of radioactive Ar 41 . This measurements puts limitations on low energy SCR flux monitoring. This paper will help many researcher who want to measure SCR flux during eclipses and motivate to find unknown mechanism behind decrease/ increase during solar/lunar eclipse.

We have studied Forbush decrease (FD) event occurred on February 14, 1978 using 43 neutron monitor observatories to understand the global signature of FD. We have studied rigidity dependence of shock amplitude and total FD amplitude. We have found almost the same power law index for both shock phase amplitude and total FD amplitude. Local time variation of shock phase amplitude and maximum depression time of FD have been investigated which indicate possible effect of shock/CME orientation. We have analyzed rigidity dependence of time constants of two phase recovery. Time constants of slow component of recovery phase show rigidity dependence and implies possible effect of diffusion. Solar wind speed was observed to be well correlated with slow component of FD recovery phase. This indicates solar wind speed as possible driver of recovery phase. To investigate the contribution of interplanetary drivers, shock and CME in FD, we have used shock-only and CME-only models. We have applied these models separately to shock phase and main phase amplitudes respectively. This confirms present accepted physical scenario that the first step of FD is due to propagating shock barrier and second step is due to flux rope of CME/magnetic cloud.

Given the renewed scientific interest in lunar exploration missions, complete understanding of lunar near surface environment and its exosphere under different conditions is of paramount importance. Lunar exosphere has been extensively studied by ground based observations [18,19,20,21,22,23] and hypothesized by different models[1,2,3,4,5,6,7,8,9,10,11,12,13]. In present work, we have discussed overlooked possible sources behind changes in the lunar exosphere when the Moon passes through the penumbra and umbra of the Earth during a lunar eclipse. The dusty turbulent environment due to planetary shadow is not only confined to lunar studies and exploration, but it can also be extended to all terrestrial airless bodies in the universe with a dusty surface e.g. some planets, planetary satellites, asteroids etc.

Imaging in hard X-rays of any astrophysical source with high angular resolution is a challenging job. Shadow-casting technique is one of the most viable options for imaging in hard X-rays. We have used two different types of shadow-casters, namely, Coded Aperture Mask (CAM) and Fresnel Zone Plate (FZP) pair and two types of pixellated solid-state detectors, namely, CZT and CMOS in RT-2/CZT payload, the hard X-ray imaging instrument onboard the CORONAS-PHOTON satellite. In this paper, we present the results of simulations with different combinations of coders (CAM & FZP) and detectors that are employed in the RT-2/CZT payload. We discuss the possibility of detecting transient Solar flares with good angular resolution for various combinations. Simulated results are compared with laboratory experiments to verify the consistency of the designed configuration.

X-ray experiments in the intermediate energy range (1-50 keV) are carried out at the Indian Centre for Space Physics (ICSP), Kolkata for space application. The purpose is to carry out developmental studies of space instruments to observe energetic phenomena from compact objects (black hole and compact stars) and active stars and their testing and evaluation. The testing/evaluation setup primarily consists of an X-ray generator, various X-ray imaging masks, an X-ray imager (CMOS) and an X-ray spectrometer (Si-PIN photo-diode). The X-ray generator (Mo target) operates in 1-50 kV anode voltage, and 1-30 mA beam current. A 45 feet long shielded collimator is used to collimate the beam which leads to the detector chamber having a 30 arc-sec angular diameter. Two types of imaging masks are used - conventional Coded Aperture Masks (CAM) and Tungsten Fresnel half-period zone-plates (ZPs) having angular resolutions of a few tens of arc-sec. The Moire fringe pattern produced by the composite shadows of two ZPs is inverse Fourier transformed to obtain the X-ray source distribution. CAMs are advantageous but the resolution obtained is limited by their smallest pixel size. Our setup has been extensively used in testing and evaluation of RT-2 payloads which have been launched recentlya (January 30, 2009). More experiments for improving imaging techniques are being designed and tested.

Combination of Fresnel Zone Plates (FZP) can make excellent telescopes for imaging in X-rays. We present the results of our experiments with such telescopes with an X-ray source kept at a distance of 45 feet. We compare the patterns obtained from experiments with those obtained by our Monte-Carlo simulations. In simulations, we allow the sources to be at finite distances (diverging beam) as well as at infinite distances (parallel beam) and show that the resolution is worsened when the source is nearby. We also present simulated results for the observation of the galactic center and show that the sources may be reconstructed with accuracy. We compare the performance of such a telescope with other X-ray imaging devices used in space-astronomy. The Zone Plate based instrument has been sent for the first time in a recently launched KORONAS-FOTON satellite.

We present the results of simulations of shadows cast by a zone plate telescope which may have one to four pairs of zone plates. From the shadows we reconstruct the images under various circumstances. We discuss physical basis of the resolution of the telescope and demonstrate this by our simulations. We allow the source to be at a finite distance (diverging beam) as well as at an infinite distance (parallel beam) and show that the resolution is worsened when the source is nearby. By reconstructing the zone plates in a way that both the zone plates subtend the same solid angles at the source, we obtain back high resolution even for sources at a finite distance. We present simulated results for the observation of the galactic center and show that the sources of varying intensities may be reconstructed with accuracy. Results of these simulations would be of immense use in interpreting the X-ray images from recently launched CORONAS-PHOTON satellite.

Combination of Fresnel Zone Plates (FZP) can make an excellent telescope for imaging in X-rays. We present here the results of our experiments with several pairs of tungsten made Fresnel Zone plates in presence of an X-ray source kept at a distance of about 45 feet. The quasi-parallel beam allowed us to study sources placed on the axis as well as off the axis of the telescope. We present theoretical study of the fringe patterns produced by the zone plates in presence of a quasi-parallel source. We compare the patterns obtained from experiments with those obtained by our Monte-Carlo simulations. The images are also reconstructed by deconvolution from both the patterns. We compare the performance of such a telescope with other X-ray imaging devices used in space-astronomy.

A telescope with Fresnel Zone Plates has been contemplated to be an excellent imaging mask in X-rays and gamma-rays for quite some time. With a proper choice of zone plate material, spacing and an appropriate readout system it is possible to achieve any theoretical angular resolution. We provide the results of numerical simulations of how a large number of X-ray sources could be imaged at a high resolution. We believe that such an imager would be an excellent tool for a future survey mission for X-ray and gamma-ray sources which we propose.

The goal of a small and dedicated satellite called the "Continuous Spectro-Photometry of Black Holes" or CSPOB is to provide the essential tool for the theoretical understanding of the hydrodynamic and magneto-hydrodynamic flows around black holes. In its life time of about three to four years, only a half a dozen black holes will be observed continuously with a pair of CSPOBs. Changes in the spectral and temporal variability properties of the high-energy emission would be caught as they happen. Several important questions are expected to be answered and many puzzles would be sorted out with this mission.