We describe a novel artificial dielectric material which has applications at millimetre and submillimetre wavelengths. The material is manufactured from layers of metal mesh patterned onto thin polypropylene sheets which are then bonded together using a hot pressing process to provide planar rugged discs which can be reliably cycled to cryogenic temperatures. The refractive index of this material can be tuned by adjusting the geometry and spacing of the metal-mesh layers. We demonstrate its usage by designing and characterising a broadband anti-reflection coating for a Z-cut crystalline Quartz plate. The coating was fabricated and applied to the quartz using the hot press technique and characterized using a Fourier Transform Spectrometer. The performance is shown to be in good agreement with HFSS and transmission line modelling results.

We describe a novel multi-layered metal mesh achromatic half wave plate for use in astronomical polarimetric instruments. The half wave plate is designed to operate across the frequency range from 125-250 GHz. The wave plate is manufactured from 12-layers of thin film metallic inductive and capacitive grids patterned onto polypropylene sheets, which are then bonded together using a hot pressing technique. Transmission line modelling and 3-D electromagnetic simulations are used to optimize the parameters of the metal-mesh patterns and to evaluate their optical properties. A prototype half wave plate has been fabricated and its performance characterized in a polarizing Fourier transform spectrometer. The device performance is consistent with the modelling although the measured differential phase shift for two orthogonal polarizations is lower than expected. This difference is likely to result from imperfect patterning of individual layers and misalignment of the grids during manufacture.

The Spectral and Photometric Imaging Receiver (SPIRE), is the Herschel Space Observatory`s submillimetre camera and spectrometer. It contains a three-band imaging photometer operating at 250, 350 and 500 microns, and an imaging Fourier Transform Spectrometer (FTS) which covers simultaneously its whole operating range of 194-671 microns (447-1550 GHz). The SPIRE detectors are arrays of feedhorn-coupled bolometers cooled to 0.3 K. The photometer has a field of view of 4' x 8', observed simultaneously in the three spectral bands. Its main operating mode is scan-mapping, whereby the field of view is scanned across the sky to achieve full spatial sampling and to cover large areas if desired. The spectrometer has an approximately circular field of view with a diameter of 2.6'. The spectral resolution can be adjusted between 1.2 and 25 GHz by changing the stroke length of the FTS scan mirror. Its main operating mode involves a fixed telescope pointing with multiple scans of the FTS mirror to acquire spectral data. For extended source measurements, multiple position offsets are implemented by means of an internal beam steering mirror to achieve the desired spatial sampling and by rastering of the telescope pointing to map areas larger than the field of view. The SPIRE instrument consists of a cold focal plane unit located inside the Herschel cryostat and warm electronics units, located on the spacecraft Service Module, for instrument control and data handling. Science data are transmitted to Earth with no on-board data compression, and processed by automatic pipelines to produce calibrated science products. The in-flight performance of the instrument matches or exceeds predictions based on pre-launch testing and modelling: the photometer sensitivity is comparable to or slightly better than estimated pre-launch, and the spectrometer sensitivity is also better by a factor of 1.5-2.