The collisional and sticking properties of sub-mm-sized aggregates composed of protoplanetary dust analogue material are measured, including the statistical threshold velocity between sticking and bouncing, their surface energy and tensile strength within aggregate clusters. We performed an experiment on the REXUS 12 suborbital rocket. The protoplanetary dust analogue materials were micrometre-sized monodisperse and polydisperse SiO2 particles prepared into aggregates with sizes around 120 $\mu$m and 330 $\mu$m, respectively and volume filling factors around 0.37. During the experimental run of 150 s under reduced gravity conditions, the sticking of aggregates and the formation and fragmentation of clusters of up to a few millimetres in size was observed. The sticking probability of the sub-mm-sized dust aggregates could be derived for velocities decreasing from 22 to 3 cm/s. The transition from bouncing to sticking collisions happened at 12.7 cm/s for the smaller aggregates composed of monodisperse particles and at 11.5 and 11.7 cm/s for the larger aggregates composed of mono- and polydisperse dust particles, respectively. Using the pull-off force of sub-mm-sized dust aggregates from the clusters, the surface energy of the aggregates composed of monodisperse dust was derived to be 1.6x10-5 J/m2, which can be scaled down to 1.7x10-2 J/m2 for the micrometre-sized monomer particles and is in good agreement with previous measurements for silica particles. The tensile strengths of these aggregates within the clusters were derived to be 1.9 Pa and 1.6 Pa for the small and large dust aggregates, respectively. These values are in good agreement with recent tensile strength measurements for mm-sized silica aggregates. Using our data on the sticking-bouncing threshold, estimates of the maximum aggregate size can be given. For a minimum mass solar nebula model, aggregates can reach sizes of 1 cm.

The experiments presented aim to measure the outcome of collisions between sub-mm sized protoplanetary dust aggregate analogues. We also observed the clusters formed from these aggregates and their collision behaviour. The experiments were performed at the drop tower in Bremen. The protoplanetary dust analogue materials were micrometre-sized monodisperse and polydisperse SiO$_2$ particles prepared into aggregates with sizes between 120~$\mu$m and 250~$\mu$m. One of the dust samples contained aggregates that were previously compacted through repeated bouncing. During three flights of 9~s of microgravity each, individual collisions between aggregates and the formation of clusters of up to a few millimetres in size were observed. In addition, the collisions of clusters with the experiment cell walls leading to compaction or fragmentation were recorded. We observed collisions amongst dust aggregates and collisions between dust clusters and the cell aluminium walls at speeds ranging from about 0.1 cm/s to 20 cm/s. The velocities at which sticking occurred ranged from 0.18 to 5.0 cm/s for aggregates composed of monodisperse dust, with an average value of 2.1 cm/s for reduced masses ranging from 1.2x10-6 to 1.8x10-3 g with an average value of 2.2x10-4 g. From the restructuring and fragmentation of clusters composed of dust aggregates colliding with the aluminium cell walls, we derived a collision recipe for dust aggregates ($\sim$100 $\mu$m) following the model of Dominik \& Thielens (1997) developed for microscopic particles. We measured a critical rolling energy of 1.8x10-13 J and a critical breaking energy of 3.5x10-13 J for 100 $\mu$m-sized non-compacted aggregates.

The bouncing barrier, a parameter combination at which dust particles in the protoplanetary disk always rebound in mutual collisions, is one of the crucial steps of planet formation. In the past years, several experiments have been performed to determine the mass and velocity regimes at which perfect bouncing does occur and those where there is a chance of the aggregates sticking together. We conducted a microgravity experiment, which allows us to investigate free collisions of millimeter-sized SiO2 dust aggregates at the relevant velocities. We analyzed 52 collisions in detail with velocities of 3.4 mm/s to 6.2 cm/s and found four of them leading to sticking, while the other aggregates rebounded. Three out of the four sticking collisions occurred at velocities where previously only bouncing had been predicted. Although the probability for sticking is low, this opens a new possibility for growth beyond millimeter sizes. Our setup allowed us to obtain the complete three-dimensional collision information. Since most previous experiments were interpreted based on two-dimensional information, we compare our three-dimensional values with those obtained if only one projection had been available. We find that the error of a two-dimensional analysis of the collision velocity is very small. The distribution of the coefficient of restitution in the two-dimensional view is representative of the real case, but for any given collision its value can be far off. Impact parameters always have to be analyzed three-dimensionally, because the two-dimensional values are not meaningful in any way.

The Suborbital Particle Aggregation and Collision Experiment (SPACE) is a novel approach to study the collision properties of submillimeter-sized, highly porous dust aggregates. The experiment was designed, built and carried out to increase our knowledge about the processes dominating the first phase of planet formation. During this phase, the growth of planetary precursors occurs by agglomeration of micrometer-sized dust grains into aggregates of at least millimeters to centimeters in size. However, the formation of larger bodies from the so-formed building blocks is not yet fully understood. Recent numerical models on dust growth lack a particular support by experimental studies in the size range of submillimeters, because these particles are predicted to collide at very gentle relative velocities of below 1 cm/s that can only be achieved in a reduced-gravity environment. The SPACE experiment investigates the collision behavior of an ensemble of silicate-dust aggregates inside several evacuated glass containers which are being agitated by a shaker to induce the desired collisions at chosen velocities. The dust aggregates are being observed by a high-speed camera, allowing for the determination of the collision properties of the protoplanetary dust analog material. The data obtained from the suborbital flight with the REXUS (Rocket Experiments for University Students) 12 rocket will be directly implemented into a state-of-the-art dust growth and collision model.

We conducted micro-gravity experiments to study the outcome of collisions between sub-mm-sized dust agglomerates consisting of \mu m-sized SiO2 monomer grains at velocities of several cm/s. Prior to the experiments, we used X-ray computer tomography (nano-CT) imaging to study the internal structure of these dust agglomerates and found no rim compaction so that their collision behavior is not governed by preparation-caused artefacts. We found that collisions between these dust aggregates can lead either to sticking or to bouncing, depending mostly on the impact velocity. While previous collision models derived the transition between both regimes from contact physics, we used the available empirical data from these and earlier experiments to derive a power law relation between dust-aggregate mass and impact velocity for the threshold between the two collision outcomes. In agreement with earlier experiments, we show that the transition between both regimes is not sharp, but follows a shallower power law than predicted by previous models (G\"uttler et al. 2010). Furthermore, we find that sticking between dust aggregates can lead to the formation of larger structures. Collisions between aggregates-of-aggregates can lead to growth at higher velocities than homogeneous dust agglomerates.

The formation of planetesimals in the early Solar System is hardly understood, and in particular the growth of dust aggregates above millimeter sizes has recently turned out to be a difficult task in our understanding [Zsom et al. 2010, A&A, 513, A57]. Laboratory experiments have shown that dust aggregates of these sizes stick to one another only at unreasonably low velocities. However, in the protoplanetary disk, millimeter-sized particles are known to have been ubiquitous. One can find relics of them in the form of solid chondrules as the main constituent of chondrites. Most of these chondrules were found to feature a fine-grained rim, which is hypothesized to have formed from accreting dust grains in the solar nebula. To study the influence of these dust-coated chondrules on the formation of chondrites and possibly planetesimals, we conducted collision experiments between millimeter-sized, dust-coated chondrule analogs at velocities of a few cm/s. For 2 and 3 mm diameter chondrule analogs covered by dusty rims of a volume filling factor of 0.18 and 0.35-0.58, we found sticking velocities of a few cm/s. This velocity is higher than the sticking velocity of dust aggregates of the same size. We therefore conclude that chondrules may be an important step towards a deeper understanding of the collisional growth of larger bodies. Moreover, we analyzed the collision behavior in an ensemble of dust aggregates and non-coated chondrule analogs. While neither the dust aggregates nor the solid chondrule analogs show sticking in collisions among their species, we found an enhanced sicking efficiency in collisions between the two constituents, which leads us to the conjecture that chondrules might act as "catalyzers" for the growth of larger bodies in the young Solar System.

Over the past years the processes involved in the growth of planetesimals have extensively been studied in the laboratory. Based on these experiments, a dust-aggregate collision model was developed upon which computer simulations were based to evaluate how big protoplanetary dust aggregates can grow and to analyze which kinds of collisions are relevant in the solar nebula and are worth further studies in the laboratory. The sticking threshold velocity of millimeter-sized dust aggregates is such a critical value that had so far only theoretically been derived, as the relevant velocities could not be reached in the laboratory. We developed a microgravity experiment that allows us for the first time to study free collisions of mm-sized dust aggregates down to velocities of ~0.1 cm/s to assess this part of the protoplanetary dust evolution model. Here, we present the results of 125 free collisions between dust aggregates of 0.5 to 2 mm diameter. Seven collisions with velocities between 0.2 and 3 cm/s led to sticking, suggesting a transition from perfect sticking to perfect bouncing with a certain sticking probability instead of a sharp velocity threshold. We developed a model to explain the physical processes involved in dust-aggregate sticking, derived dynamic material properties of the dust aggregates from the results of the collisions, and deduced the velocity below which aggregates always stick. For millimeter-sized porous dust aggregates this velocity is 8e-5 m/s.

To study the evolution of protoplanetary dust aggregates, we performed experiments with up to 2600 collisions between single, highly-porous dust aggregates and a solid plate. The dust aggregates consisted of spherical SiO$_2$ grains with 1.5$\mu$m diameter and had an initial volume filling factor (the volume fraction of material) of $\phi_0=0.15$. The aggregates were put onto a vibrating baseplate and, thus, performed multiple collisions with the plate at a mean velocity of 0.2 m s$^{-1}$. The dust aggregates were observed by a high-speed camera to measure their size which apparently decreased over time as a measure for their compaction. After 1000 collisions the volume filling factor was increased by a factor of two, while after $\sim2000$ collisions it converged to an equilibrium of $\phi\approx0.36$. In few experiments the aggregate fragmented, although the collision velocity was well below the canonical fragmentation threshold of $\sim1$ m s$^{-1}$. The compaction of the aggregate has an influence on the surface-to-mass ratio and thereby the dynamic behavior and relative velocities of dust aggregates in the protoplanetary nebula. Moreover, macroscopic material parameters, namely the tensile strength, shear strength, and compressive strength, are altered by the compaction of the aggregates, which has an influence on their further collisional behavior. The occurrence of fragmentation requires a reassessment of the fragmentation threshold velocity.