A TeV spectral break in the total flux of cosmic-ray electrons and positrons (CREs) at which the spectral power index softens from $\sim 3$ to $\sim 4$ has been observed by H.E.S.S. and recently confirmed by DAMPE with a high significance of $6.6~\sigma$. Such an observation is apparently inconsistent with the data from other experiments such as Fermi-LAT, AMS-02 and CALET. We perform a global analysis to the latest CRE data including Fermi-LAT, AMS-02, CALET, DAMPE and H.E.S.S. with energy scale uncertainties taken into account to improve the consistency between the data sets. The fit result strongly favors the existence of the break at $\sim 1$ TeV with an even higher statistical significance of $13.3~\sigma$. In view of the tentative CRE break, we revisit a number of models of nearby sources, such as a single generic Pulsar Wind Nebula (PWN), known multiple PWNe from the ATNF catalog, and their combinations with either an additional Dark Matter (DM) component or a Supernova Remnant (SNR). We show that the CRE break at $\sim 1$ TeV, together with the known CR positron excess points towards the possibility that the nearby sources should be highly charge asymmetric. Among the models under consideration, the one with a PWN plus SNR is most favored by the current data. The favoured distance and age of the PWN and SNR sources are both within $0.6$ kpc and around $10^{5}$ yr respectively. Possible candidate sources include PSR J0954-5430, Vela and Monogem ring, etc. We find that for the models under consideration, the additional DM component is either unnecessary, or predicts too much photons in tension with the H.E.S.S. data of $\gamma$-rays from the direction of the Galactic Center. We also show that the current measurement of the anisotropies in the arrival direction of the CRE can be useful in determining the property of the sources.

It has been shown, both in simulations and observationally, that the tidal field of a large galaxy can torque its satellites such that the major axis of satellite galaxies points towards their hosts. This so-called `shape alignment' has been observed in isolated Milky Way-like galaxies but not in `Local Group'-like pairs. In this study, we investigate the shape alignment of satellite galaxies in galaxy pairs similar to the Local Group identified in the Sloan Digital Sky Survey Data Release 13 (SDSS DR13). By stacking tens of thousands of satellite galaxies around primary galaxy pairs, we find two statistically strong alignment signals. (1) The major axes of satellite galaxies located in the (projected) area between two primaries (the {\it facing} region) tend to be perpendicular to the line connecting the satellite to its host (tangential alignment), while (2) the major axes of satellite galaxies located in regions away from the other host (the {\it away} region) tend to be aligned with the line connecting the satellite to its host (radial alignment). These alignments are confirmed at $\sim5\sigma$ levels. The alignment signal increases with increasing primary brightness, decreasing pair separation, and decreasing satellite distance. The alignment signal is also found to be stronger in filamentary environments. These findings will shed light on understanding the mechanisms of how satellite galaxies are affected by the tidal field in galaxy pairs and will be useful for investigating galaxy intrinsic alignment in the analyses of weak gravitational lensing.

The bulk composition of the Earth is dramatically carbon poor compared to that of the interstellar medium, and this phenomenon extends to the asteroid belt. To interpret this carbon deficit problem, the carbonaceous component in grains must have been converted into the gas-phase in the inner regions of protoplanetary disks prior to planetary formation. We examine the effect of carbon grain destruction on the chemical structure of disks by calculating the molecular abundances and distributions using a comprehensive chemical reaction network. When carbon grains are destroyed and the elemental abundance of the gas becomes carbon-rich, the abundances of carbon-bearing molecules, such as HCN and carbon-chain molecules, increase dramatically near the midplane, while oxygen-bearing molecules, such as H$_2$O and CO$_2$, are depleted. We compare the results of these model calculations with the solid carbon fraction in the solar system. Although we find a carbon depletion gradient, there are some quantitative discrepancies: the model shows a higher value at the position of asteroid belt and a lower value at the location of the Earth. In addition, using the obtained molecular abundances distributions, coupled with line radiative transfer calculations, we make predictions for ALMA to potentially observe the effect of carbon grain destruction in nearby protoplanetary disks. The results indicate that HCN, H$^{13}$CN and c-C$_3$H$_2$ may be good tracers.

The intrinsic alignment of galaxies is an important systematic effect in weak-lensing surveys, which can affect the derived cosmological parameters. One direct way to distinguish different alignment models and quantify their effects on the measurement is to produce mocked weak-lensing surveys. In this work, we use full-sky ray-tracing technique to produce mock images of galaxies from the ELUCID $N$-body simulation run with the WMAP9 cosmology. In our model we assume that the shape of central elliptical galaxy follows that of the dark matter halo, and spiral galaxy follows the halo spin. Using the mocked galaxy images, a combination of galaxy intrinsic shape and the gravitational shear, we compare the predicted tomographic shear correlations to the results of KiDS and DLS. It is found that our predictions stay between the KiDS and DLS results. We rule out a model in which the satellite galaxies are radially aligned with the center galaxy, otherwise the shear-correlations on small scales are too high. Most important, we find that although the intrinsic alignment of spiral galaxies is very weak, they induce a positive correlation between the gravitational shear signal and the intrinsic galaxy orientation (GI). This is because the spiral galaxy is tangentially aligned with the nearby large-scale overdensity, contrary to the radial alignment of elliptical galaxy. Our results explain the origin of detected positive GI term from the weak-lensing surveys. We conclude that in future analysis, the GI model must include the dependence on galaxy types in more detail.

The convergence peaks, constructed from galaxy shape measurement in weak lensing, is a powerful probe of cosmology as the peaks can be connected with the underlined dark matter haloes. However the capability of convergence peak statistic is affected by the noise in galaxy shape measurement, signal to noise ratio as well as the contribution from the projected mass distribution from the large-scale structures along the line of sight (LOS). In this paper we use the ray-tracing simulation on a curved sky to investigate the correspondence between the convergence peak and the dark matter haloes at the LOS. We find that, in case of no noise and for source galaxies at $z_{\rm s}=1$, more than $65\%$ peaks with $\text{SNR} \geq 3$ (signal to noise ratio) are related to more than one massive haloes with mass larger than $10^{13} {\rm M}_{\odot}$. Those massive haloes contribute $87.2\%$ to high peaks ($\text{SNR} \geq 5$) with the remaining contributions are from the large-scale structures. On the other hand, the peaks distribution is skewed by the noise in galaxy shape measurement, especially for lower SNR peaks. In the noisy field where the shape noise is modelled as a Gaussian distribution, about $60\%$ high peaks ($\text{SNR} \geq 5$) are true peaks and the fraction decreases to $20\%$ for lower peaks ($ 3 \leq \text{SNR} < 5$). Furthermore, we find that high peaks ($\text{SNR} \geq 5$) are dominated by very massive haloes larger than $10^{14} {\rm M}_{\odot}$.

In a recent study, using the distribution of galaxies in the north galactic pole of SDSS DR7 region enclosed in a 500$\mpch$ box, we carried out our ELUCID simulation (Wang et al. 2016, ELUCID III). Here we {\it light} the dark matter halos and subhalos in the reconstructed region in the simulation with galaxies in the SDSS observations using a novel {\it neighborhood} abundance matching method. Before we make use of thus established galaxy-subhalo connections in the ELUCID simulation to evaluate galaxy formation models, we set out to explore the reliability of such a link. For this purpose, we focus on the following a few aspects of galaxies: (1) the central-subhalo luminosity and mass relations; (2) the satellite fraction of galaxies; (3) the conditional luminosity function (CLF) and conditional stellar mass function (CSMF) of galaxies; and (4) the cross correlation functions between galaxies and the dark matter particles, most of which are measured separately for all, red and blue galaxy populations. We find that our neighborhood abundance matching method accurately reproduces the central-subhalo relations, satellite fraction, the CLFs and CSMFs and the biases of galaxies. These features ensure that thus established galaxy-subhalo connections will be very useful in constraining galaxy formation processes. And we provide some suggestions on the three levels of using the galaxy-subhalo pairs for galaxy formation constraints. The galaxy-subhalo links and the subhalo merger trees in the SDSS DR7 region extracted from our ELUCID simulation are available upon request.

In the context of strong gravitational lensing, the magnification of image is of crucial importance to constrain various lens models. For several commonly used quadruple lens models, the magnification invariants, defined as the sum of the signed magnifications of images, have been analytically derived when the image multiplicity is a maximum. In this paper, we further study the magnification of several disk lens models, including (a) exponential disk lens, (b) Gaussian disk lens, (c) modified Hubble profile lens, and another two of the popular three-dimensional symmetrical lens model, (d) NFW lens and (e) Einasto lens. We find that magnification invariant does also exist for each lens model. Moreover, our results show that magnification invariants can be significantly changed by the characteristic surface mass density $\kappa_{\rm c}$.

We examine the quenched fraction of central and satellite galaxies as a function of galaxy stellar mass, halo mass, and the matter density of their large scale environment. Matter densities are inferred from our ELUCID simulation, a constrained simulation of local Universe sampled by SDSS, while halo masses and central/satellite classification are taken from the galaxy group catalog of Yang et al. The quenched fraction for the total population increases systematically with the three quantities. We find that the `environmental quenching efficiency', which quantifies the quenched fraction as function of halo mass, is independent of stellar mass. And this independence is the origin of the stellar mass-independence of density-based quenching efficiency, found in previous studies. Considering centrals and satellites separately, we find that the two populations follow similar correlations of quenching efficiency with halo mass and stellar mass, suggesting that they have experienced similar quenching processes in their host halo. We demonstrate that satellite quenching alone cannot account for the environmental quenching efficiency of the total galaxy population and the difference between the two populations found previously mainly arises from the fact that centrals and satellites of the same stellar mass reside, on average, in halos of different mass. After removing these halo-mass and stellar-mass effects, there remains a weak, but significant, residual dependence on environmental density, which is eliminated when halo assembly bias is taken into account. Our results therefore indicate that halo mass is the prime environmental parameter that regulates the quenching of both centrals and satellites.

We present a concept of surface decomposition extended from double Fourier series to nonnegative sinusoidal wave surfaces, on the basis of which linear ion sources apply to the ultra-precision fabrication of complex surfaces and diffractive optics. It is the first time that we have a surface descriptor for building a relationship between the fabrication process of optical surfaces and the surface characterization based on PSD analysis, which akin to Zernike polynomials used for mapping the relationship between surface errors and Seidel aberrations. Also, we demonstrate that the one-dimensional scanning of linear ion source is applicable to the removal of surface errors caused by small-tool polishing in raster scan mode as well as the fabrication of beam sampling grating of high diffractive uniformity without a post-processing procedure. The simulation results show that, in theory, optical fabrication with linear ion source is feasible and even of higher output efficiency compared with the conventional approach.