Differential atmospheric dispersion is a wavelength-dependent effect introduced by the atmosphere. It is one of the instrumental errors that can affect the position of the target as perceived on the sky and its flux distribution. This effect will affect the results of astronomical observations if not corrected by an atmospheric dispersion corrector (ADC). In high-resolution spectrographs, in order to reach a radial velocity (RV) precision of 10 cm/s, an ADC is expected to return residuals at only a few tens of milli-arcseconds (mas). In fact, current state-of-the-art spectrographs conservatively require this level of residuals, although no work has been done to quantify the impact of atmospheric dispersion. In this work we test the effect of atmospheric dispersion on astronomical observations in general, and in particular on RV precision degradation and flux losses. Our scientific objective was to quantify the amount of residuals needed to fulfill the requirements set on an ADC during the design phase. We found that up to a dispersion of 100 mas, the effect on the RV is negligible. However, on the flux losses, such a dispersion can create a loss of ~2% at 380 nm, a significant value when efficiency is critical. The requirements set on ADC residuals should take into consideration the atmospheric conditions where the ADC will function, and also all the aspects related with not only the RV precision requirements but also the guiding camera used, the tolerances on the flux loss, and the different melt data of the chosen glasses.

Observations with ground-based telescopes are affected by differential atmospheric dispersion when seen at a zenith angle different from zero, a consequence of the wavelength-dependent index of refraction of the atmosphere. One of the pioneering technology in detecting exoplanets is the technique of radial velocity (RV), that can be affected by uncorrected atmospheric dispersion. The current highest precision spectrographs are expected to deliver a precision of 10 cm/s (e.g., ESPRESSO). To minimize the atmospheric dispersion effect, an Atmospheric Dispersion Corrector (ADC) can be employed. ADC designs are based on sky dispersion models that nonetheless give different results; these can reach a few tens of milli-arcseconds (mas) in the sky (a difference up to 40 mas); a value close to the current requirements (20 mas in the case of ESPRESSO). In this paper we describe tests done with ESPRESSO and HARPS to understand the influence of atmospheric dispersion and its correction on RV precision. We also present a comparison of different sky models, using EFOSC2 data (between 600nm and 700nm), that will be used to improve on the design of ADCs.

In ground based astronomical observations, atmospheric dispersion shifts the image of the object at different wavelengths due to the wavelength-dependent index of refraction of the atmosphere. Thus, using an Atmospheric Dispersion Corrector (ADC) is mandatory in order to avoid any wavelength dependent losses. Typical ADC configurations, for high resolution astronomical instruments, are two counter-rotating prisms, a set of, at least, four prisms paired together. With the arrival of large telescopes with higher angular magnification, and spectrographs with higher resolution, the requirements on the dispersion correction are becoming more critical due to the impact on the produced science (e.g. radial velocity precision). We developed an ADC optical design tool in order to select the best set of glasses in terms of residuals, transmission, resulting image quality, Fresnel losses, taking into account the required spectral range and typical atmospheric conditions where the ADC will be working. A demonstration of the capabilities of the tool is presented with the analysis of the impact of different melt data, the effect of different glass Sellmeier coefficients between catalog and measured ones, that can create a difference in the residuals above few tens of milli-arcseconds (mas). The tool allows the investigation of critical steps on the ADC design phase and speeds up the glass selection process critical for the harder requirements of the future instruments/telescopes.