We present a machine learning (ML) based method for automated detection of Gamma-Ray Burst (GRB) candidate events in the range 60 KeV - 250 KeV from the AstroSat Cadmium Zinc Telluride Imager data. We make use of density-based spatial clustering to detect excess power and carry out an unsupervised hierarchical clustering across all such events to identify the different categories of light curves present in the data. This representation helps in understanding the sensitivity of the instrument to the various GRB populations and identifies the major non-astrophysical noise artefacts present in the data. We make use of dynamic time wrapping (DTW) to carry out template matching to ensure the morphological similarity of the detected events with that of known typical GRB light curves. DTW alleviates the need for a dense template repository often required in matched filtering like searches, and the use of a similarity metric facilitates outlier detection suitable for capturing un-modeled events previously. The developed pipeline is used for searching GRBs in AstroSat data, and we briefly report the characteristics of newly detected 35 long GRB candidates. With minor modifications such as adaptive binning, the method is also sensitive to short GRBs events. Augmenting the existing on-ground data analysis pipeline with such ML capabilities could alleviate the need for extensive manual inspection and thus enable quicker response to alerts received from other observatories such as the gravitational-wave detectors.

The radio as well as the high energy emission mechanism in pulsars is yet not understood properly. A multi-wavelength study is likely to help in better understanding of such processes. The first Indian space-based observatory, ASTROSAT, has five instruments aboard, which cover the electromagnetic spectrum from infra-red (1300 $\AA$) to hard X-ray (380 KeV). Cadmium Zinc Telluride Imager (CZTI), one of the five instruments is a hard X-ray telescope functional over an energy range of 20-380 KeV. We aim to estimate the timing offset introduced in the data acquisition pipeline of the instrument, which will help in time alignment of high energy time series with those from two other ground-based observatories, viz. the Giant Meterwave Radio Telescope (GMRT) and the Ooty Radio Telescope (ORT). PSR B0531+21 is a well-studied pulsar with nearly aligned radio and hard X-ray pulse profiles. We use simultaneous observations of this pulsar with the ASTROSAT, the ORT and the GMRT. The pulsar was especially observed using the ORT with almost daily cadence to obtain good timing solutions. We also supplement the ORT data with archival FERMI data for estimation of timing noise. The timing offset of ASTROSAT instruments was estimated from fits to arrival time data at the ASTROSAT and the radio observatories. We estimate the offset between the GMRT and the ASTROSAT-CZTI to be -4716 $\pm$ 50 $\mu s$. The corresponding offset with the ORT was -29639 $\pm$ 50 $\mu s$. The offsets between the GMRT and Fermi-LAT -5368 $\pm$ 56 $\mu s$. (Abridged)

We present multi-wavelength follow-up campaigns by the AstroSat-CZTI and GROWTH collaborations to search for an electromagnetic counterpart to the gravitational wave event GW170104. At the time of the GW170104 trigger, the AstroSat CZTI field-of-view covered 50.3\% of the sky localization. We do not detect any hard X-ray (>100 keV) signal at this time, and place an upper limit of $\approx 4.5 \times 10^{-7}~{\rm erg~cm}^{-2}{\rm~s}^{-1}$ for a 1\,s timescale. Separately, the ATLAS survey reported a rapidly fading optical source dubbed ATLAS17aeu in the error circle of GW170104. Our panchromatic investigation of ATLAS17aeu shows that it is the afterglow of an unrelated long, soft GRB~170105A, with only a fortuitous spatial coincidence with GW170104. We then discuss the properties of this transient in the context of standard long GRB afterglow models.

AstroSat is a multi-wavelength satellite launched on 2015 September 28. The CZT Imager of AstroSat on its very first day of operation detected a long duration gamma-ray burst (GRB) namely GRB 151006A. Using the off-axis imaging and spectral response of the instrument, we demonstrate that CZT Imager can localise this GRB correct to about a few degrees and it can provide, in conjunction with Swift, spectral parameters similar to that obtained from Fermi/GBM. Hence CZT Imager would be a useful addition to the currently operating GRB instruments (Swift and Fermi). Specifically, we argue that the CZT Imager will be most useful for the short hard GRBs by providing localisation for those detected by Fermi and spectral information for those detected only by Swift. We also provide preliminary results on a new exciting capability of this instrument: CZT Imager is able to identify Compton scattered events thereby providing polarisation information for bright GRBs. GRB 151006A, in spite of being relatively faint, shows hints of a polarisation signal at 100-300 keV (though at a low significance level). We point out that CZT Imager should provide significant time resolved polarisation measurements for GRBs that have fluence 3 times higher than that of GRB 151006A. We estimate that the number of such bright GRBs detectable by CZT Imager is 5 - 6 per year. CZT Imager can also act as a good hard X-ray monitoring device for possible electromagnetic counterparts of Gravitational Wave events.

The Cadmium Zinc Telluride Imager (CZTI) is a high energy, wide-field imaging instrument on AstroSat. CZT's namesake Cadmium Zinc Telluride detectors cover an energy range from 20 keV to > 200 keV, with 11% energy resolution at 60 keV. The coded aperture mask attains an angular resolution of 17' over a 4.6 deg x 4.6 deg (FWHM) field of view. CZTI functions as an open detector above 100 keV, continuously sensitive to GRBs and other transients in about 30% of the sky. The pixellated detectors are sensitive to polarisation above ~100 keV, with exciting possibilities for polarisation studies of transients and bright persistent sources. In this paper, we provide details of the complete CZTI instrument, detectors, coded aperture mask, mechanical and electronic configuration, as well as data and products.

AstroStat is an easy-to-use tool for performing statistical analysis on data. It has been designed to be compatible with Virtual Observatory (VO) standards thus enabling it to become an integral part of the currently available collection of VO tools. A user can load data in a variety of formats into AstroStat and perform various statistical tests using a menu driven interface. Behind the scenes, all analysis is done using the public domain statistical software - R and the output returned is presented in a neatly formatted form to the user. The analyses performable include exploratory tests, visualizations, distribution fitting, correlation & causation, hypothesis testing, multivariate analysis and clustering. The tool is available in two versions with identical interface and features - as a web service that can be run using any standard browser and as an offline application. AstroStat will provide an easy-to-use interface which can allow for both fetching data and performing power statistical analysis on them.