In order to constraint the limitations of association methods applied to galaxy surveys, we analysed the catalogue of halos at $z=0$ of a cosmological simulation, trying to reproduce the limitations that an observational survey deal with. We focused in the percolation method, usually called Friends of Friends method, commonly used in literature. The analysis was carried on the dark matter cosmological simulation MDPL2, from the Multidark project. Results point to a large fraction of contaminants for massive halos in high density environments. Thresholds in the association parameters and the subsequent analysis of observational properties can mitigate the occurrence of fake positives. The use of tests for substructures can also be efficient in particular cases.

We use the semi-analytic model of galaxy formation SAG to study the relevance of mass and environmental quenching on satellite galaxies. We find that environmental processes dominate the star formation (SF) quenching of low-mass satellites ($M_{\star} \lesssim 10^{10.5}\, {\rm M}_{\odot}$), whereas high-mass galaxies typically quench as centrals. High-mass galaxies that remain actively forming stars while being accreted are found to be mainly affected by mass quenching after their first infall. For a given stellar mass, our model predicts SF quenching to be less efficient in low-mass haloes both before and after infall, in contradiction with common interpretations of observational data. Our model supports a two-stage scenario to explain the SF quenching. Initially, the SF of satellites resembles that of centrals until the gas cooling rate is reduced to approximately half its value at infall. Then, the SF fades through secular processes that exhaust the cold gas reservoir. This reservoir is not replenished efficiently due to the action of either ram-pressure stripping (RPS) of the hot gas in low-mass satellites, or feedback from the active galactic nucleus (AGN) in high-mass satellites. The delay times for the onset of SF quenching are found to range from $\approx 3\,{\rm Gyr}$ to $\approx 1\,{\rm Gyr}$ for low-mass ($M_{\star} \approx 10^{10}\, {\rm M}_{\odot}$) and high-mass ($M_{\star} \approx 10^{11}\, {\rm M}_{\odot}$) satellites, respectively. SF fades in $\approx 1.5\,{\rm Gyr}$, largely independent of stellar mass. We find that the SF quenching of low-mass satellites supports the so-called delay-then-rapid quenching scenario. However, the SF history of $z=0$ passive satellites of any stellar mass is better described by a delay-then-fade quenching scenario.

We present results from the semi-analytic model of galaxy formation SAG applied on the MultiDark simulation MDPL2. SAG features an updated supernova (SN) feedback scheme and a robust modelling of the environmental effects on satellite galaxies. This incorporates a gradual starvation of the hot gas halo driven by the action of ram pressure stripping (RPS), that can affect the cold gas disc, and tidal stripping (TS), which can act on all baryonic components. Galaxy orbits of orphan satellites are integrated providing adequate positions and velocities for the estimation of RPS and TS. The star formation history and stellar mass assembly of galaxies are sensitive to the redshift dependence implemented in the SN feedback model. We discuss a variant of our model that allows to reconcile the predicted star formation rate density at $z \gtrsim 3$ with the observed one, at the expense of an excess in the faint end of the stellar mass function at $z=2$. The fractions of passive galaxies as a function of stellar mass, halo mass and the halo-centric distances are consistent with observational measurements. The model also reproduces the evolution of the main sequence of star forming central and satellite galaxies. The similarity between them is a result of the gradual starvation of the hot gas halo suffered by satellites, in which RPS plays a dominant role. RPS of the cold gas does not affect the fraction of quenched satellites but it contributes to reach the right atomic hydrogen gas content for more massive satellites ($M_{\star}\gtrsim 10^{10}\,{\rm M}_{\odot}$).

We introduce the THE THREE HUNDRED project, an endeavour to model 324 large galaxy clusters with full-physics hydrodynamical re-simulations. Here we present the data set and study the differences to observations for fundamental galaxy cluster properties and scaling relations. We find that the modelled galaxy clusters are generally in reasonable agreement with observations with respect to baryonic fractions and gas scaling relations at redshift z = 0. However, there are still some (model-dependent) differences, such as central galaxies being too massive, and galaxy colours (g - r) being bluer (about 0.2 dex lower at the peak position) than in observations. The agreement in gas scaling relations down to 10^{13} h^{-1} M_{\odot} between the simulations indicates that particulars of the sub-grid modelling of the baryonic physics only has a weak influence on these relations. We also include - where appropriate - a comparison to three semi-analytical galaxy formation models as applied to the same underlying dark-matter-only simulation. All simulations and derived data products are publicly available.

We use the semi-analytic model (SAM) of galaxy formation and evolution SAG coupled with the MULTIDARK simulation MDPL2 to study the evolution of the stellar mass-gas metallicity relation of galaxies (MZR). We test several implementations of the dependence of the mass loading due to supernovae (SNe). We find that no evolution in the normalization of the MZR is obtained unless we introduce an explicit scaling of the reheated and ejected mass with redshift as $(1+z)^\beta$. The latter is in agreement with results from the FIRE simulations, and it should encompass small scale properties of the interstellar medium varying over time, which are not captured in SAMs, as well as other energy sources in addition to SNe. Increasing $\beta$ leads to stronger evolution of the MZR normalization; $\beta = 1.9$ reproduces the observed MZR in the range $0 < z < 3.5$. A stronger redshift dependence of outflows reduces the levels of star formation at earlier epochs with the consequent decrease of metal production. This leads to a slower increase of the gas metallicity compared to the stellar mass build-up. The cold gas can be contaminated either by receiving a direct injection of the material recycled by stellar winds and SNe or by gas cooling. The relative role of each process for a given stellar mass depends on the criterion adopted to regulate the fate of the recycled material. However, modifying the metal loading of the outflows has mild impact on the zero-point evolution and does not affect our conclusions.

We present a comparison of the observed evolving galaxy stellar mass functions with the predictions of eight semi-analytic models and one halo occupation distribution model. While most models are able to fit the data at low redshift, some of them struggle to simultaneously fit observations at high redshift. We separate the galaxies into 'passive' and 'star-forming' classes and find that several of the models produce too many low-mass star-forming galaxies at high redshift compared to observations, in some cases by nearly a factor of 10 in the redshift range $2.5 < z < 3.0$. We also find important differences in the implied mass of the dark matter haloes the galaxies inhabit, by comparing with halo masses inferred from observations. Galaxies at high redshift in the models are in lower mass haloes than suggested by observations, and the star formation efficiency in low-mass haloes is higher than observed. We conclude that many of the models require a physical prescription that acts to dissociate the growth of low-mass galaxies from the growth of their dark matter haloes at high redshift.

The use of high-quality simulated sky catalogs is essential for the success of cosmological surveys. The catalogs have diverse applications, such as investigating signatures of fundamental physics in cosmological observables, understanding the effect of systematic uncertainties on measured signals and testing mitigation strategies for reducing these uncertainties, aiding analysis pipeline development and testing, and survey strategy optimization. The list of applications is growing with improvements in the quality of the catalogs and the details that they can provide. Given the importance of simulated catalogs, it is critical to provide rigorous validation protocols that enable both catalog providers and users to assess the quality of the catalogs in a straightforward and comprehensive way. For this purpose, we have developed the DESCQA framework for the Large Synoptic Survey Telescope Dark Energy Science Collaboration as well as for the broader community. The goal of DESCQA is to enable the inspection, validation, and comparison of an inhomogeneous set of synthetic catalogs via the provision of a common interface within an automated framework. In this paper, we present the design concept and first implementation of DESCQA. In order to establish and demonstrate its full functionality we use a set of interim catalogs and validation tests. We highlight several important aspects, both technical and scientific, that require thoughtful consideration when designing a validation framework, including validation metrics and how these metrics impose requirements on the synthetic sky catalogs.

We present a comparison of nine galaxy formation models, eight semi-analytical and one halo occupation distribution model, run on the same underlying cold dark matter simulation (cosmological box of co-moving width 125$h^{-1}$ Mpc, with a dark-matter particle mass of $1.24\times 10^9 h^{-1}$ Msun) and the same merger trees. While their free parameters have been calibrated to the same observational data sets using two approaches, they nevertheless retain some 'memory' of any previous calibration that served as the starting point (especially for the manually-tuned models). For the first calibration, models reproduce the observed z = 0 galaxy stellar mass function (SMF) within 3-{\sigma}. The second calibration extended the observational data to include the z = 2 SMF alongside the z~0 star formation rate function, cold gas mass and the black hole-bulge mass relation. Encapsulating the observed evolution of the SMF from z = 2 to z = 0 is found to be very hard within the context of the physics currently included in the models. We finally use our calibrated models to study the evolution of the stellar-to-halo mass (SHM) ratio. For all models we find that the peak value of the SHM relation decreases with redshift. However, the trends seen for the evolution of the peak position as well as the mean scatter in the SHM relation are rather weak and strongly model dependent. Both the calibration data sets and model results are publicly available.

We present the public release of the MultiDark-Galaxies: three distinct galaxy catalogues derived from one of the Planck cosmology MultiDark simulations (i.e. MDPL2, with a volume of (1 Gpc/$h$)$^{3}$ and mass resolution of $1.5 \times 10^{9} M_{\odot}/h$) by applying the semi-analytic models GALACTICUS, SAG, and SAGE to it. We compare the three models and their conformity with observational data for a selection of fundamental properties of galaxies like stellar mass function, star formation rate, cold gas fractions, and metallicities - noting that they sometimes perform differently reflecting model designs and calibrations. We have further selected galaxy subsamples of the catalogues by number densities in stellar mass, cold gas mass, and star formation rate in order to study the clustering statistics of galaxies. We show that despite different treatment of orphan galaxies, i.e. galaxies that lost their dark-matter host halo due to the finite mass resolution of the N-body simulation or tidal stripping, the clustering signal is comparable, and reproduces the observations in all three models - in particular when selecting samples based upon stellar mass. Our catalogues provide a powerful tool to study galaxy formation within a volume comparable to those probed by on-going and future photometric and redshift surveys. All model data consisting of a range of galaxy properties - including broad-band SDSS magnitudes - are publicly available.

We study the stellar populations of bulges of Milky Way-like (MW-like) galaxies with the aim of identifying the physical processes involved in the formation of the bulge of our Galaxy. We use the semi-analytic model of galaxy formation and evolution SAG adapted to this aim; this kind of models can trace the properties of galaxies and their components like stellar discs, bulges and halos, but resolution limits prevent them from reaching the scale of stellar populations (SPs). Properties of groups of stars formed during single star formation events are stored and tracked in the model and results are compared with observations of stars in the galactic bulge. MW-like galaxies are selected using two different criteria. One of them considers intrinsic photo-metric properties and the second is focused on the cosmological context of the local group of galaxies (LG). We compare our model results with spectroscopic and photometric stellar metallicity distributions. We find that 87% of stars in bulges of MWtype galaxies in our model are accreted and formed in starbursts during disc instability events. Mergers contribute to 13% of the mass budget of the bulge and are responsible for the low metallicity tail of the distribution. Abundance ratios of {\alpha} elements with respect to iron, [{\alpha}/Fe], are measured in SPs of model galaxies. The patterns found in the model for SPs with different origins help to explain the lack of a gradient of [{\alpha}/Fe] ratios in observed stars along the minor axis of the bulge.

We present a clustering comparison of 12 galaxy formation models (including Semi-Analytic Models (SAMs) and Halo Occupation Distribution (HOD) models) all run on halo catalogues and merger trees extracted from a single {\Lambda}CDM N-body simulation. We compare the results of the measurements of the mean halo occupation numbers, the radial distribution of galaxies in haloes and the 2-Point Correlation Functions (2PCF). We also study the implications of the different treatments of orphan (galaxies not assigned to any dark matter subhalo) and non-orphan galaxies in these measurements. Our main result is that the galaxy formation models generally agree in their clustering predictions but they disagree significantly between HOD and SAMs for the orphan satellites. Although there is a very good agreement between the models on the 2PCF of central galaxies, the scatter between the models when orphan satellites are included can be larger than a factor of 2 for scales smaller than 1 Mpc/h. We also show that galaxy formation models that do not include orphan satellite galaxies have a significantly lower 2PCF on small scales, consistent with previous studies. Finally, we show that the 2PCF of orphan satellites is remarkably different between SAMs and HOD models. Orphan satellites in SAMs present a higher clustering than in HOD models because they tend to occupy more massive haloes. We conclude that orphan satellites have an important role on galaxy clustering and they are the main cause of the differences in the clustering between HOD models and SAMs.

We present a fast and accurate method to select an optimal set of parameters in semi-analytic models of galaxy formation and evolution (SAMs). Our approach compares the results of a model against a set of observables applying a stochastic technique called Particle Swarm Optimization (PSO), a self-learning algorithm for localizing regions of maximum likelihood in multidimensional spaces that outperforms traditional sampling methods in terms of computational cost. We apply the PSO technique to the SAG semi-analytic model combined with merger trees extracted from a standard $\Lambda$CDM N-body simulation. The calibration is performed using a combination of observed galaxy properties as constraints, including the local stellar mass function and the black hole to bulge mass relation. We test the ability of the PSO algorithm to find the best set of free parameters of the model by comparing the results with those obtained using a MCMC exploration. Both methods find the same maximum likelihood region, however the PSO method requires one order of magnitude less evaluations. This new approach allows a fast estimation of the best-fitting parameter set in multidimensional spaces, providing a practical tool to test the consequences of including other astrophysical processes in SAMs.