We present a study of the two main peaks of the so-called cathedral QPO in XTE J1859+226. While looking at the temporal evolution of the two features we show that they do not manifest the same amplitude of variations of their power, and do not seem to follow the flux variations in the same way. We then present their RMS-spectra and show that they do not have the same shape, slope and cut-off energy. We discuss these different facts and try to answer the question regarding the genuineness of their harmonic relationship.

Abridged: We present a spectral and temporal analysis of the Cathedral QPO detected in the power density spectra of the microquasar XTE J1859+226 obtained with RXTE. This type of QPO manifests as two peaks with similar amplitudes and harmonically related centroid frequencies (~3 and ~6 Hz). The amplitude of the ~3 Hz feature varies in anticorrelation with the count rate, by about ~50. The ~6 Hz feature shows a slight increase (~7%) of its amplitude with count rate. The RMS-spectra of the two peaks are quite different. The ~3 Hz feature is softer than the other one, and shows a cut-off at an energy of ~6 keV while the RMS of the 6 Hz increases up to at least 20 keV. We also study the bicoherence, $b^2(\mu,\nu)$. The values b^2(~3,~3) and b^2(~6,~6) are rather high and similar to the type C QPOs of GRS 1915+105. By comparison with the latter source the fact that the bicoherence of the ~3 Hz feature is higher than that of the other peak, would tend to indicate that the ~3 Hz is the fundamental QPO. The value of b^2(~3,~6)$ is, however, low and therefore indicates a behavior that is different than that seen in GRS 1915+105. We suggest that, rather than pure harmonics, we may see different modes of the same underlying phenomenon competing to produce QPOs at different frequencies.

Tracing the formation and evolution of all supermassive black holes, including the obscured ones, understanding how black holes influence their surroundings and how matter behaves under extreme conditions, are recognized as key science objectives to be addressed by the next generation of instruments. These are the main goals of the COSPIX proposal, made to ESA in December 2010 in the context of its call for selection of the M3 mission. In addition, COSPIX, will also provide key measurements on the non thermal Universe, particularly in relation to the question of the acceleration of particles, as well as on many other fundamental questions as for example the energetic particle content of clusters of galaxies. COSPIX is proposed as an observatory operating from 0.3 to more than 100 keV. The payload features a single long focal length focusing telescope offering an effective area close to ten times larger than any scheduled focusing mission at 30 keV, an angular resolution better than 20 arcseconds in hard X-rays, and polarimetric capabilities within the same focal plane instrumentation. In this paper, we describe the science objectives of the mission, its baseline design, and its performances, as proposed to ESA.

Studying the physical conditions in circumstellar disks is a crucial step toward understanding planet formation. Of particular interest is the case of HD 100546, a Herbig Be star that presents a gap within the first 13 AU of its protoplanetary disk, that may originate in the dynamical interactions of a forming planet. We gathered a large amount of new interferometric data using the AMBER/VLTI instrument in the H- and K-bands to spatially resolve the warm inner disk and constrain its structure. Then, combining these measurements with photometric observations, we analyze the circumstellar environment of HD 100546 in the light of a passive disk model based on 3D Monte-Carlo radiative transfer. Finally, we use hydrodynamical simulations of gap formation by planets to predict the radial surface density profile of the disk and test the hypothesis of ongoing planet formation. The SED and the NIR interferometric data are adequately reproduced by our model. We show that the H- and K-band emissions are coming mostly from the inner edge of the internal dust disk, located near 0.24 AU from the star, i.e., at the dust sublimation radius in our model. We directly measure an inclination of $33^{\circ} \pm 11^{\circ}$ and a position angle of $140^{\circ} \pm 16^{\circ}$ for the inner disk. This is similar to the values found for the outer disk ($i \simeq 42^{\circ}$, $PA \simeq 145^{\circ}$), suggesting that both disks may be coplanar. We finally show that 1 to 8 Jupiter mass planets located at $\sim 8$ AU from the star would have enough time to create the gap and the required surface density jump of three orders of magnitude between the inner and outer disk. However, no information on the amount of matter left in the gap is available, which precludes us from setting precise limits on the planet mass, for now.

We present two dimensional cylindrically symmetric hydrodynamic simulations and synthetic emission maps of a stellar wind propagating into an infalling, rotating environment. The resulting outflow morphology, collimation and stability observed in these simulations have relevance to the study of young stellar objects, Herbig-Haro jets and molecular outflows. Our code follows hydrogen gas with molecular, atomic and ionic components tracking the associated time dependent molecular chemistry and ionization dynamics with radiative cooling appropriate for a dense molecular gas. We present tests of the code as well as new simulations which indicate the presence of instabilities in the wind-blown bubble's swept-up shell.

The Accretion-Ejection Instability (AEI) has been proposed to explain the low frequency Quasi-Periodic Oscillation (QPO) observed in low-mass X-Ray Binaries. Its frequency, typically a fraction of the Keplerian frequency at the disk inner radius, is in the right range indicated by observations. With numerical simulation we will show how this instability is able to produce a modulation of the X-ray flux and what are the characteristic of this modulation. More simulations are required, especially 3D MHD simulations. We will briefly present a new code in development: AstroBear which will allow us to create synthetic spectra.