The presence of rocky exoplanets with a large refractory carbon inventory is predicted by chemical evolution models of protoplanetary disks of stars with photospheric C/O >0.65, and by models studying the radial transport of refractory carbon. High-pressure high-temperature laboratory experiments show that most of the carbon in these exoplanets differentiates into a graphite outer shell. Our aim is to evaluate the effects of a graphite outer shell on the thermal evolution of rocky exoplanets containing a metallic core and a silicate mantle. We implement a parameterized model of mantle convection to determine the thermal evolution of rocky exoplanets with graphite layer thicknesses up to 1000 km. We find that, due to the high thermal conductivity of graphite, conduction is the dominant heat transport mechanism in a graphite layer for the long-term evolution (>200 Myr). The conductive graphite shell essentially behaves like a stagnant lid with a fixed thickness. Models of Kepler-37b (Mercury-size) and a Mars-sized exoplanet show that a planet with a graphite lid cools faster than a planet with a silicate lid, and a planet without a stagnant lid cools the fastest. A graphite lid needs to be approximately ten times thicker than a corresponding silicate lid in order to produce similar thermal evolution.

Carbon-enriched rocky exoplanets have been proposed around dwarf stars as well as around binary stars, white dwarfs and pulsars. However, the mineralogical make up of such planets is poorly constrained. We performed high-pressure high-temperature laboratory experiments ($P$ = 1$-$2 GPa, $T$ = 1523$-$1823 K) on carbon-enriched chemical mixtures to investigate the deep interiors of Pluto- to Mars-size planets the upper mantles of larger planets. Our results show that these exoplanets, when fully-differentiated, comprise a metallic core, a silicate mantle and a graphite layer on top of the silicate mantle. The silicate mineralogy (olivine, orthopyroxene, clinopyroxene and spinel) is largely unaffected by the amount of carbon. Metals are either two immiscible iron-rich alloys (S-rich and S-poor) or a single iron-rich alloy in the Fe-C-S system with immiscibility depending on the S/Fe ratio and core pressure. Graphite is the dominant carbon-bearing phase at the conditions of our experiments with no traces of silicon carbide or carbonates. If the bulk carbon content is higher than needed to saturate the mantle and the core, graphite would be in the form of an additional layer on top of the silicate mantle assuming differentiation. For a thick enough graphite layer, diamonds would form at the bottom of this layer due to high pressures. We model the interior structure of Kepler-37b and show that a mere 10 wt% graphite layer would decrease its derived mass by 7%, suggesting future space missions that determine both radius and mass of rocky exoplanets with insignificant gaseous envelopes could provide quantitative limits on their carbon content. Future observations of rocky exoplanets with graphite-rich surfaces would show low albedos due to the low reflectance of graphite. The absence of life-bearing elements other than carbon on the surface likely makes them uninhabitable.

Theoretical models predict the condensation of silicon carbide around host stars with C/O ratios higher than 0.65 (cf. C/O$_{\mathrm{Sun}}$ = 0.54), in addition to its observations in meteorites, interstellar medium and protoplanetary disks. Consequently, the interiors of rocky exoplanets born from carbon-enriched refractory material are often assumed to contain large amounts of silicon carbide. Here we aim to investigate the stability of silicon carbide in the interior of carbon-enriched rocky exoplanets and to derive the reaction leading to its transformation. We performed a high-pressure high-temperature experiment to investigate the reaction between a silicon carbide layer and a layer representative of the bulk composition of a carbon-enriched rocky exoplanet. We report the reaction leading to oxidation of silicon carbide producing quartz, graphite, and molten iron silicide. Combined with previous studies, we show that in order to stabilize silicon carbide, carbon saturation is not sufficient, and a complete reduction of Fe$^{2+}$ to Fe$^{0}$ in a planetary mantle is required, suggesting that future spectroscopic detection of Fe$^{2+}$ or Fe$^{3+}$ on the surface of rocky exoplanets would imply the absence of silicon carbide in their interiors.

[Abridged] The aim of this work is to search for an absorption signal from exospheric sodium (Na) and singly ionized calcium (Ca$^+$) in the optical transmission spectrum of the hot rocky super-Earth 55 Cancri e. Although the current best-fitting models to the planet mass and radius require a possible atmospheric component, uncertainties in the radius exist, making it possible that 55 Cancri e could be a hot rocky planet without an atmosphere. High resolution (R$\sim$110000) time-series spectra of five transits of 55 Cancri e, obtained with three different telescopes (UVES/VLT, HARPS/ESO 3.6m & HARPS-N/TNG) were analysed. Targeting the sodium D lines and the calcium H and K lines, the potential planet exospheric signal was filtered out from the much stronger stellar and telluric signals, making use of the change of the radial component of the orbital velocity of the planet over the transit from -57 to +57 km/sec. Combining all five transit data sets, we detect a signal potentially associated with sodium in the planet exosphere at a statistical significance level of 3$\sigma$. Combining the four HARPS transits that cover the calcium H and K lines, we also find a potential signal from ionized calcium (4.1 $\sigma$). Interestingly, this latter signal originates from just one of the transit measurements - with a 4.9$\sigma$ detection at this epoch. Unfortunately, due to the low significance of the measured sodium signal and the potentially variable Ca$^+$ signal, we estimate the p-values of these signals to be too high (corresponding to <4$\sigma$) to claim unambiguous exospheric detections. By comparing the observed signals with artificial signals injected early in the analysis, the absorption by Na and Ca$^+$ are estimated to be at a level of approximately 2.3$\times 10^{-3}$ and 7.0$\times 10^{-2}$ respectively, relative to the stellar spectrum.

Recent high-precision measurements of the isotopic composition of lunar rocks demonstrate that the bulk silicate Earth and the Moon show an unexpectedly high degree of similarity. This is inconsistent with one of the primary results of classic dynamical simulations of the widely accepted giant impact model for the formation of the Moon, namely that most of the mass of the Moon originates from the impactor, not Earth. Resolution of this discrepancy without changing the main premises of the giant impact model requires total isotopic homogenisation of Earth and impactor material after the impact for a wide range of elements including O, Si, K, Ti, Nd and W. Even if this process could explain the O isotope similarity, it is unlikely to work for the much heavier, refractory elements. Given the increasing uncertainty surrounding the giant impact model in light of these geochemical data, alternative hypotheses for lunar formation should be explored. In this paper, we revisit the hypothesis that the Moon was formed directly from terrestrial mantle material. We show that the dynamics of this scenario requires a large amount of energy, almost instantaneously generated additional energy. The only known source for this additional energy is nuclear fission. We show that it is feasible to form the Moon through the ejection of terrestrial silicate material triggered by a nuclear explosion at Earths core-mantle boundary (CMB), causing a shock wave propagating through the Earth. Hydrodynamic modelling of this scenario shows that a shock wave created by rapidly expanding plasma resulting from the explosion disrupts and expels overlying mantle and crust material.

The formation, composition and physical properties of lunar dust are incompletely characterised with regard to human health. While the physical and chemical determinants of dust toxicity for materials such as asbestos, quartz, volcanic ashes and urban particulate matter have been the focus of substantial research efforts, lunar dust properties, and therefore lunar dust toxicity may differ substantially. In this contribution, past and ongoing work on dust toxicity is reviewed, and major knowledge gaps that prevent an accurate assessment of lunar dust toxicity are identified. Finally, a range of studies using ground-based, low-gravity, and in situ measurements is recommended to address the identified knowledge gaps. Because none of the curated lunar samples exist in a pristine state that preserves the surface reactive chemical aspects thought to be present on the lunar surface, studies using this material carry with them considerable uncertainty in terms of fidelity. As a consequence, in situ data on lunar dust properties will be required to provide ground truth for ground-based studies quantifying the toxicity of dust exposure and the associated health risks during future manned lunar missions.