Future soft X-ray (10 - 50 Angstrom) spectroscopy missions require higher effective areas and resolutions to perform critical science that cannot be done by instruments on current missions. An X-ray grating spectrometer employing off-plane reflection gratings would be capable of meeting these performance criteria. Off-plane gratings with blazed groove facets operated in the Littrow mounting can be used to achieve excellent throughput into orders achieving high resolutions. We have fabricated two off-plane gratings with blazed groove profiles via a technique which uses commonly available microfabrication processes, is easily scaled for mass production, and yields gratings customized for a given mission architecture. Both fabricated gratings were tested in the Littrow mounting at the Max-Planck-Institute for extraterrestrial Physics PANTER X-ray test facility to assess their performance. The line spread functions of diffracted orders were measured, and a maximum resolution of 800 $\pm$ 20 is reported. In addition, we also observe evidence of a `blaze' effect from measurements of relative efficiencies of the diffracted orders.

The Encircled Energy Fraction and its quantiles, notably the Half Energy Width, are routinely used to characterize the quality of X-ray optical systems. They are however always quoted without a statistical error. We show how non-parametric statistical methods can be used to redress this situation, and we discuss how the knowledge of the statistical error can be used to speed up the characterization efforts for future X-ray observatories.

An X-ray spectrograph consisting of radially ruled off-plane reflection gratings and silicon pore optics was tested at the Max Planck Institute for extraterrestrial Physics PANTER X-ray test facility. The silicon pore optic (SPO) stack used is a test module for the Arcus small explorer mission, which will also feature aligned off-plane reflection gratings. This test is the first time two off-plane gratings were actively aligned to each other and with a SPO to produce an overlapped spectrum. The gratings were aligned using an active alignment module which allows for the independent manipulation of subsequent gratings to a reference grating in three degrees of freedom using picomotor actuators which are controllable external to the test chamber. We report the line spread functions of the spectrograph and the actively aligned gratings, and plans for future development.

We describe an extension to the Geant4 software package that allows it to be used as a general purpose X-ray tracing package. We demonstrate its use by building a model of the X-ray optics of the XMM-Newton, calculating its effective area, and comparing the results with the published calibration curves.

We address the question of to what accuracy remote sensing images of the surface of planets can be matched, so that the possible displacement of features on the surface can be accurately measured. This is relevant in the context of the libration experiment aboard the European Space Agency's BepiColombo mission to Mercury. We focus here only on the algorithmic aspects of the problem, and disregard all other sources of error (spacecraft position, calibration uncertainties, etc.) that would have to be taken into account. We conclude that for a wide range of illumination conditions, translations between images can be recovered to about one tenth of a pixel r.m.s.

The EPIC pn CCD camera on board of XMM-Newton is designed to perform high throughput imaging and spectroscopy as well as high resolution timing observations in the energy range of 0.1-15 keV. A temporal resolution of milliseconds or microseconds, depending on the instrument mode and detector, is outstanding for CCD based X-ray cameras. In order to calibrate the different observing modes of the EPIC pn CCD, XMM-Newton observations of the pulsars PSR B1509-58, PSR B0540-69 and the Crab were performed during the calibration and performance verification phase. To determine the accuracy of the on board clock against Coordinated Universal Time (UTC), PSR B1509-58 was observed simultaneously with XMM-Newton and RXTE in addition. The paper summarizes the current status of the clock calibration.

The BL Lac object Mkn 501 was observed with the BeppoSAX satellite at three epochs in April-May 1998, simultaneously with the Whipple and HEGRA Cherenkov telescopes. The X-ray spectrum is well detected up to 70 keV and it exhibits, at all epochs, a continuous curvature, which is here modeled with three power-laws of increasingly steeper index at larger energies. In the nu*f_nu representation the spectrum exhibits a peak at ~20 keV, which is interpreted as the maximum of the synchrotron emission. This implies that the synchrotron peak energy has lowered by an order of magnitude with respect to the powerful X-ray outburst observed in April 1997. The simultaneous TeV flux was comparable to the lowest levels observed for Mkn 501, possibly suggesting that the peak of the inverse Compton radiation had also shifted toward lower energies.

The BL Lac object Mkn~421 was observed three times by the X-ray observatory BeppoSAX in consecutive days during 1997 April and May. The source was in a quiescent state, with an average 2-10 keV flux of 9.0 x 10^(-11) erg/cm/cm/s. Flux variation by a factor of ~2 on timescales as short as a few 10 ks were more pronounced in the hard (i.e. above ~3 keV) than in the soft X-rays. The broadband (0.1-40 keV) spectrum is concave and can be most easily explained with a power-law model which steepens gradually with energy. In this framework, neither photoabsorption edges nor resonant absorption lines are required, strengthening the case against the ubiquity of such features in BL Lac objects, which had been previously suggested by Einstein observations. The broadband spectrum hardens with hard X-ray flux, mostly due to a flattening above ~4 keV. This suggests that the relativistic highest energy electron distribution properties drive the X-ray spectral dynamics: either a stratification of the distribution in the jet with energy or inhomogeneities in the electron injection mechanism could be consistent with the observed variability pattern.

The BL Lac object Mkn 501, one of the only three extragalactic sources (with Mkn 421 and 1ES 2344+514) so far detected at TeV energies, was observed with the BeppoSAX satellite on 7, 11, and 16 April 1997 during a phase of high activity at TeV energies, as monitored with the Whipple, HEGRA and CAT Cherenkov telescopes. Over the whole 0.1-200 keV range the spectrum was exceptionally hard (alpha =< 1, with F_nu ~ nu^{-alpha}) indicating that the X-ray power output peaked at (or above) ~100 keV. This represents a shift of at least two orders of magnitude with respect to previous observations of Mkn 501, a behavior never seen before in this or any other blazar. The overall X-ray spectrum hardens with increasing intensity and, at each epoch, it is softer at larger energies. The correlated variability from soft X-rays to the TeV band points to models in which the same population of relativistic electrons produces the X-ray continuum via synchrotron radiation and the TeV emission by inverse Compton scattering of the synchrotron photons or other seed photons. For the first time in any blazar the synchrotron power is observed to peak at hard X-ray energies. The large shift of the synchrotron peak frequency with respect to previous observations of Mkn 501 implies that intrinsic changes in the relativistic electron spectrum caused the increase in emitted power. Due to the very high electron energies, the inverse Compton process is limited by the Klein-Nishina regime. This implies a quasi-linear (as opposed to quadratic) relation of the variability amplitude in the TeV and hard X-ray ranges (for the SSC model) and an increase of the inverse Compton peak frequency smaller than that of the synchrotron peak frequency.