The Gamma-ray BL Lac object OJ 287 is known to exhibit inner-parsec "jet-wobbling", high degrees of variability at all wavelengths and quasi-stationary features including an apparent (~100 deg) position angle change in projection on the sky plane. Sub-50 micro-arcsecond resolution 86 GHz observations with the global mm-VLBI array (GMVA) supplement ongoing multi-frequency VLBI blazar monitoring at lower frequencies. Using these maps together with cm/mm total intensity and Gamma-ray observations from Fermi/LAT from 2008-2014, we aimed to determine the location of Gamma-ray emission and to explain the inner-mas structural changes. Observations with the GMVA offer approximately double the angular resolution compared with 43 GHz VLBA observations and allow us to observe above the synchrotron self-absorption peak frequency. The jet was spectrally decomposed at multiple locations along the jet. From this we derived estimates of the magnetic field. How the field decreases down the jet allowed an estimate of the distance to the jet apex and an estimate of the magnetic field strength at the jet apex and in the broad line region. Combined with accurate kinematics we attempt to locate the site of Gamma-ray activity, radio flares and spectral changes. Strong Gamma-ray flares appeared to originate from either the "core" region, a downstream stationary feature, or both, with Gamma-ray activity significantly correlated with radio flaring in the downstream quasi-stationary feature. Magnetic field estimates were determined at multiple locations along the jet, with the magnetic field found to be >1.6 G in the "core" and >0.4 G in the downstream quasi-stationary feature. We therefore found upper limits on the location of the "core" as >6.0 pc from the jet apex and determined an upper limit on the magnetic field near the jet base of the order of thousands of Gauss.

Software spectrometer (SWSpec) developed for spacecraft tracking can be used to assure VLBI signal chain reliability, and phase stability of a VLBI receiver. Testing performed with SWSpec during pre-operations both saves time, and eases the tests as one does not need to gather, couple and setup the hardware.