The combination of high spatial and spectral resolution in optical astronomy enables new observational approaches to many open problems in stellar and circumstellar astrophysics. However, constructing a high-resolution spectrograph for an interferometer is a costly and time-intensive undertaking. Our aim is to show that, by coupling existing high-resolution spectrographs to existing interferometers, one could observe in the domain of high spectral and spatial resolution, and avoid the construction of a new complex and expensive instrument. We investigate in this article the different challenges which arise from combining an interferometer with a high-resolution spectrograph. The requirements for the different sub-systems are determined, with special attention given to the problems of fringe tracking and dispersion. A concept study for the combination of the VLTI (Very Large Telescope Interferometer) with UVES (UV-Visual Echelle Spectrograph) is carried out, and several other specific instrument pairings are discussed. We show that the proposed combination of an interferometer with a high-resolution spectrograph is indeed feasible with current technology, for a fraction of the cost of building a whole new spectrograph. The impact on the existing instruments and their ongoing programs would be minimal.

Numerical simulations of atmospheric turbulence and AO wavefront correction are performed to investigate the timescale for fringe motion in optical interferometers with spatial filters. These simulations focus especially on partial AO correction, where only a finite number of Zernike modes are compensated. The fringe motion is found to depend strongly on both the aperture diameter and the level of AO correction used. In all of the simulations the coherence timescale for interference fringes is found to decrease dramatically when the Strehl ratio provided by the AO correction is <~30%. For AO systems which give perfect compensation of a limited number of Zernike modes, the aperture size which gives the optimum signal for fringe phase tracking is calculated. For AO systems which provide noisy compensation of Zernike modes (but are perfectly piston-neutral), the noise properties of the AO system determine the coherence timescale of the fringes when the Strehl ratio is <~30%.

Through selection of short exposure images we achieve diffraction-limited I-band imaging from well-figured ground-based telescopes as large as 2.5 m diameter. The faint limiting magnitude and large isoplanatic patch size for the Lucky Exposures technique at the Nordic Optical Telescope means that 25% of the night sky is within range of a suitable reference star for I-band imaging. Typically the 1%--10% of exposures with the highest Strehl ratios are selected. When these exposures are shifted and added together, field stars in the resulting images have Strehl ratios as high as 0.26 and full width at half maximum flux (FWHM) as small as 90 milliarcseconds. Within the selected exposures the isoplanatic patch is found to be 60 arcseconds in diameter at 810 nm wavelength. Images within globular clusters and of multiple stars from the Nordic Optical Telescope using reference stars as faint as I~16 are presented. A new generation of CCDs (E2V L3Vision CCDs) were used in these observations, allowing extremely low noise high frame-rate imaging with both fine pixel sampling and a relatively wide field of view. The theoretical performance of these CCDs is compared with the experimental results obtained.

By selecting short exposure images taken using a CCD with negligible readout noise we obtained essentially diffraction-limited 810 nm images of faint objects using nearby reference stars brighter than I=16 at a 2.56 m telescope. The FWHM of the isoplanatic patch for the technique is found to be 50 arcseconds, providing ~20% sky coverage around suitable reference stars.

A quantitative assessment is presented of diffraction-limited stellar images with Strehl ratios of 0.25-0.30 obtained by selection of short-exposure CCD images of stars brighter than +6m at 810nm with the Nordic Optical Telescope.

A radically new CCD development by Marconi Applied Technologies has enabled substantial internal gain within the CCD before the signal reaches the output amplifier. With reasonably high gain, sub-electron readout noise levels are achieved even at MHz pixel rates. This paper reports a detailed assessment of these devices, including novel methods of measuring their properties when operated at peak mean signal levels well below one electron per pixel. The devices are shown to be photon shot noise limited at essentially all light levels below saturation. Even at the lowest signal levels the charge transfer efficiency is good. The conclusion is that these new devices have radically changed the balance in the perpetual trade-off between readout noise and the speed of readout. They will force a re-evaluation of camera technologies and imaging strategies to enable the maximum benefit to be gained from these high-speed, essentially noiseless readout devices. This new LLLCCD technology, in conjunction with thinning (backside illumination) should provide detectors which will be very close indeed to being theoretically perfect.