Results will be shown from the ASTRONEU array developed and operated in the outskirts of Patras, Greece. An array of 9 scintillator detectors and 3 antennas were deployed to study Extensive Air Showers (EAS) as a tool for calibrating an underwater neutrino telescope, possible other applications in muon tomography, education purposes, and last but not least, the detection of air showers via their electromagnetic signature. This is the first stage of a total of 24 scintillator counters and 6 RF antennas to complete the array. In this work, results with regard to the electromagnetic detection of showers will be shown. The method of operation and analysis will be presented. The purpose of this project was to demonstrate the adequacy of the method to detect cosmic events even in the presence of high urban electromagnetic background, using noise filters, timing, signal polarization, and eventual comparison with well understood event reconstruction using the scintillator detectors. The results indicate that cosmic showers were detected and the method can be used for the complete array.

In this document the simulation part of the Hellenic Open University Reconstruction & Simulation (HOURS) software package is described in detail. HOURS can be used for the generation, simulation, pattern recognition and reconstruction of high energy neutrino produced events in a very large volume neutrino telescope. The objective is to provide as accurate as possible a representation of event properties in a wide range of neutrino telescope configurations and medium optical properties. Moreover, HOURS contains software for the simulation and reconstruction of Extensive Air Showers (EAS) using the HEllenic LYceum Cosmic Observatories Network (HELYCON) scintillation counters. Using the information offered by the simulation/reconstruction of any EAS, and by considering the showers' energetic muons that penetrate the sea to the depth of the neutrino telescope, it is possible to study the joint performance of the neutrino and EAS detectors for physics or calibration purposes. HOURS has been used extensively for the optimization, development of calibration techniques and performance evaluation of the planned Mediterranean neutrino telescope, KM3NeT (km 3 Neutrino Telescope). The results of these studies have been published to various international scientific journals. The code and further information may be found on the HOURS web page: http://physicslab.eap.gr/EN/Simulation_software.html .

High-energy cosmic rays are one of the primary sources of information for scientists investigating the elementary properties of matter. The need to study cosmic rays, with energies thousands of times larger than those encountered in particle accelerators, led to the development of modern detection hardware and experimental methodologies. We present a low power, low complexity data acquisition (DAQ) system with 100 ps resolution, suitable for particle and radiation detection experiments. The system uses a Multiple-Time-over-Threshold (MToT) technique for the treatment of the output signal of Photo Multiplier Tubes (PMTs). The use of three thresholds compensates for the slewing effects and offers a more accurate measurement of the PMT pulses' width. For the evaluation of the pulse the system uses comparators and a Time-to-Digital (TDC) converter, whereas the pulses are time-stamped using the GPS signal. The prototype card is analyzed for its noise behavior and is tested to verify its performance. The system has been designed for the HEllenic LYceum Cosmic Observatories Network (HELYCON) Extensive Air Showers (EAS) detector.

The main objectives of the KM3NeT Collaboration are i) the discovery and subsequent observation of high-energy neutrino sources in the Universe and ii) the determination of the mass hierarchy of neutrinos. These objectives are strongly motivated by two recent important discoveries, namely: 1) The high-energy astrophysical neutrino signal reported by IceCube and 2) the sizable contribution of electron neutrinos to the third neutrino mass eigenstate as reported by Daya Bay, Reno and others. To meet these objectives, the KM3NeT Collaboration plans to build a new Research Infrastructure consisting of a network of deep-sea neutrino telescopes in the Mediterranean Sea. A phased and distributed implementation is pursued which maximises the access to regional funds, the availability of human resources and the synergetic opportunities for the earth and sea sciences community. Three suitable deep-sea sites are identified, namely off-shore Toulon (France), Capo Passero (Italy) and Pylos (Greece). The infrastructure will consist of three so-called building blocks. A building block comprises 115 strings, each string comprises 18 optical modules and each optical module comprises 31 photo-multiplier tubes. Each building block thus constitutes a 3-dimensional array of photo sensors that can be used to detect the Cherenkov light produced by relativistic particles emerging from neutrino interactions. Two building blocks will be configured to fully explore the IceCube signal with different methodology, improved resolution and complementary field of view, including the Galactic plane. One building block will be configured to precisely measure atmospheric neutrino oscillations.

A prototype detection unit of the KM3NeT deep-sea neutrino telescope has been installed at 3500m depth 80km offshore the Italian coast. KM3NeT in its final configuration will contain several hundreds of detection units. Each detection unit is a mechanical structure anchored to the sea floor, held vertical by a submerged buoy and supporting optical modules for the detection of Cherenkov light emitted by charged secondary particles emerging from neutrino interactions. This prototype string implements three optical modules with 31 photomultiplier tubes each. These optical modules were developed by the KM3NeT Collaboration to enhance the detection capability of neutrino interactions. The prototype detection unit was operated since its deployment in May 2014 until its decommissioning in July 2015. Reconstruction of the particle trajectories from the data requires a nanosecond accuracy in the time calibration. A procedure for relative time calibration of the photomultiplier tubes contained in each optical module is described. This procedure is based on the measured coincidences produced in the sea by the 40K background light and can easily be expanded to a detector with several thousands of optical modules. The time offsets between the different optical modules are obtained using LED nanobeacons mounted inside them. A set of data corresponding to 600 hours of livetime was analysed. The results show good agreement with Monte Carlo simulations of the expected optical background and the signal from atmospheric muons. An almost background-free sample of muons was selected by filtering the time correlated signals on all the three optical modules. The zenith angle of the selected muons was reconstructed with a precision of about 3{\deg}.

The first prototype of a photo-detection unit of the future KM3NeT neutrino telescope has been deployed in the deep waters of the Mediterranean Sea. This digital optical module has a novel design with a very large photocathode area segmented by the use of 31 three inch photomultiplier tubes. It has been integrated in the ANTARES detector for in-situ testing and validation. This paper reports on the first months of data taking and rate measurements. The analysis results highlight the capabilities of the new module design in terms of background suppression and signal recognition. The directionality of the optical module enables the recognition of multiple Cherenkov photons from the same $^{40}$K decay and the localization bioluminescent activity in the neighbourhood. The single unit can cleanly identify atmospheric muons and provide sensitivity to the muon arrival directions.

We report on the development of search methods for point-like and extended neutrino sources, utilizing the tracking and energy estimation capabilities of an underwater, Very Large Volume Neutrino Telescope (VLVnT). We demonstrate that the developed techniques offer a significant improvement on the telescope's discovery potential. We also present results on the potential of the Mediterranean KM3NeT to discover galactic neutrino sources.

We study the potential of a very large volume underwater Mediterranean neutrino telescope to observe neutrinos from supernova (SN) explosions within our galaxy. The intense neutrino burst emitted in a SN explosion results in a large number of MeV neutrinos inside the instrumented volume of the neutrino telescope that can be detected (mainly) via the reaction \nu_e-bar + p -> e^+ + n . In this study we simulated the response of the underwater neutrino telescope to the electron antineutrino flux predicted by the Garching model for SN explosions. We assumed that the neutrino telescope comprises 6160 direction sensitive optical modules, each containing 31 small photomultiplier tubes. Multiple coincidences between the photomultiplier tubes of the same optical module are utilized to suppress the noise produced by $^{40}K$ radioactive decays and to establish a statistical significant signature of the SN explosion.

Gamma ray earthbound and satellite experiments have discovered, over the last years, many galactic and extra-galactic gamma ray sources. The detection of astrophysical neutrinos emitted by the same sources would imply that these astrophysical objects are charged cosmic ray accelerators and help to resolve the enigma of the origin of cosmic rays. A very large volume neutrino telescope might be able to detect these potential neutrino emitters. The apriori known direction of the neutrino source can be used to effectively suppress the $^{40}K$ optical background and increase significantly the tracking efficiency through causality filters. We report on advancing filtering and prefit techniques using the known neutrino source direction and first results are presented.

We report on the evaluation of the performance of a Mediterranean very large volume neutrino telescope. We present results of our studies concerning the capability of the telescope in detecting/discovering galactic (steady point sources) and extragalactic, transient (Gamma Ray Bursts) high energy neutrino sources as well as measuring ultra high energy diffuse neutrino fluxes. The neutrino effective area and angular resolution are presented as a function of the neutrino energy, and the background event rate (atmospheric neutrinos and muons) is estimated. The discovery potential of the neutrino telescope is evaluated and the experimental time required for a significant discovery of potential neutrino emitters (known from their gamma ray emission, assumedly produced by hadronic interactions) is estimated. For the simulation we use the HOU Reconstruction & Simulation (HOURS) software package.

We propose the operation of floating Extensive Air Shower (EAS) detector stations in coincidence with the KM3NeT Mediterranean deep-sea neutrino telescope to determine the absolute position and orientation of the underwater detector and to investigate possible systematic angular errors. We evaluate the accuracy of the proposed calibration strategies using a detailed simulation of the EAS and KM3NeT detectors.

We report on a simulation study of the calibration potential offered by floating Extensive Air Shower (EAS) detector stations (HELYCON), operating in coincidence with the KM3NeT Mediterranean deep-sea neutrino telescope. We describe strategies in order to investigate for possible systematic errors in reconstructing the direction of energetic muons as well as to determine the absolute position of the underwater detector.