sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Titus, T. N.

Normalized to: Titus, T.

5 article(s) in total. 42 co-authors, from 1 to 3 common article(s). Median position in authors list is 5,0.

[1]  oai:arXiv.org:2003.11045  [pdf] - 2089172
Disk-Integrated Thermal Properties of Ceres Measured at Millimeter Wavelengths
Comments: 21 pages, 4 figures, 3 tables
Submitted: 2020-03-24
We observed Ceres at three epochs in 2015 November and 2017 September and October with ALMA 12-meter array and in 2017 October with the ALMA Compact Array (ACA), all at ~265 GHz continuum (wavelengths of ~1.1 mm) to map the temperatures of Ceres over a full rotation at each epoch. We also used 2017 October ACA observations to search for HCN. The disk-averaged brightness temperature of Ceres is measured to be between 170 K and 180 K during our 2017 observations. The rotational lightcurve of Ceres shows a double peaked shape with an amplitude of about 4%. Our HCN search returns a negative result with an upper limit production rate of ~2$\times$10$^{24}$ molecules s$^{-1}$, assuming globally uniform production and a Haser model. A thermophysical model suggests that Ceres's top layer has higher dielectric absorption than lunar-like materials at a wavelength of 1 mm. However, previous observations showed that the dielectric absorption of Ceres decreases towards longer wavelengths. Such distinct dielectric properties might be related to the hydrated phyllosilicate composition of Ceres and possibly abundant $\mu$m-sized grains on its surface. The thermal inertia of Ceres is constrained by our modeling as likely being between 40 and 160 tiu, much higher than previous measurements at infrared wavelengths. Modeling also suggests that Ceres's lightcurve is likely dominated by spatial variations in its physical or compositional properties that cause changes in Ceres's observed thermal properties and dielectric absorption as it rotates.
[2]  oai:arXiv.org:1612.07147  [pdf] - 1533726
Detection and Quantification of Volatiles at Mars using a multispectral LIDAR
Comments: 9 pages, 3 figures
Submitted: 2016-12-21
We present a concept for using a polarization sensitive multispectral lidar to map the seasonal distribution and exchange of volatiles among the reservoirs of the Martian surface and atmosphere. The LIDAR instrument will be a multi-wavelength, altitude-resolved, active near-infrared (NIR, with 10 bands around 1.6 microns) instrument to measure the reflected intensity and polarization of backscattered radiation from planetary surfaces and atmospheres. The proposed instrument would be ideally suited for a mission to Mars to comprehensively investigate the nature and seasonal distributions of volatiles and aerosols. The investigation would include the abundance of atmospheric dust and condensed volatiles, surface and cloud/aerosol grain sizes and shapes, ice and dust particle microphysics and also variations in atmospheric chemistry during multiple overflight local times throughout polar night and day. Such an instrument would be ideal for mapping and detection of recently detected CO2 frost phenomena and H2O and CO2 precipitation events in the polar regions of Mars. Herein we discuss the applicability of this instrument to detect and map sublimation/deposition 'mode flips' recently discovered by Brown et al. (2016) using the CRISM passive infrared sensor on Mars Reconnaissance Orbiter.
[3]  oai:arXiv.org:1407.0111  [pdf] - 1215321
Interannual observations and quantification of summertime H2O ice deposition on the Martian CO2 ice south polar cap
Comments: 35 pages, 5 figures, 2 tables and supplementary information of 2 tables
Submitted: 2014-07-01
The spectral signature of water ice was observed on Martian south polar cap in 2004 by the Observatoire pour l'Mineralogie, l'Eau les Glaces et l'Activite (OMEGA) (Bibring et al., 2004). Three years later, the OMEGA instrument was used to discover water ice deposited during southern summer on the polar cap (Langevin et al., 2007). However, temporal and spatial variations of these water ice signatures have remained unexplored, and the origins of these water deposits remains an important scientific question. To investigate this question, we have used observations from the Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) instrument on the Mars Reconnaissance Orbiter (MRO) spacecraft of the southern cap during austral summer over four Martian years to search for variations in the amount of water ice. We report below that for each year we have observed the cap, the magnitude of the H2O ice signature on the southern cap has risen steadily throughout summer, particularly on the west end of the cap. The spatial extent of deposition is in disagreement with the current best simulations of deposition of water ice on the south polar cap (Montmessin et al., 2007). This increase in water ice signatures is most likely caused by deposition of atmospheric H2O ice and a set of unusual conditions makes the quantification of this transport flux using CRISM close to ideal. We calculate a 'minimum apparent' amount of deposition corresponding to a thin H2O ice layer of 0.2mm (with 70 percent porosity). This amount of H2O ice deposition is 0.6-6 percent of the total Martian atmospheric water budget. We compare our 'minimal apparent' quantification with previous estimates. This deposition process may also have implications for the formation and stability of the southern CO2 ice cap, and therefore play a significant role in the climate budget of modern day Mars.
[4]  oai:arXiv.org:1406.0030  [pdf] - 1323332
The science case for a modern, multi-wavelength, polarization-sensitive LIDAR in orbit around Mars
Comments: 25 pages, 6 figures, 4 tables
Submitted: 2014-05-30
We present the scientific case to build a multiple-wavelength, active, near-infrared (NIR) instrument to measure the reflected intensity and polarization characteristics of backscattered radiation from planetary surfaces and atmospheres. We focus on the ability of such an instrument to enhance, perhaps revolutionize, our understanding of climate, volatiles and astrobiological potential of modern-day Mars.
[5]  oai:arXiv.org:0903.3687  [pdf] - 22598
MRO/CRISM Retrieval of Surface Lambert Albedos for Multispectral Mapping of Mars with DISORT-based Rad. Transfer Modeling: Phase 1 - Using Historical Climatology for Temperatures, Aerosol Opacities, & Atmo. Pressures
Comments:
Submitted: 2009-03-21
We discuss the DISORT-based radiative transfer pipeline ('CRISM_LambertAlb') for atmospheric and thermal correction of MRO/CRISM data acquired in multispectral mapping mode (~200 m/pixel, 72 spectral channels). Currently, in this phase-one version of the system, we use aerosol optical depths, surface temperatures, and lower-atmospheric temperatures, all from climatology derived from Mars Global Surveyor Thermal Emission Spectrometer (MGS-TES) data, and surface altimetry derived from MGS Mars Orbiter Laser Altimeter (MOLA). The DISORT-based model takes as input the dust and ice aerosol optical depths (scaled to the CRISM wavelength range), the surface pressures (computed from MOLA altimetry, MGS-TES lower-atmospheric thermometry, and Viking-based pressure climatology), the surface temperatures, the reconstructed instrumental photometric angles, and the measured I/F spectrum, and then outputs a Lambertian albedo spectrum. The Lambertian albedo spectrum is valuable geologically since it allows the mineralogical composition to be estimated. Here, I/F is defined as the ratio of the radiance measured by CRISM to the solar irradiance at Mars divided by $\pi$. After discussing the capabilities and limitations of the pipeline software system, we demonstrate its application on several multispectral data cubes: the outer northern ice cap of Mars, Tyrrhena Terra, and near the landing site for the Phoenix mission. For the icy spectra near the northern polar cap, aerosols need to be included in order to properly correct for the CO_2 absorption in the H_{2}O ice bands at wavelengths near 2.0 $\mu$m. In future phases of software development, we intend to use CRISM data directly in order to retrieve the spatiotemporal maps of aerosol optical depths, surface pressure and surface temperature.