New radio (MeerKAT and Parkes) and X-ray (XMM-Newton, Swift, Chandra, and NuSTAR) observations of PSR J1622-4950 indicate that the magnetar, in a quiescent state since at least early 2015, reactivated between 2017 March 19 and April 5. The radio flux density, while variable, is approximately 100x larger than during its dormant state. The X-ray flux one month after reactivation was at least 800x larger than during quiescence, and has been decaying exponentially on a 111+/-19 day timescale. This high-flux state, together with a radio-derived rotational ephemeris, enabled for the first time the detection of X-ray pulsations for this magnetar. At 5%, the 0.3-6 keV pulsed fraction is comparable to the smallest observed for magnetars. The overall pulsar geometry inferred from polarized radio emission appears to be broadly consistent with that determined 6-8 years earlier. However, rotating vector model fits suggest that we are now seeing radio emission from a different location in the magnetosphere than previously. This indicates a novel way in which radio emission from magnetars can differ from that of ordinary pulsars. The torque on the neutron star is varying rapidly and unsteadily, as is common for magnetars following outburst, having changed by a factor of 7 within six months of reactivation.

The African Very Long Baseline Interferometry Network (AVN) is a pan-African project that will develop Very Long Baseline Interferometry (VLBI) observing capability in several countries across the African continent, either by conversion of existing telecommunications antennas into radio telescopes, or by building new ones. This paper focuses on the conversion of the Nkutunse satellite communication station (near Accra, Ghana), specifically the early mechanical and infrastructure upgrades, together with the development of a custom ambient receiver and digital backend. The paper concludes with what remains to be done, before the station can be commissioned as an operational VLBI station.

The construction of the KAT-7 array in the Karoo region of the Northern Cape in South Africa was intended primarily as an engineering prototype for technologies and techniques applicable to the MeerKAT telescope. This paper looks at the main engineering and scien- tific highlights from this effort, and discusses their applicability to both MeerKAT and other next-generation radio telescopes. In particular we found that the composite dish surface works well, but it becomes complicated to fabricate for a dish lacking circular symmetry; the Stir- ling cycle cryogenic system with ion pump to achieve vacuum works but demands much higher maintenance than an equivalent Gifford-McMahon cycle system; the ROACH (Recon- figurable Open Architecture Computing Hardware)-based correlator with SPEAD (Stream- ing Protocol for Exchanging Astronomical Data) protocol data transfer works very well and KATCP (Karoo Array Telescope Control Protocol) control protocol has proven very flexible and convenient. KAT-7 has also been used for scientific observations where it has a niche in mapping low surface-brightness continuum sources, some extended HI halos and OH masers in star-forming regions. It can also be used to monitor continuum source variability, observe pulsars, and make VLBI observations

The Mozambique Radio Astronomy Observatory (MRAO) will be a first milestone towards development of radioastronomy in Mozambique. Development of MRAO will constitute a preparation step towards participation in the upcoming Africa VLBI Network and the Square Kilometer Array project. The MRAO first antenna is planned to serve as a capacitation and training facility and will be installed after the conversion of a 7-meter telecom dish in South Africa. Therefore, this first radiotelescope design has to comply with local spectral and environmental constraints. Furthermore, power availability and long term sustainability with potential inclusion of solar power and control of Radio Frequency Interference are analyzed. Here we outline some of the design, environmental and power sustainability constraints.