In the magnetically torqued disk (MTD) model for hot star disks, as proposed and formulated by \citet{cassi02}, stellar wind mass loss was taken to be uniform over the stellar surface. Here account is taken of the fact that as stellar spin rate S_o (=\sqrt {\Omega_o^2 R^3/GM}) is increased, and the stellar equator is gravity darkened, the equatorial mass flux and terminal speed are reduced, compared to the poles, for a given total \mdot. As a result, the distribution of equatorial disk density, determined by the impact of north and southbound flows, is shifted further out from the star. This results, for high S_o (\gtrsim 0.5), in a fall in the disk mass and emission measure, and hence in the observed emission line EW, scattering polarization, and IR emission. Consequently, contrary to expectations, critical rotation S_o \to 1 is not the optimum for creation of hot star disks which, in terms of EM for example, is found to occur in a broad peak around S_o\approx 0.5-0.6 depending slightly on the wind velocity law. The relationship of this analytic quasi-steady parametric MTD model to other work on magnetically guided winds is discussed. In particular the failures of the MTD model for Be-star disks alleged by \citet{owo03} are shown to revolve largely around open observational tests, rather in the basic MTD physics, and around their use of insufficiently strong fields.

Despite extensive study, the mechanisms by which Be star disks acquire high densities and angular momentum while displaying variability on many time scales are still far from clear. In this paper, we discuss how magnetic torquing may help explain disk formation with the observed quasi-Keplerian (as opposed to expanding) velocity structure and their variability. We focus on the effects of the rapid rotation of Be stars, considering the regime where centrifugal forces provide the dominant radial support of the disk material. Using a kinematic description of the angular velocity, vphi(r), in the disk and a parametric model of an aligned field with a strength B(r) we develop analytic expressions for the disk properties that allow us to estimate the stellar surface field strength necessary to create such a disk for a range of stars on the main-sequence. The model explains why disks are most common for main-sequence stars at about spectral class B2 V. The earlier type stars with very fast and high density winds would require unacceptably strong surface fields (> 10^3 Gauss) to form torqued disks, while the late B stars (with their low mass loss rates) tend to form disks that produce only small fluxes in the dominant Be diagnostics. For stars at B2 V the average surface field required is about 300 Gauss. The predicted disks provide an intrinsic polarization and a flux at Halpha comparable to observations. We also discuss whether the effect on field containment of the time dependent accumulation of matter in the flux tubes/disk can help explain some of the observed variability of Be star disks.