The heating of the real polar cap surface of radio pulsars by the bombardment of ultra-relativistic charges is studied. The real polar cap is a significantly smaller area within or close by the conventional polar cap which is encircled by the last open field lines of the dipolar field $\vec{B}_d$. It is surrounded by those field lines of the small scale local surface field $\vec{B}_s$ that join the last open field lines of $\vec{B}_d$ in a height of $\sim 10^5$ cm above the cap. As the ratio of radii of the conventional and real polar cap $R_{dip}/R_{pc}\sim 10$, flux conservation requires $B_s/B_d\sim 100$. For rotational periods $P\sim 0.5$ s, $B_s\sim 10^{14}$ G creates a strong electric potential gap that forms the inner accelerating region (IAR) in which charges gain kinetic energies $\sim 3\times 10^{14}$ eV. This sets an upper limit for the energy that back flowing charges can release as heat in the surface layers of the real polar cap. Within the IAR, which is flown through with a dense stream of extremely energetic charges, no stable atmosphere of hydrogen can survive. Therefore, we consider the polar cap as a solidified "naked" surface consisting of fully ionized iron ions. We discuss the physical situation at the real polar cap, calculate its surface temperatures $T_s$ as functions of $B_s$ and $P$, and compare the results with X-ray observations of radio pulsars.

We study a slightly rotating accretion flow onto a black hole, using the fully three dimensional (3-D)numerical simulations. We consider hydrodynamics of an inviscid flow, assuming a spherically symmetric density distribution at the outer boundary and a small, latitude-dependent angular momentum. We investigate the role of the adiabatic index and gas temperature, and the flow behaviour due to non-axisymmetric effects. Our 3-D simulations confirm axisymmetric results: the material that has too much angular momentum to be accreted forms a thick torus near the equator and the mass accretion rate is lower than the Bondi rate. In our previous study of the 3-D accretion flows, for gamma=5/3, we found that the inner torus precessed, even for axisymmetric conditions at large radii. The present study shows that the inner torus precesses also for other values of the adiabatic index: gamma=4/3, 1.2 and 1.01. However, the time for the precession to set increases with decreasing gamma. In particular, for gamma=1.01 we find that depending on the outer boundary conditions, the torus may shrink substantially due to the strong inflow of the non-rotating matter and the precession will have insufficient time to develop. On the other hand, if the torus is supplied by the continuous inflow of the rotating material from the outer radii, its inner parts will eventually tilt and precess, as it was for the larger gamma's.