Birefringence in ionized, magnetized media is usually measured as Faraday rotation of linearly polarized radiation. However, pulses propagating through regions with very large Faraday rotation measures (RMs) can split into circularly polarized components with measurable differences in arrival times $\propto \nu^{-3}\, \rm RM$, where $\nu$ is the radio frequency. Differential refraction from gradients in DM (dispersion measure) and RM can contribute a splitting time $\propto \vert \mathbf{\nabla_{\perp}} \rm DM \vert \vert \mathbf{\nabla_{\perp}}\rm RM \vert\,\nu^{-5}$. Regardless of whether the emitted pulse is unpolarized or linearly polarized, net circular polarization will be measured when splitting is a significant fraction of the pulse width. However, the initial polarization may be inferable from the noise statistics of the bursts. Extreme multipath scattering that broadens pulses can mask splitting effects. We discuss particular cases such as the Galactic center magnetar, J1749$-$2900, and the repeating fast radio burst source, FRB 121102. Both lines of sight have $\rm RM \sim 10^5~\rm rad~m^{-2}$ that yields millisecond splittings at frequencies well below $\sim 1 \text{ GHz}$. We also consider the splitting of nanosecond shot pulses in giant pulses from the Crab pulsar and the minimal effects of birefringence on precision pulsar timing. Finally, we explore the utility of two-dimensional coherent dedispersion with DM and RM as parameters.

Low radio frequency solar observations using the Murchison Widefield Array have recently revealed the presence of numerous weak, short-lived and narrow-band emission features, even during moderately quiet solar conditions. These non-thermal features occur at rates of many thousands per hour in the 30.72 MHz observing bandwidth, and hence, necessarily require an automated approach for their detection and characterization. Here, we employ continuous wavelet transform using a mother Ricker wavelet for feature detection from the dynamic spectrum. We establish the efficacy of this approach and present the first statistically robust characterization of the properties of these features. In particular, we examine distributions of their peak flux densities, spectral spans, temporal spans and peak frequencies. We can reliably detect features weaker than 1 SFU, making them, to the best of our knowledge, the weakest bursts reported in literature. The distribution of their peak flux densities follows a power law with an index of -2.23 in the 12-155 SFU range, implying that they can provide an energetically significant contribution to coronal and chromospheric heating. These features typically last for 1-2 seconds and possess bandwidths of about 4-5 MHz. Their occurrence rate remains fairly flat in the 140-210 MHz frequency range. At the time resolution of the data, they appear as stationary bursts, exhibiting no perceptible frequency drift. These features also appear to ride on a broadband background continuum, hinting at the likelihood of them being weak type-I bursts.

We describe the development and implementation of a light-weight, fully autonomous 2-axis pointing and stabilization system designed for balloon-borne astronomical payloads. The system is developed using off-the-shelf components such as Arduino Uno controller, HMC 5883L magnetometer, MPU-9150 Inertial Measurement Unit (IMU) and iWave GPS receiver unit. It is a compact and rugged system which can also be used to take images/video in a moving vehicle, or in areal photography. The system performance is evaluated from the ground, as well as in conditions simulated to imitate the actual flight by using a tethered launch.

We describe the characterization and removal of noise present in the Inertial Measurement Unit (IMU) MPU-6050. This IMU was initially used in an attitude sensor (AS) developed in-house, and subsequently implemented in a pointing and stabilization platform developed for small balloon-borne astronomical payloads. We found that the performance of the IMU degrades with time due to the accumulation of different errors. Using the Allan variance analysis method, we identified the different components of noise present in the IMU and verified the results using a power spectral density analysis (PSD). We tried to remove the high-frequency noise using smoothing filters, such as moving average filter and Savitzky-Golay filter. Although we did manage to filter some of the high-frequency noise, the performance of these filters was not satisfactory for our application. We found the distribution of the random noise present in the IMU using a probability density analysis, and identified the noise to be white Gaussian in nature which we successfully removed by a Kalman filter in real time.

We present a catalog of low-mass dense cores observed with the SHARC-II instrument at 350 microns. Our observations have an effective angular resolution of 10", approximately 2.5 times higher than observations at the same wavelength obtained with the Herschel Space Observatory, albeit with lower sensitivity, especially to extended emission. The catalog includes 81 maps covering a total of 164 detected sources. For each detected source, we tabulate basic source properties including position, peak intensity, flux density in fixed apertures, and radius. We examine the uncertainties in the pointing model applied to all SHARC-II data and conservatively find that the model corrections are good to within ~3", approximately 1/3 of the SHARC-II beam. We examine the differences between two array scan modes and find that the instrument calibration, beam size, and beam shape are similar between the two modes. We also show that the same flux densities are measured when sources are observed in the two different modes, indicating that there are no systematic effects introduced into our catalog by utilizing two different scan patterns during the course of taking observations. We find a detection rate of 95% for protostellar cores but only 45% for starless cores, and demonstrate the existence of a SHARC-II detection bias against all but the most massive and compact starless cores. Finally, we discuss the improvements in protostellar classification enabled by these 350 micron observations.