The present study aims to provide a diagnostic line ratio that will enable the observer to determine whether a plasma is in a state of transient ionization. We use the Atomic Data and Analysis Structure (ADAS) to calculate line contribution functions for two lines, Si IV 1394 A and O IV 1401 A, formed in the solar transition region. The generalized collisional-radiative theory is used. It includes all radiative and electron collisional processes, except for photon-induced processes. State-resolved direct ionization and recombination to and from the next ionization stage are also taken into account. For dynamic bursts with a decay time of a few seconds, the Si IV 1394 A line can be enhanced by a factor of 2-4 in the first fraction of a second with the peak in the line contribution function occurring initially at a higher electron temperature due to transient ionization compared to ionization equilibrium conditions. On the other hand, the O IV 1401 A does not show such any enhancement. Thus the ratio of these two lines, which can be observed with the Interface Region Imaging Spectrograph, can be used as a diagnostic of transient ionization. We show that simultaneous high-cadence observations of two lines formed in the solar transition region may be used as a direct diagnostic of whether the observed plasma is in transient ionization. The ratio of these two lines can change by a factor of four in a few seconds owing to transient ionization alone.

We discuss the diagnostic potential of high cadence ultraviolet spectral data when transient ionization is considered. For this we use high cadence UV spectra taken during the impulsive phase of a solar flares (observed with instruments on-board the Solar Maximum Mission) which showed excellent correspondence with hard X-ray pulses. The ionization fraction of the transition region ion O V and in particular the contribution function for the O V 1371A line are computed within the Atomic Data and Analysis Structure, which is a collection of fundamental and derived atomic data and codes which manipulate them. Due to transient ionization, the O V 1371A line is enhanced in the first fraction of a second with the peak in the line contribution function occurring initially at a higher electron temperature than in ionization equilibrium. The rise time and enhancement factor depend mostly on the electron density. The fractional increase in the O V 1371A emissivity due to transient ionization can reach a factor of 2--4 and can explain the fast response in the line flux of transition regions ions during the impulsive phase of flares solely as a result of transient ionization. This technique can be used to diagnostic the electron temperature and density of solar flares observed with the forth-coming Interface Region Imaging Spectrograph.

Comparison of appropriate theoretical derived line ratios with observational data can yield estimates of a plasma's physical parameters, such as electron density or temperature. The usual practice in the calculation of the line ratio is the assumption of excitation by electrons/protons followed by radiative decay. Furthermore, it is normal to use the so-called coronal approximation, i.e. one only considers ionization and recombination to and from the ground state. A more accurate treatment is to include the ionization/recombination to and from meta-stable levels. Here, we apply this to two lines from adjacent ionization stages; Mg IX 368A and Mg X 625A, which has been shown to be a very useful temperature diagnostic. At densities typical of coronal hole conditions, the difference between the electron temperature derived assuming the zero density limit compared with the electron density dependent ionization/recombination is small. This however is not the case for flares where the electron density is orders of magnitude larger. The derived temperature for the coronal hole at solar maximum is around 1.04 MK compared to just below 0.82 MK at solar minimum.

The paper presents an integrated view of the population structure and its role in establishing the ionisation state of light elements in dynamic, finite density, laboratory and astrophysical plasmas. There are four main issues, the generalised collisional-radiative picture for metastables in dynamic plasmas with Maxwellian free electrons and its particularising to light elements, the methods of bundling and projection for manipulating the population equations, the systematic production/use of state selective fundamental collision data in the metastable resolved picture to all levels for collisonal-radiative modelling and the delivery of appropriate derived coefficients for experiment analysis. The ions of carbon, oxygen and neon are used in illustration. The practical implementation of the methods described here is part of the ADAS Project.

A programme is outlined for the assembly of a comprehensive dielectronic recombination database within the generalized collisional--radiative (GCR) framework. It is valid for modelling ions of elements in dynamic finite-density plasmas such as occur in transient astrophysical plasmas such as solar flares and in the divertors and high transport regions of magnetic fusion devices. The resolution and precision of the data are tuned to spectral analysis and so are sufficient for prediction of the dielectronic recombination contributions to individual spectral line emissivities. The fundamental data are structured according to the format prescriptions of the Atomic Data and Analysis Structure (ADAS) and the production of relevant GCR derived data for application is described and implemented following ADAS. The requirements on the dielectronic recombination database are reviewed and the new data are placed in context and evaluated with respect to older and more approximate treatments. Illustrative results validate the new high-resolution zero-density dielectronic recombination data in comparison with measurements made in heavy-ion storage rings utilizing an electron cooler. We also exemplify the role of the dielectronic data on GCR coefficient behaviour for some representative light and medium weight elements.