In photometry, the short-timescale stellar variability ("flicker"), such as that caused by granulation and oscillations, can reach amplitudes comparable to the transit depth of Earth-sized planets and is correlated over the typical transit timescales. It can introduce systematic errors on the inferred planetary parameters when a small number of transits are observed. The objective of this paper is to characterize the statistical properties of this noise and quantify its impact on the inferred transit parameters. We used the extensive solar observations obtained with SoHO/VIRGO to characterize flicker noise. We simulated realistic transits across the solar disk using SDO/HMI data and used these to obtain transit light curves, which we used to estimate the errors made on the transit parameters. We make these light curves publicly available. To extend the study to a wider parameter range, we derived the properties of flicker noise using Kepler observations and studied their dependence on stellar parameters. Finally, we predicted the limiting stellar apparent magnitude for which the properties of the flicker noise can be extracted using high-precision CHEOPS and PLATO observations. Stellar granulation is a stochastic colored noise, and is stationary with respect to the stellar magnetic cycle. Both the flicker correlation timescales and amplitudes increase with the stellar mass and radius. If these correlations are not taken into account when fitting for the parameters of transiting exoplanets, this can bias the inferred parameters. In particular, we find errors of up to 10$\%$ on $R_p/R_s$ for an Earth-sized planet orbiting a Sun-like star. For F and G stars, flicker will significantly affect the inferred parameters of transits observed with CHEOPS and PLATO. Dedicated modeling strategies need to be developed to accurately characterize both the star and the transiting exoplanets.

Proportional electroluminescence (EL) in noble gases is used in two-phase detectors for dark matter search to record (in the gas phase) the ionization signal induced by particle scattering in the liquid phase. The "standard" EL mechanism is considered to be due to noble gas excimer emission in the vacuum ultraviolet (VUV). In addition to it, there are two alternative mechanisms, producing light in the visible and near infrared (NIR) range. The first is due to bremsstrahlung of electrons scattered on neutral atoms (so-called neutral bremsstrahlung, NBrS). The second, responsible for electron avalanche scintillations in the NIR at higher electric fields, is due to transitions between excited atomic states. In this work, we have for the first time demonstrated two alternative techniques of the optical readout of two-phase argon detectors, in the visible and NIR range, using a SiPM matrix and electroluminescence due to either neutral bremsstrahlung or avalanche scintillations effects. The amplitude yield and position resolution were measured for these readout techniques, which allowed to assess the detection threshold for electron and nuclear recoils in two-phase argon detectors for dark matter search. It should be emphasized that this is the first practical application of the NBrS effect in detection science.

Convective motions at the stellar surface generate a stochastic colored noise source in the radial velocity (RV) data. This noise impedes the detection of small exoplanets. Moreover, the unknown statistics (amplitude, distribution) related to this noise make it difficult to estimate the false alarm probability (FAP) for exoplanet detection tests. In this paper, we investigate the possibility of using 3D magneto-hydrodynamical simulations (MHD) of stellar convection to design detection methods that can provide both a reliable estimate of the FAP and a high detection power. We tested the realism of 3D simulations in producing solar RV by comparing them with the observed disk integrated velocities taken by the GOLF instrument on board the SOHO spacecraft. We presented a new detection method based on periodograms standardized by these simulated time series, applying several detection tests to these standarized periodograms. The power spectral density of the 3D synthetic convective noise is consistent with solar RV observations for short periods. For regularly sampled observations, the analytic expressions of FAP derived for several statistical tests applied to the periodogram standardized by 3D simulation noise are accurate. The adaptive tests considered in this work (Higher-Criticism, Berk-Jones), which are new in the exoplanet field, may offer better detection performance than classical tests (based on the highest periodogram value) in the case of multi-planetary systems and planets with eccentric orbits. 3D MHD simulations are now mature enough to produce reliable synthetic time series of the convective noise affecting RV data. These series can be used to access to the statistics of this noise and derive accurate FAP of tests that are a critical element in the detection of exoplanets down to the cm/s level.

Large liquid argon detectors offer one of the best avenues for the detection of galactic weakly interacting massive particles (WIMPs) via their scattering on atomic nuclei. The liquid argon target allows exquisite discrimination between nuclear and electron recoil signals via pulse-shape discrimination of the scintillation signals. Atmospheric argon (AAr), however, has a naturally occurring radioactive isotope, $^{39}$Ar, a $\beta$ emitter of cosmogenic origin. For large detectors, the atmospheric $^{39}$Ar activity poses pile-up concerns. The use of argon extracted from underground wells, deprived of $^{39}$Ar, is key to the physics potential of these experiments. The DarkSide-20k dark matter search experiment will operate a dual-phase time projection chamber with 50 tonnes of radio-pure underground argon (UAr), that was shown to be depleted of $^{39}$Ar with respect to AAr by a factor larger than 1400. Assessing the $^{39}$Ar content of the UAr during extraction is crucial for the success of DarkSide-20k, as well as for future experiments of the Global Argon Dark Matter Collaboration (GADMC). This will be carried out by the DArT in ArDM experiment, a small chamber made with extremely radio-pure materials that will be placed at the centre of the ArDM detector, in the Canfranc Underground Laboratory (LSC) in Spain. The ArDM LAr volume acts as an active veto for background radioactivity, mostly $\gamma$-rays from the ArDM detector materials and the surrounding rock. This article describes the DArT in ArDM project, including the chamber design and construction, and reviews the background required to achieve the expected performance of the detector.

Context. 55 Cnc e is a transiting super-Earth orbiting a solar-like star with an orbital period of 17.7 hours. In 2011, using the MOST space telescope, a quasi-sinusoidal modulation in flux was detected with the same period as the planetary orbit. The amplitude of this modulation was too large to be explained as the change in light reflected or emitted by the planet. Aims. The MOST telescope continued to observe 55 Cnc e for a few weeks per year over five years, covering 143 individual transits. This paper presents the analysis of the observed phase modulation throughout these observations and a search for the secondary eclipse of the planet. Methods. The most important source of systematic noise in MOST data is due to stray-light reflected from the Earth, which is modulated with both the orbital period of the satellite and the Earth's rotation period. We present a new technique to deal with this source of noise, which we combined with standard detrending procedures for MOST data. We then performed Markov Chain Monte Carlo analyses of the detrended light curves, modeling the planetary transit and phase modulation. Results. We find phase modulations similar to those seen in 2011 in most of the subsequent years; however, the amplitude and phase of maximum light are seen to vary from 113 to 28 ppm and from 0.1 to 3.8 rad. The secondary eclipse is not detected, but we constrain the geometric albedo of the planet to less than 0.47 (2$\sigma$). Conclusions. While we cannot identify a single origin of the observed optical modulation, we propose a few possible scenarios. Those include star-planet interaction or the presence of a transiting circumstellar torus of dust. However, a detailed interpretation of these observations is limited by their photometric precision. Additional observations at optical wavelengths could contribute to uncovering the underlying physical processes.

When the noise affecting time series is colored with unknown statistics, a difficulty for sinusoid detection is to control the true significance level of the test outcome. This paper investigates the possibility of using training data sets of the noise to improve this control. Specifically, we analyze the performances of various detectors {applied to} periodograms standardized using training data sets. Emphasis is put on sparse detection in the Fourier domain and on the limitation posed by the necessarily finite size of the training sets available in practice. We study the resulting false alarm and detection rates and show that standardization leads in some cases to powerful constant false alarm rate tests. The study is both analytical and numerical. Although analytical results are derived in an asymptotic regime, numerical results show that theory accurately describes the tests' behaviour for moderately large sample sizes. Throughout the paper, an application of the considered periodogram standardization is presented for exoplanet detection in radial velocity data.

Our aim is to devise a detection method for exoplanet signatures (multiple sinusoids) that is both powerful and robust to partially unknown statistics under the null hypothesis. In the considered application, the noise is mostly created by the stellar atmosphere, with statistics depending on the complicated interplay of several parameters. Recent progresses in hydrodynamic (HD) simulations show however that realistic stellar noise realizations can be numerically produced off-line by astrophysicists. We propose a detection method that is calibrated by HD simulations and analyze its performances. A comparison of the theoretical results with simulations on synthetic and real data shows that the proposed method is powerful and robust.