We use a gravitational bar torque method to compare bar strengths (the maximum tangential force normalized by radial force) in B and H-band images of 152 galaxies from the Ohio State University Bright Spiral Galaxy Survey. Our main motivation is to check how much the difference in the rest-frame wavelength could affect comparisons of bar strengths in low and high redshift observations. Between these two bands we find an average bar strength ratio Q_B/H= 1.25 which factor is nearly independent of the morphological type. We show that Q_B/H > 1 is mostly due to reduced bulge dilution of radial forces in the B-band. The bar torque method needs an estimate for the vertical scale height of the galaxy, based on the radial scale length of the disk and the galaxy's morphological type. Since these two might not always be possible to determine at high redshifts in a reliable manner, we also checked that similar results are obtained with vertical scale heights estimated from the radii corresponding to the K-band surface brightness of 20 mag/arcsec^2. Also, we made a simple test of the usability of the bar torque method at high redshifts by checking the effects of image degradation (nearest neighbour sampling without any adjustment of noise levels): we found that the estimated bar strengths varied by +/- 10% at most as long as the total extent of the bar was at least 10 pixels. Overall, we show that the gravitational bar torque method should provide a proficient tool for quantifying bar strengths also at high redshifts.

Structural analysis has been performed for a sample of 15 Southern early-type disk galaxies, mainly S0s, using high resolution $K_s$-band images. The galaxies are mostly barred and many of them show multiple structures including bars and ovals, typical for S0s. The new images are of sufficient quality to reveal new detail on the morphology of the galaxies. For example, we report a hitherto undetected nuclear ring in NGC 1387, a nuclear bar in NGC 1326, and in the residual image also a weak primary bar in NGC 1317. For the galaxies we (1) measure the radial profiles of the orientation parameters derived from the elliptical isophotes, (2) apply Fourier methods for calculating tangential forces, and particularly, (3) apply structural decomposition methods. For galaxies with multiple structures a 2-dimensional method is found to be superior to a 1-dimensional method, but only if in addition to the bulge and the disk, at least one other component is taken into account. {\it We find strong evidence of pseudo-bulges in S0s}: ten of the galaxies have the shape parameter of the bulge near to $n$ = 2, indicating that the bulges are more disk-like than following the R$^{1/4}$-law. Also, six of the galaxies have either nuclear rings, nuclear bars or nuclear disks. In all non-elliptical galaxies in our sample the $B/T < $ 0.4, as typically found in galaxies having pseudo-bulges. In two of the galaxies the $B/T$ flux ratio is as small as in typical Sc-type spirals. This might be the hitherto undiscovered link in the scenario in which spirals are transformedinto S0s. Also, bars in S0s are found to be shorter and less massive, and have smaller bar torques than bars in S0/a-type galaxies.