The Characterising Exoplanet Satellite (CHEOPS) is a space mission designed to perform photometric observations of bright stars to obtain precise radii measurements of transiting planets. The high-precision photometry of CHEOPS relies on careful on-ground calibration of its payload. For that purpose, intensive pre-launch campaigns of measurements were carried out to calibrate the instrument and characterise its photometric performances. We report on main results of these campaigns, provide a complete analysis of data sets and estimate in-flight photometric performance by mean of end-to-end simulation. The on-ground photometric stability of the instrument is found to be of the order of 15 parts per million over 5 hours. Our end-to-end simulation shows that measurements of planet-to-star radii ratio with CHEOPS can be determined with a precision of 2% for a Neptune-size planet transiting a K-dwarf star and 5% for an Earth-size planet orbiting a Sun-like star. It corresponds to signal-to-noise ratios on the transit depths of 25 and 10 respectively, allowing the characterisation and detection of these planets. The pre-launch CHEOPS performances are shown to be compliant with the mission requirements.

Athena is the large mission selected by ESA in 2013 to investigate the science theme "Hot and Energetic Universe" and presently scheduled for launch in 2028. One of the two instruments located at the focus of the 12 m-long Athena telescope is the X-ray Integral Field Unit (X-IFU). This is an array of TES micro-calorimeters that will be operated at temperatures of 50 mK in order to perform high resolution spectroscopy with an energy resolution down to 2.5 eV at energies < 7 keV. In order to cope with the large dynamical range of X-ray fluxes spanned by the celestial objects Athena will be observing, the X-IFU will be equipped with a filter wheel. This will allow the user to fine tune the instrument set-up based on the nature of the target, thus optimizing the scientific outcomes of the observation. A few positions of the filter wheel will also be used to host a calibration source and to allow the measurement of the instrument intrinsic background.