The X-Ray Spectrometer (XRS) on the MESSENGER spacecraft provided measurements of major-element ratios across Mercury's surface. We present global maps of Mg/Si, Al/Si, S/Si, Ca/Si, and Fe/Si derived from XRS data collected throughout MESSENGER's orbital mission. We describe the procedures we used to select and filter data and to combine them to make the final maps, which are archived in NASA's Planetary Data System. Areal coverage is variable for the different element-ratio maps, with 100% coverage for Mg/Si and Al/Si, but only 18% coverage for Fe/Si north of 30 $^{\circ}$ N, where the spatial resolution is highest. The spatial resolution is improved over previous maps by 10-15% because of the inclusion of higher-resolution data from late in the mission when the spacecraft periapsis altitude was low. Unlike typical planetary data maps, however, the spatial resolution of the XRS maps can vary from pixel to pixel, and thus care must be taken in interpreting small-scale features. We provide several examples of how the XRS maps can be used to investigate elemental variations in the context of geological features on Mercury, which range in size from single $\sim$100-km-diameter craters to large impact basins. We expect that these maps will provide the basis for and/or contribute to studies of Mercury's origin and geological history for many years to come.

This textbook gives a perspective of heliophysics in a way that emphasizes universal processes from a perspective that draws attention to what provides Earth (and similar (exo-)planets) with a relatively stable setting in which life as we know it can thrive. The book is intended for students in physical sciences in later years of their university training and for beginning graduate students in fields of solar, stellar, (exo-)planetary, and planetary-system sciences.

The second Miniature X-ray Solar Spectrometer (MinXSS-2) CubeSat, which begins its flight in late 2018, builds on the success of MinXSS-1, which flew from 2016-05-16 to 2017-05-06. The science instrument is more advanced -- now capable of greater dynamic range with higher energy resolution. More data will be captured on the ground than was possible with MinXSS-1 thanks to a sun-synchronous, polar orbit and technical improvements to both the spacecraft and the ground network. Additionally, a new open-source beacon decoder for amateur radio operators is available that can automatically forward any captured MinXSS data to the operations and science team. While MinXSS-1 was only able to downlink about 1 MB of data per day corresponding to a data capture rate of about 1%, MinXSS-2 will increase that by at least a factor of 6. This increase of data capture rate in combination with the mission's longer orbital lifetime will be used to address new science questions focused on how coronal soft X-rays vary over solar cycle timescales and what impact those variations have on the earth's upper atmosphere.

The Miniature X-ray Solar Spectrometer (MinXSS) is a 3 Unit (3U) CubeSat designed for a 3-month mission to study solar soft X-ray spectral irradiance. The first of the two flight models was deployed from the International Space Station in 2016 May and operated for one year before its natural deorbiting. This was the first flight of the Blue Canyon Technologies XACT 3-axis attitude determination and control system -- a commercially available, high-precision pointing system. We characterized the performance of the pointing system on orbit including performance at low altitudes where drag torque builds up. We found that the pointing accuracy was 0.0042\degree\ - 0.0117\degree\ (15$''$ - 42$''$, 3$\sigma$, axis dependent) consistently from 190 km - 410 km, slightly better than the specification sheet states. Peak-to-peak jitter was estimated to be 0.0073\degree\ (10 s$^{-1}$) - 0.0183\degree\ (10 s$^{-1}$) (26$''$ (10 s$^{-1}$) - 66$''$ (10 s$^{-1}$), 3$\sigma$). The system was capable of dumping momentum until an altitude of 185 km. We found small amounts of sensor degradation in the star tracker and coarse sun sensor. Our mission profile did not require high-agility maneuvers so we are unable to characterize this metric. Without a GPS receiver, it was necessary to periodically upload ephemeris information to update the orbit propagation model and maintain pointing. At 400 km, these uploads were required once every other week. At $\sim$270 km, they were required every day. We also characterized the power performance of our electric power system, which includes a novel pseudo-peak power tracker -- a resistor that limited the current draw from the battery on the solar panels. With 19 30\% efficient solar cells and an 8 W system load, the power balance had 65\% of margin on orbit. We present several recommendations to other CubeSat programs throughout.

The goal of the Miniature X-ray Solar Spectrometer (MinXSS) CubeSat is to explore the energy distribution of soft X-ray (SXR) emissions from the quiescent Sun, active regions, and during solar flares, and to model the impact on Earth's ionosphere and thermosphere. The energy emitted in the SXR range (0.1 --10 keV) can vary by more than a factor of 100, yet we have limited spectral measurements in the SXRs to accurately quantify the spectral dependence of this variability. The MinXSS primary science instrument is an Amptek, Inc. X123 X-ray spectrometer that has an energy range of 0.5--30 keV with a nominal 0.15 keV energy resolution. Two flight models have been built. The first, MinXSS-1, has been making science observations since 2016 June 9, and has observed numerous flares, including more than 40 C-class and 7 M-class flares. These SXR spectral measurements have advantages over broadband SXR observations, such as providing the capability to derive multiple-temperature components and elemental abundances of coronal plasma, improved irradiance accuracy, and higher resolution spectral irradiance as input to planetary ionosphere simulations. MinXSS spectra obtained during the M5.0 flare on 2016 July 23 highlight these advantages, and indicate how the elemental abundance appears to change from primarily coronal to more photospheric during the flare. MinXSS-1 observations are compared to the Geostationary Operational Environmental Satellite (GOES) X-Ray Sensor (XRS) measurements of SXR irradiance and estimated corona temperature. Additionally, a suggested improvement to the calibration of the GOES XRS data is presented.

Melott et al. [2016] suggest that individual solar proton events (SPEs) are detectable as nitrate ion spikes in ice cores. They use the high fluence, high energy (hard spectrum) SPE of 23 February 1956 to calculate an enhancement of HNO3 from the surface to 46 km that is equivalent to a ~120 ng cm-2 nitrate ion spike observed in the GISP2H ice core. The Melott et al. [2016] approach is fundamentally flawed, since it considers only the absolute column burden of SPE-produced nitrate and not the pre-existing nitrate in the stratosphere. Modeling studies supported by extensive observations [Duderstadt et al., 2014, 2016, and this comment] show background HNO3 in the lower and middle stratosphere equivalent to 2000 to 3000 ng cm-2 nitrate. These high levels of background nitrate must also be included when estimating SPE enhancements to the deposition of nitrate ions that might eventually be preserved in an ice core. The 1956 SPE results in less than a 5% increase in the column burden of atmospheric HNO3, not large enough to explain the nitrate spike seen in the GISP2H ice core. Even extreme SPE enhancements cannot explain nitrate peaks (typically hundreds of percent increases) observed in the ice record [Duderstadt et al., 2016]. Realistic mechanisms linking nitrate ions in ice cores to SPEs have not been established. It is time to move the search for indicators of SPEs away from nitrate ions: Nitrate ions cannot be used as proxies for individual SPEs in the ice core record.

Nitrate ion spikes in polar ice cores are contentiously used to estimate the intensity, frequency, and probability of historical solar proton events, quantities that are needed to prepare for potentially society-crippling space weather events. We use the Whole Atmosphere Community Climate Model to calculate how large an event would have to be to produce enough odd nitrogen throughout the atmosphere to be discernible as nitrate peaks at the Earth's surface. These hypothetically large events are compared with probability of occurrence estimates derived from measured events, sunspot records, and cosmogenic radionuclides archives. We conclude that the fluence and spectrum of solar proton events necessary to produce odd nitrogen enhancements equivalent to the spikes of nitrate ions in Greenland ice cores are unlikely to have occurred throughout the Holocene, confirming that nitrate ions in ice cores are not suitable proxies for historical individual solar proton events.

The Miniature X-ray Solar Spectrometer (MinXSS) is a 3-Unit (3U) CubeSat developed at the Laboratory for Atmospheric and Space Physics (LASP) at the University of Colorado, Boulder (CU). Over 40 students contributed to the project with professional mentorship and technical contributions from professors in the Aerospace Engineering Sciences Department at CU and from LASP scientists and engineers. The scientific objective of MinXSS is to study processes in the dynamic Sun, from quiet-Sun to solar flares, and to further understand how these changes in the Sun influence the Earth's atmosphere by providing unique spectral measurements of solar soft x-rays (SXRs). The enabling technology providing the advanced solar SXR spectral measurements is the Amptek X123, a commercial-off-the-shelf (COTS) silicon drift detector (SDD). The Amptek X123 has a low mass (~324 g after modification), modest power consumption (~2.50 W), and small volume (6.86 cm x 9.91 cm x 2.54 cm), making it ideal for a CubeSat. This paper provides an overview of the MinXSS mission: the science objectives, project history, subsystems, and lessons learned that can be useful for the small-satellite community.

The rotational evolution of Mercury's mantle and its core under conservative and dissipative torques is important for understanding the planet's spin state. Dissipation results from tides and viscous, magnetic and topographic core--mantle interactions. The dissipative core--mantle torques take the system to an equilibrium state wherein both spins are fixed in the frame precessing with the orbit, and in which the mantle and core are differentially rotating. This equilibrium exhibits a mantle spin axis that is offset from the Cassini state by larger amounts for weaker core--mantle coupling for all three dissipative core--mantle coupling mechanisms, and the spin axis of the core is separated farther from that of the mantle, leading to larger differential rotation. The relatively strong core--mantle coupling necessary to bring the mantle spin axis to its observed position close to the Cassini state is not obtained by any of the three dissipative core--mantle coupling mechanisms. For a hydrostatic ellipsoidal core--mantle boundary, pressure coupling dominates the dissipative effects on the mantle and core positions, and dissipation together with pressure coupling brings the mantle spin solidly to the Cassini state. The core spin goes to a position displaced from that of the mantle by about 3.55 arcmin nearly in the plane containing the Cassini state. With the maximum viscosity considered of $\nu\sim 15.0\,{\rm cm^2/s}$ if the coupling is by the circulation through an Ekman boundary layer or $\nu\sim 8.75\times 10^5\,{\rm cm^2/s}$ for purely viscous coupling, the core spin lags the precessing Cassini plane by 23 arcsec, whereas the mantle spin lags by only 0.055 arcsec. Larger, non hydrostatic values of the CMB ellipticity also result in the mantle spin at the Cassini state, but the core spin is moved closer to the mantle spin.