We study the recurring jets near AR11176 during the period 2011 March 31 17:00 UT to April 1 05:00 UT using observations from the Atmospheric Imaging Assembly (AIA) on board Solar Dynamics Observatory (SDO). Mini-filaments (mini-filament1 & 2) are found at the base of these recurring jets where mini-filament1 shows the partial signature of eruption in case of Jet1-3. However, the mini-filament2 shows a complete eruption driving a full blow-out jet (Jet4). The eruption of mini-filament2 triggers C-class flare and Jet4 eruption. The eruption of Jet4 triggers a coronal mass ejection (CME). The plane-of-sky velocity of recurring jets (Jet1-4) results in 160 km/s, 106 km/s, 151 km/s and 369 km/s. The estimated velocity of CME is 636 km/s. The continuous magnetic flux cancellation is observed at the base of the jet productive region which could be the cause of the eruption of mini-filaments and recurring jets. In the former case, the mini-filament1 shows partial eruption and first three jets (Jet1-3) are produced, but the rate of cancellation was rather low. However, in the latter case, mini-filament2 fully erupts (perhaps because of a higher cancellation rate), and this triggers a C-class flare and a CME-productive jet. At the base of first three jets (Jet1-3), the mini-filament1 causes to push the overlying dynamic complex thin loops resulting in the reconnection and drives the jet (Jet1-3) eruptions. The formation of the plasma blobs are observed during the eruption of the first jet (Jet1).

We study a quiet-Sun blowout jet which is observed on 2014 May 16 by the instruments on board Solar Dynamics Observatory (SDO). We find the twin CME as jet-like and bubble-like CME simultaneously as observed by LASCO C2 on board Solar and Heliospheric Observatory (SoHO), Solar Terrestrial Relation Observatory (STEREO A and STEREO B/COR2). They are respectively associated with the eruption of the northern and southern sections of the filament. A circular filament is rooted at the internetwork region at the base of the blowout jet. The collective magnetic cancellation is observed by SDO/HMI line of sight (LOS) magnetograms at the northern end of the filament, which makes this filament unstable and further makes it to erupt in two different stages. In the first stage, northern section of the filament is ejected, and causes an evolution of the northern part of the blowout jet. This part of the blowout jet is further extended as a collimated plasma beam to form a jet-like CME. We also observe the plasma blobs at the northern edge of the blowout jet resulting from Kelvin-Helmholtz (K-H) instability in its twisted magneto-plasma spire. In the second stage, southern section of the filament erupts in form of deformed/twisted magnetic flux rope which forms the southern part of the blowout jet. This eruption is most likely caused by the eruption of the northern section of filament, which removes the confined magnetic field of the southern section of the filament. Alternative scenarios may be a magnetic implosion between these magnetic structures confined in a much larger magnetic domain. This eruption of southern section of the filament further results in the bubble-like CME in the outer corona.

Using HINODE/XRT, GOES, SDO/AIA observations, we study a compact C-1.4 class flare outside a major sunspot of AR 12178 on 4 October 2014. This flare is associated with a peculiar coronal jet, which is erupted in two stages in the overlying corona above the compact flaring region. At the time of flare maximum, the first stage of the jet eruption occurs above the flare energy release site, and thereafter in the second stage its magneto-plasma system interacts with the overlying distinct magnetic field domain in its vicinity to build further the typical jet plasma column.