Normalized to: Smirnova, M.
[1]
oai:arXiv.org:1504.00779 [pdf] - 1323369
Design, Construction and Operation of a Low-Power, Autonomous
Radio-Frequency Data-Acquisition Station for the TARA Experiment
Kunwar, S.;
Abbasi, R.;
Allen, C.;
Belz, J.;
Besson, D.;
Byrne, M.;
Farhang-Boroujeny, B.;
Gillman, W. H.;
Hanlon, W.;
Hanson, J.;
Myers, I.;
Novikov, A.;
Prohira, S.;
Ratzlaff, K.;
Rezazadeh, A.;
Sanivarapu, V.;
Schurig, D.;
Shustov, A.;
Smirnova, M.;
Takai, H.;
Thomson, G. B.;
Young, R.
Submitted: 2015-04-03, last modified: 2015-05-29
Employing a 40-kW radio-frequency transmitter just west of Delta, UT, and
operating at 54.1 MHz, the TARA (Telescope Array RAdar) experiment seeks radar
detection of extensive air showers (EAS) initiated by ultra-high energy cosmic
rays (UHECR). For UHECR with energies in excess of $10^{19}$ eV, the
Doppler-shifted "chirps" resulting from EAS shower core radar reflections
should be observable above background (dominantly galactic) at distances of
tens of km from the TARA transmitter. In order to stereoscopically reconstruct
cosmic ray chirps, two remote, autonomous self-powered receiver stations have
been deployed. Each remote station (RS) combines both low power consumption as
well as low cost. Triggering logic, the powering and communication systems, and
some specific details of hardware components are discussed.
[2]
oai:arXiv.org:astro-ph/0310353 [pdf] - 1233242
Position-sensitive detector for the 6-meter optical telescope
Submitted: 2003-10-14, last modified: 2003-10-15
The Position-Sensitive Detector (PSD) for photometrical and spectral
observation on the 6-meter optical telescope of the Special Astrophysical
Observatory (Russia) is described. The PSD consists of a position-sensitive
tube, amplifiers of output signals, analog-to-digital converters (ADC) and a
digital logic plate, which produces a signal for ADC start and an external
strob pulse for reading information by registration system. If necessary, the
thermoelectric cooler can be used. The position-sensitive tube has the
following main elements: a photocathode, electrodes of inverting optics, a
block of microchannel plates (MCP) and a position-sensitive collector of
quadrant type. The main parameters of the PSD are the diameter of the sensitive
surface is 25 mm, the spatial resolution is better than 100 (\mu)m in the
centre and a little worse on the periphery; the dead time is near 0.5 (\mu)s;
the detection quantum efficiency is defined by the photocathode and it is not
less than 0.1, as a rule; dark current is about hundreds of cps, or less, when
cooling. PSD spectral sensitivity depends on the type of photocathode and input
window material. We use a multialkali photocathode and a fiber or UV-glass,
which gives the short- wave cut of 360 nm or 250 nm, respectively.