sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Shah, Vishal M.

Normalized to: Shah, V.

5 article(s) in total. 29 co-authors, from 1 to 3 common article(s). Median position in authors list is 7,0.

[1]  oai:arXiv.org:1903.06303  [pdf] - 1894260
The Elusive Majority of Young Moving Groups. I. Young Binaries and Lithium-Rich Stars in the Solar Neighborhood
Comments: Accepted to ApJ
Submitted: 2019-03-14
Young stars in the solar neighborhood serve as nearby probes of stellar evolution and represent promising targets to directly image self-luminous giant planets. We have carried out an all-sky search for late-type ($\approx$K7$-$M5) stars within 100 pc selected primarily on the basis of activity indicators from $GALEX$ and $ROSAT$. Approximately two thousand active and potentially young stars are identified, over 600 of which we have followed up with low-resolution optical spectroscopy and over 1000 with diffraction-limited imaging using Robo-AO at the Palomar 1.5-m telescope. Strong lithium is present in 58 stars, implying ages spanning $\approx$10$-$200 Myr. Most of these lithium-rich stars are new or previously known members of young moving groups including TWA, $\beta$ Pic, Tuc-Hor, Carina, Columba, Argus, AB Dor, Upper Centaurus Lupus, and Lower Centaurus Crux; the rest appear to be young low-mass stars without connections to established kinematic groups. Over 200 close binaries are identified down to 0.2$''$ $-$ the vast majority of which are new $-$ and will be valuable for dynamical mass measurements of young stars with continued orbit monitoring in the future.
[2]  oai:arXiv.org:1607.06485  [pdf] - 1460965
Precision velocimetry planet hunting with PARAS: Current performance and lessons to inform future extreme precision radial velocity instruments
Comments: 9 pages, 6 figures, published in Proc. of SPIE Astronomical Telescopes + Instrumentation 2016
Submitted: 2016-07-21
PARAS is a fiber-fed stabilized high-resolution cross-dispersed echelle spectrograph, located on the 1.2 m telescope in Mt. Abu India. Designed for exoplanet detection, PARAS is capable of single-shot spectral coverage of 3800 - 9600 A, and currently achieving radial velocity (RV) precisions approaching ~1 m/s over several months using simultaneous ThAr calibration. As such, it is one of the few dedicated stabilized fiber-fed spectrographs on small (1-2 m) telescopes that are able to fill an important niche in RV follow-up and stellar characterization. The success of ground-based RV surveys is motivating the push into extreme precisions, with goals of ~10 cm/s in the optical and <1 m/s in the near-infrared (NIR). Lessons from existing instruments like PARAS are invaluable in informing hardware design, providing pipeline prototypes, and guiding scientific surveys. Here we present our current precision estimates of PARAS based on observations of bright RV standard stars, and describe the evolution of the data reduction and RV analysis pipeline as instrument characterization progresses and we gather longer baselines of data. Secondly, we discuss how our experience with PARAS is a critical component in the development of future cutting edge instruments like (1) the Habitable Zone Planet Finder (HPF), a NIR spectrograph optimized to look for planets around M dwarfs, scheduled to be commissioned on the Hobby Eberly Telescope in 2017, and (2) the NEID optical spectrograph, designed in response to the NN-EXPLORE call for an extreme precision Doppler spectrometer (EPDS) for the WIYN telescope. In anticipation of instruments like TESS and GAIA, the ground-based RV support system is being reinforced. We emphasize that instruments like PARAS will play an intrinsic role in providing both complementary follow-up and battlefront experience for these next generation of precision velocimeters.
[3]  oai:arXiv.org:1312.5471  [pdf] - 1202371
The PRL Stabilized High Resolution Echelle Fiber-fed Spectrograph: Instrument Description & First Radial Velocity Results
Comments: 33 pages, 15 figures, accepted for publication in PASP
Submitted: 2013-12-19
We present spectrograph design details and initial radial velocity results from the PRL optical fiber-fed high-resolution cross-dispersed echelle spectrograph (PARAS), which has recently been commissioned at the Mt Abu 1.2 m telescope, in India. Data obtained as part of the post-commissioning tests with PARAS show velocity precision better than 2m/s over a period of several months on bright RV standard stars. For observations of sigma-Dra we report 1.7m/s precision for a period of seven months and 2.1m/s for HD 9407 over a period of 2 months. PARAS is capable of a single-shot spectral coverage of 3800A - 9500A at a resolution of about 67,000. The RV results were obtained between 3800A and 6900A using simultaneous wavelength calibration with a Thorium-Argon (ThAr) hollow cathode lamp. The spectrograph is maintained under stable conditions of temperature with a precision of 0.01 - 0.02C (rms) at 25.55C, and enclosed in a vacuum vessel at pressure of 0.1 +/-0.03 mbar. The blaze peak efficiency of the spectrograph between 5000A and 6500A, including the detector, is 30%; and about 25% with the fiber transmission. The total efficiency, including spectrograph, fiber transmission, focal ratio degradation (FRD), and telescope (with 81% reflectivity) is about 7% in the same wavelength region on a clear night with good seeing conditions.
[4]  oai:arXiv.org:1007.4280  [pdf] - 1033890
First Light results from PARAS: The PRL Echelle Spectrograph
Comments: To appear in SPIE Proc. 2010, vol. 7035
Submitted: 2010-07-24
We present the first light commissioning results from the Physical Research Laboratory (PRL) optical fiber-fed high resolution cross-dispersed Echelle Spectrograph. It is capable of a single- shot spectral coverage of 3700A to 8600A at R ~ 63,000 and is under very stable conditions of temperature (0.04{\deg}C at 23{\deg}C). In the very near future pressure control will also be achieved by enclosing the entire spectrograph in a low-pressure vacuum chamber (~0.01mbar). It is attached to a 1.2m telescope using two 50micron core optical fibers (one for the star and another for simultaneous Th-Ar spectral calibration). The 1.2m telescope is located at Mt. Abu, India, and we are guaranteed about 80 to 100 nights a year for observations with the spectrograph. The instrument will be ultimately used for radial-velocity searches of exoplanets around 1000 dwarf stars, brighter than 10th magnitude, for the next 5 years with a precision of 3 to 5m/s using the simultaneous Th-Ar spectral lamp reference technique. The spectrograph has already achieved a stability of 3.7m/s in short-term time scale and in the near future we expect the stability to be at 1m/s once we install the spectrograph inside the vacuum chamber.
[5]  oai:arXiv.org:astro-ph/0612356  [pdf] - 87694
The Fe-Line Feature In The X-Ray Spectrum of Solar Flares: First Results From The SOXS Mission
Comments: 21 pages, 12 figures, Solar Physics (in press)
Submitted: 2006-12-13
We present the first results from the "Low Energy Detector" payload of the "Solar X-ray Spectrometer (SOXS)" mission, which was launched onboard the GSAT-2 Indian spacecraft on 08 May 2003 by the GSLV-D2 rocket to study solar flares. The SOXS Low Energy Detector (SLD) payload was designed, developed, and fabricated by the Physical Research Laboratory (PRL) in collaboration with the Space Application Centre (SAC), Ahmedabad and the ISRO Satellite Centre (ISAC), Bangalore of Indian Space Research Organization (ISRO). The energy ranges of the Si PIN and CZT detectors are 4 - 25 keV and 4 - 56 keV respectively. The Si PIN provides sub-keV energy resolution while the CZT reveals ~1.7 keV energy resolution throughout the energy range. The high sensitivity and sub-keV energy resolution of the Si PIN detector allows measuring the intensity, peak energy, and the equivalent width of the Fe-line complex at approximately 6.7 keV as a function of time in all ten M-class flares studied in this investigation. The peak energy (Ep) of the Fe-line feature varies between 6.4 and 6.7 keV with increasing in temperature from 9 to 58 MK. We found that the equivalent width (w) of the Fe-line feature increases exponentially with temperature up to 30 MK and then increases very slowly up to 40 Mk. It remains between 3.5 and 4 keV in the temperature range of 30 - 45 MK. We compare our measurements of w with calculations made earlier by various investigators and propose that these measurements may improve theoretical models. We interpret the variation of both Ep and w with temperature as due to the changes in the ionization and recombination conditions in the plasma during the flare interval and as a consequence the contribution from different ionic emission lines also varies.