The standard general relativistic model of a razor-thin accretion disk around a black hole, developed by Novikov & Thorne (NT) in 1973, assumes the shear stress vanishes at the radius of the innermost stable circular orbit (ISCO) and that, outside the ISCO, the shear stress is produced by an effective turbulent viscosity. However, astrophysical accretion disks are not razor-thin, it is uncertain whether the shear stress necessarily vanishes at the ISCO, and the magnetic field, which is thought to drive turbulence in disks, may contain large-scale structures that do not behave like a simple local scalar viscosity. We describe three-dimensional general relativistic magnetohydrodynamic simulations of accretion disks around black holes with a range of spin parameters, and we use the simulations to assess the validity of the NT model. Our fiducial initial magnetic field consists of multiple (alternating polarity) poloidal field loops whose shape is roughly isotropic in the disk in order to match the isotropic turbulence expected in the poloidal plane. For a thin disk with an aspect ratio |h/r| ~ 0.07 around a non-spinning black hole, we find a decrease in the accreted specific angular momentum of 2.9% relative to the NT model and an excess luminosity from inside the ISCO of 3.5%. The deviations in the case of spinning black holes are of the same order. In addition, the deviations decrease with decreasing |h/r|. We therefore conclude that magnetized thin accretion disks in x-ray binaries in the thermal/high-soft spectral state ought to be well-described by the NT model, especially at luminosities below 30% of Eddington where we expect a very small disk thickness |h/r| <~ 0.05. We also discuss how the stress and the luminosity inside the ISCO depend on the assumed initial magnetic field geometry. (abridged)

We describe three-dimensional general relativistic magnetohydrodynamic simulations of a geometrically thin accretion disk around a non-spinning black hole. The disk has a thickness $h/r\sim0.05-0.1$ over the radial range $(2-20)GM/c^2$. In steady state, the specific angular momentum profile of the inflowing magnetized gas deviates by less than 2% from that of the standard thin disk model of Novikov & Thorne (1973). Also, the magnetic torque at the radius of the innermost stable circular orbit (ISCO) is only $\sim2%$ of the inward flux of angular momentum at this radius. Both results indicate that magnetic coupling across the ISCO is relatively unimportant for geometrically thin disks.

We consider a simple Newtonian model of a steady accretion disk around a black hole. The model is based on height-integrated hydrodynamic equations, alpha-viscosity, and a pseudo-Newtonian potential that results in an innermost stable circular orbit (ISCO) that closely approximates the one predicted by GR. We find that the hydrodynamic models exhibit increasing deviations from the standard disk model of Shakura & Sunyaev as disk thickness H/R or the value of alpha increases. The latter is an analytical model in which the viscous torque is assumed to vanish at the ISCO. We consider the implications of the results for attempts to estimate black hole spin by using the standard disk model to fit continuum spectra of black hole accretion disks. We find that the error in the spin estimate is quite modest so long as H/R < 0.1 and alpha < 0.2. At worst the error in the estimated value of the spin parameter is 0.1 for a non-spinning black hole; the error is much less for a rapidly spinning hole. We also consider the density and disk thickness contrast between the gas in the disk and that inside the ISCO. The contrast needs to be large if black hole spin is to be successfully estimated by fitting the relativistically-broadened X-ray line profile of fluorescent iron emission from reflection off an accretion disk. In our hydrodynamic models, the contrast in density and thickness is low when H/R>0.1, sugesting that the iron line technique may be most reliable in extemely thin disks. We caution that these results have been obtained with a viscous hydrodynamic model and need to be confirmed with MHD simulations of radiatively cooled thin disks.

We have used the Novikov-Thorne thin disk model to fit the continuum X-ray spectra of three transient black hole X-ray binaries in the thermal state. From the fits we estimate the dimensionless spin parameters of the black holes to be: 4U 1543-47, a* = a/M = 0.7-0.85; GRO J1655-40, a* = 0.65-0.8; GRS 1915+105, a* = 0.98-1. We plan to expand the sample of spin estimates to about a dozen over the next several years. Some unresolved theoretical issues are briefly discussed.

We describe a program that we have embarked on to estimate the spins of stellar-mass black holes in X-ray binaries. We fit the continuum X-ray spectrum of the radiation from the accretion disk using the standard thin disk model, and extract the dimensionless spin parameter a* = a/M of the black hole as a parameter of the fit. We have obtained results on three systems, 4U 1543-47 (a* = 0.7-0.85), GRO J1655-40 (0.65-0.8), and GRS 1915+105 (0.98-1), and have nearly completed analysis of two additional systems. We anticipate expanding the sample of spin estimates to about a dozen over the next several years.

Based on a spectral analysis of the X-ray continuum that employs a fully relativistic accretion-disk model, we conclude that the compact primary of the binary X-ray source GRS 1915+105 is a rapidly-rotating Kerr black hole. We find a lower limit on the dimensionless spin parameter of a* greater than 0.98. Our result is robust in the sense that it is independent of the details of the data analysis and insensitive to the uncertainties in the mass and distance of the black hole. Furthermore, our accretion-disk model includes an advanced treatment of spectral hardening. Our data selection relies on a rigorous and quantitative definition of the thermal state of black hole binaries, which we used to screen all of the available RXTE and ASCA data for the thermal state of GRS 1915+105. In addition, we focus on those data for which the accretion disk luminosity is less than 30% of the Eddington luminosity. We argue that these low-luminosity data are most appropriate for the thin alpha-disk model that we employ. We assume that there is zero torque at the inner edge of the disk, as is likely when the disk is thin, although we show that the presence of a significant torque does not affect our results. Our model and the model of the relativistic jets observed for this source constrain the distance and black hole mass and could thus be tested by determining a VLBA parallax distance and improving the measurement of the mass function. Finally, we comment on the significance of our results for relativistic-jet and core-collapse models, and for the detection of gravitational waves.

We fit X-ray spectral data in the thermal dominant or high soft state of two dynamically confirmed black holes, GRO J1655-40 and 4U 1543-47, and estimate the dimensionless spin parameters a* = a/M of the two holes. For GRO J1655-40, using a spectral hardening factor computed for a non-LTE relativistic accretion disk, we estimate a* ~ 0.75 and ~ 0.65-0.75, respectively, from ASCA and RXTE data. For 4U 1543-47, we estimate a* ~ 0.75-0.85 from RXTE data. Thus, neither black hole has a spin approaching the theoretical maximum a* = 1.