Context: Eruptive events such as coronal mass ejections (CMEs) and flares accelerate particles and generate shock waves which can arrive at Earth and can disturb the magnetosphere. Understanding the association between CMEs and CME-driven shocks is therefore highly important for space weather studies. Aims: We present a study of the CME/flare event associated with two type II bursts observed on September 27, 2012. The aim of the study is to understand the relationship between the observed CME and the two distinct shock wave signatures. Methods: The multi-wavelength study of the eruptive event (CME/flare) was complemented with radio triangulation of the associated radio emission and modelling of the CME and the shock wave employing MHD simulations. Results: We found that, although temporal association between the type II bursts and the CME is good, the low-frequency type II(LF-type II) burst occurs significantly higher in the corona than the CME and its relationship to the CME is not straightforward. The analysis of the EIT wave (coronal bright front) shows the fastest wave component to be in the southeast quadrant of the Sun. This is also the quadrant in which the source positions of the LF-type II were found to be located, probably resulting from the interaction between the shock wave and a streamer. Conclusions: The relationship between the CME/flare event and the shock wave signatures is discussed using the temporal association,as well as the spatial information of the radio emission. Further, we discuss the importance and possible effects of the frequently non-radial propagation of the shock wave.

Coronal mass ejections (CMEs) are the primary sources of intense disturbances at Earth, where their geo-effectiveness is largely determined by their dynamic pressure and internal magnetic field, which can be significantly altered during interactions with other CMEs in interplanetary space. We analyse three successive CMEs that erupted from the Sun during September 4-6, 2017, investigating the role of CME-CME interactions as source of the associated intense geomagnetic storm (Dst_min=-142 nT on September 7). To quantify the impact of interactions on the (geo-)effectiveness of individual CMEs, we perform global heliospheric simulations with the EUHFORIA model, using observation-based initial parameters with the additional purpose of validating the predictive capabilities of the model for complex CME events. The simulations show that around 0.45 AU, the shock driven by the September 6 CME started compressing a preceding magnetic ejecta formed by the merging of two CMEs launched on September 4, significantly amplifying its Bz until a maximum factor of 2.8 around 0.9 AU. The following gradual conversion of magnetic energy into kinetic and thermal components reduced the Bz amplification until its almost complete disappearance around 1.8 AU. We conclude that a key factor at the origin of the intense storm triggered by the September 4-6, 2017 CMEs was their arrival at Earth during the phase of maximum Bz amplification. Our analysis highlights how the amplification of the magnetic field of individual CMEs in space-time due to interaction processes can be characterised by a growth, a maximum, and a decay phase, suggesting that the time interval between the CME eruptions and their relative speeds are critical factors in determining the resulting impact of complex CMEs at various heliocentric distances (helio-effectiveness).

In order to address the growing need for more accurate space weather predictions, a new model named EUHFORIA (EUropean Heliospheric FORecasting Information Asset) was recently developed (Pomoell and Poedts, 2018). We present first results of the performance assessment for the solar wind modeling with EUHFORIA and identify possible limitations of its present setup. Using the basic EUHFORIA 1.0.4. model setup with the default input parameters, we modeled background solar wind (no coronal mass ejections) and compared the obtained results with ACE, in situ measurements. For the need of statistical study we developed a technique of combining daily EUHFORIA runs into continuous time series. The combined time series were derived for the years 2008 (low solar activity) and 2012 (high solar activity) from which in situ speed and density profiles were extracted. We find for the low activity phase a better match between model results and observations compared to the considered high activity time interval. The quality of the modeled solar wind parameters is found to be rather variable. Therefore, to better understand the obtained results we also qualitatively inspected characteristics of coronal holes, sources of the studied fast streams. We discuss how different characteristics of the coronal holes and input parameters to EUHFORIA influence the modeled fast solar wind, and suggest possibilities for the improvements of the model.

We analyse in this work the propagation and geoeffectiveness of four successive coronal mass ejections (CMEs) that erupted from the Sun during 21--23 May 2013 and that were detected in interplanetary space by the Wind and/or STEREO-A spacecraft. All these CMEs featured critical aspects for understanding so-called "problem space weather storms" at Earth. In the first three events a limb CMEs resulted in moderately geoeffective in-situ structures at their target location in terms of the disturbance storm time (Dst) index (either measured or estimated). The fourth CME, which also caused a moderate geomagnetic response, erupted from close to the disc centre as seen from Earth, but it was not visible in coronagraph images from the spacecraft along the Sun--Earth line and appeared narrow and faint from off-angle viewpoints. Making the correct connection between CMEs at the Sun and their in-situ counterparts is often difficult for problem storms. We investigate these four CMEs using multiwavelength and multipoint remote-sensing observations (extreme ultraviolet, white light, and radio), aided by 3D heliospheric modelling, in order to follow their propagation in the corona and in interplanetary space and to assess their impact at 1 AU. Finally, we emphasise the difficulties in forecasting moderate space weather effects provoked by problematic and ambiguous events and the importance of multispacecraft data for observing and modelling problem storms.

Coronal Mass Ejections (CMEs) are the primary source of strong space weather disturbances at Earth. Their geoeffectiveness is largely determined by their dynamic pressure and internal magnetic fields, for which reliable predictions at Earth are not possible with traditional cone CME models. We study two Earth-directed CMEs using the EUropean Heliospheric FORecasting Information Asset (EUHFORIA) model, testing the predictive capabilities of a linear force-free spheromak CME model initialised using parameters derived from remote-sensing observations. Using observation-based CME input parameters, we perform MHD simulations of the events with the cone and spheromak CME models. Results show that spheromak CMEs propagate faster than cone CMEs when initialised with the same kinematic parameters. We interpret these differences as due to different Lorentz forces acting within cone and spheromak CMEs, leading to different CME expansions. Such discrepancies can be mitigated by initialising spheromak CMEs with a reduced speed corresponding to the radial speed only. Results at Earth evidence that the spheromak model improves the predictions of B(Bz) up to 12-60(22-40) percentage points compared to a cone model. Considering virtual spacecraft located around Earth, B(Bz) predictions reach 45-70%(58-78%) of the observed peak values. The spheromak model predicts inaccurate magnetic field parameters at Earth for CMEs propagating away from the Sun-Earth line, while it successfully predicts the CME properties and arrival time in the case of strictly Earth-directed events. Modelling CMEs propagating away from the Sun-Earth line requires extra care due to limitations related to the assumed spherical shape. The spatial variability of modelling results and the typical uncertainties in the reconstructed CME direction advocate the need to consider predictions at Earth and at virtual spacecraft around it.

In this study we present a statistical analysis of 53 fast Earth-directed halo CMEs observed by the SOHO/LASCO instrument during the period Jan. 2009-Sep. 2015, and we use this CME sample to test the capabilities of a Sun-to-Earth prediction scheme for CME geoeffectiveness. First, we investigate the CME association with other solar activity features by means of multi-instrument observations of the solar magnetic and plasma properties. Second, using coronagraphic images to derive the CME kinematical properties at 0.1 AU, we propagate the events to 1 AU by means of the WSA-ENLIL+Cone model. Simulation results at Earth are compared with in-situ observations at L1. By applying the pressure balance condition at the magnetopause and a solar wind-Kp index coupling function, we estimate the expected magnetospheric compression and geomagnetic activity level, and compare them with global data records. The analysis indicates that 82% of the CMEs arrived at Earth in the next 4 days. Almost the totality of them compressed the magnetopause below geosynchronous orbits and triggered a geomagnetic storm. Complex sunspot-rich active regions associated with energetic flares result the most favourable configurations from which geoeffective CMEs originate. The analysis of related SEP events shows that 74% of the CMEs associated with major SEPs were geoeffective. Moreover, the SEP production is enhanced in the case of fast and interacting CMEs. In this work we present a first attempt at applying a Sun-to-Earth geoeffectiveness prediction scheme - based on 3D simulations and solar wind-geomagnetic activity coupling functions - to a statistical set of potentially geoeffective halo CMEs. The results of the prediction scheme are in good agreement with geomagnetic activity data records, although further studies performing a fine-tuning of such scheme are needed.