We present an analysis of off-limb cool flare loops observed by SDO/AIA during the gradual phase of SOL2017-09-10T16:06 X8.2-class flare. In the EUV channels starting from the 335 {\AA} one, cool loops appear as dark structures against the bright loop arcade. These dark structures were precisely coaligned (spatially and temporally) with loops observed by SST in emission lines of hydrogen and ionized calcium. Recently published semi-empirical model of cool loops based on SST observations serves us to predict the level of hydrogen and helium recombination continua. The continua were synthesized using an approximate non-LTE approach and theoretical spectra were then transformed to AIA signals. Comparison with signals detected inside the dark loops shows that only in AIA 211 {\AA} channel the computed level of recombination continua is consistent with observations for some models, while in all other channels which are more distant from the continua edges the synthetic continuum is far too low. In analogy with on-disk observations of flares we interpret the surplus emission as due to numerous EUV lines emitted from hot but faint loops in front of the cool ones. Finally we briefly comment on failure of the standard absorption model when used for analysis of the dark-loop brightness.

High-resolution spectroscopy of strong chromospheric absorption lines delivers nowadays several millions of spectra per observing day, when using fast scanning devices to cover large regions on the solar surface. Therefore, fast and robust inversion schemes are needed to explore the large data volume. Cloud Model (CM) inversions of the chromospheric H$\alpha$ line are commonly employed to investigate various solar features including filaments, prominences, surges, jets, mottles, and (macro-)spicules. The choice of the CM was governed by its intuitive description of complex chromospheric structures as clouds suspended above the solar surface by magnetic fields. This study is based on observations of active region NOAA 11126 in H$\alpha$, which were obtained 2010 November 18-23 with the echelle spectrograph of the Vacuum Tower Telescope (VTT) at the Observatorio del Teide, Spain. Principal Component Analysis (PCA) reduces the dimensionality of spectra and conditions noise-stripped spectra for CM inversions. Modeled H$\alpha$ intensity and contrast profiles as well as CM parameters are collected in a database, which facilitates efficient processing of the observed spectra. Physical maps are computed representing the line-core and continuum intensity, absolute contrast, equivalent width, and Doppler velocities, among others. Noise-free spectra expedite the analysis of bisectors. The data processing is evaluated in the context of "big data", in particular with respect to automatic classification of spectra.

We present the first images of a coordinated campaign to follow active region NOAA 12709 on 2018 May 13 as part of a joint effort between three observatories (China-Europe). The active region was close to disk center and enclosed a small pore, a tight polarity inversion line and a filament in the chromosphere. The active region was observed with the 1.5-meter GREGOR solar telescope on Tenerife (Spain) with spectropolarimetry using GRIS in the He I 10830 \r{A} spectral range and with HiFI using two broad-band filter channels. In addition, the Lomnicky Stit Observatory (LSO, Slovakia) recorded the same active region with the new Solar Chromospheric Detector (SCD) in spectroscopic mode at H$\alpha$ 6562 \r{A}. The third ground-based telescope was located at the Fuxian Solar Observatory (China), where the active region was observed with the 1-meter New Vacuum Solar Telescope (NVST), using the Multi-Channel High Resolution Imaging System at H$\alpha$ 6562 \r{A}. Overlapping images of the active region from all three telescopes will be shown as well as preliminary Doppler line-of-sight (LOS) velocities. The potential of such observations are discussed.

We study a fragment of a large quiescent filament observed on May 29, 2017 by the Interferometric BIdimensional Spectropolarimeter (IBIS) mounted at the Dunn Solar Telescope. We focus on its quiescent stage prior to its eruption. We analyse the spectral observations obtained in the H$\alpha$ line to derive the thermodynamic properties of the plasma of the observed fragment of the filament. We used a 2D filament model employing radiative transfer computations under conditions that depart from the local thermodynamic equilibrium. We employed a forward modelling technique in which we used the 2D model to producesynthetic H_alpha line profiles that we compared with the observations. We then found the set of model input parameters, which produces synthetic spectra with the best agreement with observations. Our analysis shows that one part of the observed fragment of the filament is cooler, denser, and more dynamic than its other part that is hotter, less dense, and more quiescent. The derived temperatures in the first part range from 6,000 K to 10,000$ K and in the latter part from 11,000 K to 14,000 K. The gas pressure is 0.2-0.4 dyn/cm}^{2} in the first part and around 0.15 dyn/cm}^{2} in the latter part. The more dynamic nature of the first part is characterised by the line-of-sight velocities with absolute values of 6-7 km/s and microturbulent velocities of 8-9 km/s. On the other hand, the latter part exhibits line-of-sight velocities with absolute values 0-2.5 km/s and microturbulent velocities of 4-6 km/s.

The paper analyzes the structure and dynamics of a quiescent prominence that occurred on October 22, 2013. We aim to determine the physical characteristics of the observed prominence using MgII k and h, CII (1334 and 1336 A), and SiIV (1394 A) lines observed by IRIS. We employed the 1D non-LTE modeling of MgII lines assuming static isothermal-isobaric slabs. We selected a large grid of models with realistic input parameters and computed synthetic MgII lines. The method of Scargle periodograms was used to detect possible prominence oscillations. We analyzed 2160 points of the observed prominence in five different sections along the slit averaged over ten pixels due to low signal to noise ratio in the CII and SiIV lines. We computed the integrated intensity for all studied lines, while the central intensity and reversal ratio was determined only for both MgII and CII 1334 lines. We plotted several correlations: time evolution of the integrated intensities and central intensities, scatter plots between all combinations of line integrated intensities, and reversal ratio as a function of integrated intensity. We also compared MgII observations with the models. Results show that more than two-thirds of MgII profiles and about one-half of CII 1334 profiles are reversed. Profiles of SiIV are generally unreversed. The MgII and CII lines are optically thick, while the SiIV line is optically thin. The studied prominence shows no global oscillations in the MgII and CII lines. Therefore, the observed time variations are caused by random motions of fine structures with velocities up to 10 km/s. The observed average ratio of MgII k to MgII h line intensities can be used to determine the prominence's characteristic temperature. Certain disagreements between observed and synthetic line intensities of MgII lines point to the necessity of using more complex 2D multi-thread modeling in the future.

We observed an arch filament system (AFS) in a sunspot group with the GREGOR Infrared Spectrograph attached to the GREGOR solar telescope. The AFS was located between the leading sunspot of negative polarity and several pores of positive polarity forming the following part of the sunspot group. We recorded five spectro-polarimetric scans of this region. The spectral range included the spectral lines Si I 1082.7 nm, He I 1083.0 nm, and Ca I 1083.9 nm. In this work we concentrate on the silicon line which is formed in the upper photosphere. The line profiles are inverted with the code `Stokes Inversion based on Response functions' to obtain the magnetic field vector. The line-of-sight velocities are determined independently with a Fourier phase method. Maximum velocities are found close to the ends of AFS fibrils. These maximum values amount to 2.4 km/s next to the pores and to 4 km/s at the sunspot side. Between the following pores, we encounter an area of negative polarity that is decreasing during the five scans. We interpret this by new emerging positive flux in this area canceling out the negative flux. In summary, our findings confirm the scenario that rising magnetic flux tubes cause the AFS.

Accurate knowledge of the spectral transmission profile of a Lyot filter is important, in particular in comparing observations with simulated data. The paper summarizes available facts about the transmission profile of the DOT H$\alpha$ Lyot filter pointing to a discrepancy between sidelobe-free Gaussian-like profile measured spectroscopically and signatures of possible leakage of parasitic continuum light in DOT H$\alpha$ images. We compute wing-to-center intensity ratios resulting from convolutions of Gaussian and square of the sinc function with the H$\alpha$ atlas profile and compare them with the ratios derived from observations of the quiet Sun chromosphere at disk center. We interpret discrepancies between the anticipated and observed ratios and the sharp limb visible in the DOT H$\alpha$ image as an indication of possible leakage of parasitic continuum light. A method suggested here can be applied also to indirect testing of transmission profiles of other Lyot filters. We suggest two theoretical transmission profiles of the DOT H$\alpha$ Lyot filter which should be considered as the best available approximations. Conclusive answer can only be given by spectroscopic re-measurement of the filter.

Aims: Changes of the magnetic field and the line-of-sight velocities in the photosphere are being reported for an M-class flare that originated at a $\delta$-spot belonging to active region NOAA 11865. Methods: High-resolution ground-based near-infrared spectropolarimetric observations were acquired simultaneously in two photospheric spectral lines, Fe I 10783 \AA\ and Si I 10786 \AA, with the Tenerife Infrared Polarimeter at the Vacuum Tower Telescope (VTT) in Tenerife on 2013 October 15. The observations covered several stages of the M-class flare. Inversions of the full-Stokes vector of both lines were carried out and the results were put into context using (extreme)-ultraviolet filtergrams from the Solar Dynamics Observatory (SDO). Results: The active region showed high flaring activity during the whole observing period. After the M-class flare, the longitudinal magnetic field did not show significant changes along the polarity inversion line (PIL). However, an enhancement of the transverse magnetic field of approximately 550 G was found that bridges the PIL and connects umbrae of opposite polarities in the $\delta$-spot. At the same time, a newly formed system of loops appeared co-spatially in the corona as seen in 171 \AA\ filtergrams of the Atmospheric Imaging Assembly (AIA) on board SDO. However, we cannot exclude that the magnetic connection between the umbrae already existed in the upper atmosphere before the M-class flare and became visible only later when it was filled with hot plasma. The photospheric Doppler velocities show a persistent upflow pattern along the PIL without significant changes due to the flare. Conclusions: The increase of the transverse component of the magnetic field after the flare together with the newly formed loop system in the corona support recent predictions of flare models and flare observations.

Arch filament systems occur in active sunspot groups, where a fibril structure connects areas of opposite magnetic polarity, in contrast to active region filaments that follow the polarity inversion line. We used the GREGOR Infrared Spectrograph (GRIS) to obtain the full Stokes vector in the spectral lines Si I 1082.7 nm, He I 1083.0 nm, and Ca I 1083.9 nm. We focus on the near-infrared calcium line to investigate the photospheric magnetic field and velocities, and use the line core intensities and velocities of the helium line to study the chromospheric plasma. The individual fibrils of the arch filament system connect the sunspot with patches of magnetic polarity opposite to that of the spot. These patches do not necessarily coincide with pores, where the magnetic field is strongest. Instead, areas are preferred not far from the polarity inversion line. These areas exhibit photospheric downflows of moderate velocity, but significantly higher downflows of up to 30 km/s in the chromospheric helium line. Our findings can be explained with new emerging flux where the matter flows downward along the fieldlines of rising flux tubes, in agreement with earlier results.

In this paper we study the soft X-ray (SXR) signatures of one particular prominence. The X-ray observations used here were made by the Hinode/XRT instrument using two different filters. Both of them have a pronounced peak of the response function around 10 A. One of them has a secondary smaller peak around 170 A, which leads to a contamination of SXR images. The observed darkening in both of these filters has a very large vertical extension. The position and shape of the darkening corresponds nicely with the prominence structure seen in SDO/AIA images. First we have investigated the possibility that the darkening is caused by X-ray absorption. But detailed calculations of the optical thickness in this spectral range show clearly that this effect is completely negligible. Therefore the alternative is the presence of an extended region with a large emissivity deficit which can be caused by the presence of cool prominence plasmas within otherwise hot corona. To reproduce the observed darkening one needs a very large extension along the line-of-sight of the region amounting to around 10$^5$ km. We interpret this region as the prominence spine, which is also consistent with SDO/AIA observations in EUV.

We present non-LTE diagnostics of the filament observed by SOHO/SUMER on May 27, 2005 in the whole Lyman series. The filament was situated close to the disk center. The Ly_alpha observations were carried out with normal voltage of detector A. The slit was placed at the central part of the detector -- outside the Ly_alpha attenuator. Therefore, the observed profiles of this line could be calibrated reliably.