Following an established protocol of science, that results must be reproducible, we examine the Gaussian fits to Galactic 21-cm emission profiles obtained by two seemingly complementary methods: the semi-automated approach based on the method used by Verschuur (2004) and the automated technique of Nidever et al. (2008). Both methods use data from the Leiden/Argentine/Bonn all-sky survey. The appeal of an automated routine is great, if for no other reason than the time saved over semi-automated fits. The pitfalls, however, are often unanticipated, and the most important aspect of any algorithm is the reproducibility of the results. The comparisons led to the identification of four problems with the Nidever et al. (2008) analysis: (1) different methods of calculating the reduced chi-squared measuring the goodness of fit; (2) an ultra-broad component found bridging the gap between low and intermediate velocity gas; (3) the lack of an imposed spatial coherence allowing different components to appear and disappear in profiles separated by a fraction of a beam width; and (4) multiple, fundamentally different solutions for the profiles at both the North and South Galactic Poles. A two-step method would improve the algorithm, where an automated fit is followed by a quality-assurance, visual inspection. Confirming evidence emerges from this study of a pervasive component with a line width of order 34 km/s, which may be explained by the Critical Ionization Velocity (CIV) of helium. Since the Nidever et al. (2008) paper contains the only result in the refereed literature that contradicts the CIV model, it is important to understand the flaws in the analysis that let to this contradiction.

Gaussian analysis of new, high-angular-resolution interstellar 21-cm neutral hydrogen emission profile structure more clearly reveals the presence of the previously reported signature of the critical ionization velocity ({\it CIV}) of Helium (34 km s$^{-1}$). The present analysis includes 1496 component line widths for 178 neutral hydrogen profiles in two areas of sky at galactic latitudes around $-$50$^\circ$, well away from the galactic plane. The new data considered here allow the interstellar abundance of Helium to be calculated, and the derived value of 0.095 $\pm$ 0.020 compares extremely well with the value of 0.085 for the cosmic abundance based on solar data. Although the precise mechanisms that give rise to the {\it CIV} effect in interstellar space are not yet understood, our results may provide additional motivation for further theoretical study of how the mechanism operates.

We have expanded upon earlier work that investigates the relative importance of coronal loops with isothermal $versus$ multithermal cross-field temperature distributions. These results are important for determining if loops have substructure in the form of unresolved magnetic strands. We have increased the number of loops targeted for temperature analysis from 19 to 207 with the addition of 188 new loops from multiple regions. We selected all loop segments visible in the 171-\AA\ images of the Atmospheric Imaging Assembly (AIA) that had a clean background. 86 of the new loops were rejected because they could not be reliably separated from the background in other AIA filters. 61 loops required multithermal models to reproduce the observations. 28 loops were effectively isothermal, that is, the plasma emission to which AIA is sensitive could not be distinguished from isothermal emission, within uncertainties. 10 loops were isothermal. Also part of our inventory were one small flaring loop, one very cool loop whose temperature distribution could not be constrained by the AIA data, and one loop with inconclusive results. Our survey can confirm an unexpected result from the pilot study: we found no isothermal loop segments where we could properly use the 171-to-193 ratio method, which would be similar to the analysis done for many loops observed with TRACE and EIT. We recommend caution to observers who assume the loop plasma is isothermal, and hope that these results will influence the direction of coronal heating models and the efforts modelers spend on various heating scenarios.

In this study we have compared coronal loops in the Extreme ultraviolet Imaging Telescope (EIT) on-board the Solar and Heliospheric Observatory (SOHO) with coronal loops from the Transition Region and Coronal Explorer (TRACE). The purpose of which is to quantitatively and qualitatively examine the effects of spatial resolution on the width of coronal loops and implications for how a coronal loop is defined. Out of twenty-two loop sections analyzed, we find that none of them were resolved in EIT and none of them were close to the width of the TRACE loops. These findings suggest that coronal loops are unresolved in EIT. We also find examples of how unresolved loops can be quite misleading. We have also found that many of the TRACE loops that we have analyzed may be unresolved as well. Our findings emphasize the importance of studying loop width in order to better understand coronal loops and also emphasize the need for instruments with higher spatial resolution.

The Atmospheric Imaging Assembly (AIA) onboard the Solar Dynamics Observatory is a state-of-the-art imager with the potential to do unprecedented time-dependent multi-thermal analysis at every pixel on scales short compared to the radiative and conductive cooling times. Recent results, however, have identified missing spectral lines in the CHIANTI atomic physics data base, which is used to construct the instrument response functions. We have done differential emission measure analysis using simultaneous AIA and Hinode/EIS observations of six X-ray bright points. Our results not only support the conclusion that CHIANTI is incomplete near 131 angstroms, but more importantly, suggest that the peak temperature of the Fe VIII emissivity/response is likely to be closer to log T = 5.8 than to the current value of log T = 5.7. Using a revised emissivity/response calculation for Fe VIII, we find that the observed AIA 131-angstrom flux can be underestimated by about 1.25, which is smaller than previous comparisons.

The frequency of heating events in the corona is an important constraint on the coronal heating mechanisms. Observations indicate that the intensities and velocities measured in active region cores are effectively steady, suggesting that heating events occur rapidly enough to keep high temperature active region loops close to equilibrium. In this paper, we couple observations of Active Region 10955 made with XRT and EIS on \textit{Hinode} to test a simple steady heating model. First we calculate the differential emission measure of the apex region of the loops in the active region core. We find the DEM to be broad and peaked around 3\,MK. We then determine the densities in the corresponding footpoint regions. Using potential field extrapolations to approximate the loop lengths and the density-sensitive line ratios to infer the magnitude of the heating, we build a steady heating model for the active region core and find that we can match the general properties of the observed DEM for the temperature range of 6.3 $<$ Log T $<$ 6.7. This model, for the first time, accounts for the base pressure, loop length, and distribution of apex temperatures of the core loops. We find that the density-sensitive spectral line intensities and the bulk of the hot emission in the active region core are consistent with steady heating. We also find, however, that the steady heating model cannot address the emission observed at lower temperatures. This emission may be due to foreground or background structures, or may indicate that the heating in the core is more complicated. Different heating scenarios must be tested to determine if they have the same level of agreement.

We present the science case for a broadband X-ray imager with high-resolution spectroscopy, including simulations of X-ray spectral diagnostics of both active regions and solar flares. This is part of a trilogy of white papers discussing science, instrument (Bandler et al. 2010), and missions (Bookbinder et al. 2010) to exploit major advances recently made in transition-edge sensor (TES) detector technology that enable resolution better than 2 eV in an array that can handle high count rates. Combined with a modest X-ray mirror, this instrument would combine arcsecondscale imaging with high-resolution spectra over a field of view sufficiently large for the study of active regions and flares, enabling a wide range of studies such as the detection of microheating in active regions, ion-resolved velocity flows, and the presence of non-thermal electrons in hot plasmas. It would also enable more direct comparisons between solar and stellar soft X-ray spectra, a waveband in which (unusually) we currently have much better stellar data than we do of the Sun.

Surprisingly few solar coronal loops have been observed simultaneously with TRACE and SOHO/CDS, and even fewer analyses of these loops have been conducted and published. The SOHO Joint Observing Program 146 was designed in part to provide the simultaneous observations required for in-depth temperature analysis of active region loops and determine whether these loops are isothermal or multithermal. The data analyzed in this paper were taken on 2003 January 17 of AR 10250. We used TRACE filter ratios, emission measure loci, and two methods of differential emission measure analysis to examine the temperature structure of three different loops. TRACE and CDS observations agree that Loop 1 is isothermal with Log T $=$ 5.85, both along the line of sight as well as along the length of the loop leg that is visible in the CDS field of view. Loop 2 is hotter than Loop 1. It is multithermal along the line of sight, with significant emission between 6.2 $<$ Log T $<$ 6.4, but the loop apex region is out of the CDS field of view so it is not possible to determine the temperature distribution as a function of loop height. Loop 3 also appears to be multithermal, but a blended loop that is just barely resolved with CDS may be adding cool emission to the Loop 3 intensities and complicating our results. So, are coronal loops isothermal or multithermal? The answer appears to be yes!

The X-Ray Telescope (XRT) on the Japanese/USA/UK {\it Hinode (Solar-B)} spacecraft has detected emission from a quiescent active region core that is consistent with nanoflare heating. The fluxes from 10 broadband X-ray filters and filter combinations were used to constructed Differential Emission Measure (DEM) curves. In addition to the expected active region peak at Log T = 6.3-6.5, we find a high-temperature component with significant emission measure at Log T $>$ 7.0. This emission measure is weak compared to the main peak -- the DEM is down by almost three orders of magnitude -- which accounts of the fact that it has not been observed with earlier instruments. It is also consistent with spectra of quiescent active regions: no Fe XIX lines are observed in a CHIANTI synthetic spectrum generated using the XRT DEM distribution. The DEM result is successfully reproduced with a simple two-component nanoflare model.

Resonance scattering has often been invoked to explain the disagreement between the observed and predicted line ratios of Fe XVII 15.01 A to Fe XVII 15.26 A (the ``3C/3D'' ratio). In this process photons of 15.01, with its much higher oscillator strength, are preferentially scattered out of the line of sight, thus reducing the observed line ratio. Recent laboratory measurements, however, have found significant inner-shell Fe XVI lines at 15.21 and 15.26 Angstroms, suggesting that the observed 3C/3D ratio results from blending. Given our new understanding of the fundamental spectroscopy, we have re-examined the original solar spectra, identifying the Fe XVI 15.21 line and measuring its flux to account for the contribution of Fe XVI to the 15.26 flux. Deblending brings the 3C/3D ratio into good agreement with the experimental ratio; hence, we find no need to invoke resonance scattering. Low opacity in Fe XVII 15.01 also implies low opacity for Fe XV 284.2, ruling out resonance scattering as the cause of the fuzziness of TRACE and SOHO EIT 284-Angstrom images. The images must, instead, be unresolved due to the large number of structures at this temperature. Insignificant resonance scattering implies that future instruments with higher spatial resolution could resolve the active region plasma into its component loop structures.

The observations from 1998 April 20 taken with the Coronal Diagnostics Spectrometer CDS on SOHO of a coronal loop on the limb have shown that the plasma was multi-thermal along each line of sight investigated, both before and after background subtraction. The latter result relied on Emission Measure Loci plots, but in this Letter, we used a forward folding technique to produce Differential Emission Measure curves. We also calculate DEM-weighted temperatures for the chosen pixels and find a gradient in temperature along the loop as a function of height that is not compatible with the flat profiles reported by numerous authors for loops observed with EIT on SOHO and TRACE. We also find discrepancies in excess of the mathematical expectation between some of the observed and predicted CDS line intensities. We demonstrate that these differences result from well-known limitations in our knowledge of the atomic data and are to be expected. We further show that the precision of the DEM is limited by the intrinsic width of the ion emissivity functions that are used to calculate the DEM. Hence we conclude that peaks and valleys in the DEM, while in principle not impossible, cannot be confirmed from the data.

The standard solar model was so reliable that it could predict the existence of the massive neutrino. Helioseismology measurements were so precise that they could determine the depth of the convection zone. This agreement between theory and observation was the envy of all astrophysics -- until recently when sophisticated three-dimensional hydrodynamic calculations of the solar atmosphere reduced the metal content by a factor of almost two. Antia & Basu (2005) suggested that a higher value of the solar neon abundance, Ne/O = 0.52, would resolve this controversy. Drake & Testa (2005) presented strong evidence in favor of this idea from a sample of 21 Chandra stars with enhanced values of the neon abundance, Ne/O = 0.41. In this paper, we have analyzed solar active region spectra from the archive of the Flat Crystal Spectrometer on Solar Maximum Mission, a NASA mission from the 1980s, as well as full-Sun spectra from the pioneering days of X-ray astronomy in the 1960s. These data seem consistent with the standard neon-to-oxygen abundance value, Ne/O = 0.15 (Grevesse & Sauval 1998). If these results prove to be correct, than the enhanced-neon hypothesis will not resolve the current controversy.

The 1998 April 20 spectral line data from the Coronal Diagnostics Spectrometer (CDS) on the {\it Solar and Heliospheric Observatory} (\SOHO) shows a coronal loop on the solar limb. Our original analysis of these data showed that the plasma was multi-thermal, both along the length of the loop and along the line of sight. However, more recent results by other authors indicate that background subtraction might change these conclusions, so we consider the effect of background subtraction on our analysis. We show Emission Measure (EM) Loci plots of three representative pixels: loop apex, upper leg, and lower leg. Comparisons of the original and background-subtracted intensities show that the EM Loci are more tightly clustered after background subtraction, but that the plasma is still not well represented by an isothermal model. Our results taken together with those of other authors indicate that a variety of temperature structures may be present within loops.