sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Saylor, Mike

Normalized to: Saylor, M.

6 article(s) in total. 88 co-authors, from 1 to 4 common article(s). Median position in authors list is 15,5.

[1]  oai:arXiv.org:2006.11358  [pdf] - 2119143
A possible polar origin for the FRB associated with a Galactic magnetar
Comments: Submitted to Nature
Submitted: 2020-06-19
Fast Radio Bursts (FRBs) are millisecond-long radio pulses of extragalactic origin with peak luminosities far exceeding any Milky Way sources. The prevalent invocation for the FRB origin involves magnetars: young, magnetically powered neutron stars with the strongest magnetic fields in the Universe. A magnetar-defining signature is the emission of bright, hard X-ray bursts of sub-second duration. These occur in isolation or during a burst storm, when several hundred are observed within minutes to hours. On April 27th 2020, the Galactic magnetar SGR J1935+2154 entered an active period, emitting hundreds of X-ray bursts in a few hours. Remarkably, only one of these temporally coincided with an FRB-like radio burst. Here we report on the spectral and temporal analyses of 24 X-ray bursts emitted 13 hours prior to the FRB and seen simultaneously with NASA NICER and Fermi/GBM missions in their combined energy range. We demonstrate that the FRB-associated X-ray burst is very similar temporally, albeit strikingly different spectrally, from the 24 NICER/GBM bursts. If the FRB-associated burst were drawn from this magnetar burst population, its occurrence rate would be at most around 1 in 7000. This rarity combined with the unusual X-ray burst spectrum is perhaps indicative of an uncommon locale for the origin of the FRB-associated burst. We suggest that this unique event originated in quasi-polar open or closed magnetic field lines extending to high altitudes where radio emission can be generated, possibly from a collimated plasma flow.
[2]  oai:arXiv.org:1807.09100  [pdf] - 1743826
On the 2018 outburst of the accreting millisecond X-ray pulsar Swift J1756.9-2508 as seen with NICER
Comments: 9 pages, 4 figures, 2 tables. Accepted for publication in ApJ
Submitted: 2018-07-24
We report on the coherent timing analysis of the 182 Hz accreting millisecond X-ray pulsar Swift J1756.9$-$2508 during its 2018 outburst as observed with the Neutron Star Interior Composition Explorer (NICER). Combining our NICER observations with Rossi X-ray Timing Explorer observations of the 2007 and 2009 outbursts, we also studied the long-term spin and orbital evolution of this source. We find that the binary system is well described by a constant orbital period model, with an upper limit on the orbital period derivative of $|\dot P_b| < 7.4\times 10^{-13}$ s s$^{-1}$. Additionally, we improve upon the source coordinates through astrometric analysis of the pulse arrival times, finding R.A. = $17^{\rm h}56^{\rm m}57.18^{\rm s}\pm0.08^{\rm s}$ and Decl. = $-25^{\circ}06'27.8''\pm3.5''$, while simultaneously measuring the long-term spin frequency derivative as $\dot\nu = -7.3\times 10^{-16}$ Hz s$^{-1}$. We briefly discuss the implications of these measurements in the context of the wider population of accreting millisecond pulsars.
[3]  oai:arXiv.org:1407.8205  [pdf] - 1216025
Commissioning ShARCS: the Shane Adaptive optics infraRed Camera-Spectrograph for the Lick Observatory 3-m telescope
Comments: 9 pages, 7 figures. Presented at SPIE Astronomical Telescopes + Instrumentation conference, paper 9148-118
Submitted: 2014-07-30
We describe the design and first-light early science performance of the Shane Adaptive optics infraRed Camera-Spectrograph (ShARCS) on Lick Observatory's 3-m Shane telescope. Designed to work with the new ShaneAO adaptive optics system, ShARCS is capable of high-efficiency, diffraction-limited imaging and low-dispersion grism spectroscopy in J, H, and K-bands. ShARCS uses a HAWAII-2RG infrared detector, giving high quantum efficiency (>80%) and Nyquist sampling the diffraction limit in all three wavelength bands. The ShARCS instrument is also equipped for linear polarimetry and is sensitive down to 650 nm to support future visible-light adaptive optics capability. We report on the early science data taken during commissioning.
[4]  oai:arXiv.org:1407.8207  [pdf] - 1216027
ShaneAO: wide science spectrum adaptive optics system for the Lick Observatory
Comments: 11 pages, 10 figures. Presented at SPIE Astronomical Telescopes + Instrumentation conference, paper 9148-76
Submitted: 2014-07-30
A new high-order adaptive optics system is now being commissioned at the Lick Observatory Shane 3-meter telescope in California. This system uses a high return efficiency sodium beacon and a combination of low and high-order deformable mirrors to achieve diffraction-limited imaging over a wide spectrum of infrared science wavelengths covering 0.8 to 2.2 microns. We present the design performance goals and the first on-sky test results. We discuss several innovations that make this system a pathfinder for next generation AO systems. These include a unique woofer-tweeter control that provides full dynamic range correction from tip/tilt to 16 cycles, variable pupil sampling wavefront sensor, new enhanced silver coatings developed at UC Observatories that improve science and LGS throughput, and tight mechanical rigidity that enables a multi-hour diffraction- limited exposure in LGS mode for faint object spectroscopy science.
[5]  oai:arXiv.org:1407.8209  [pdf] - 1216029
Opto-Mechanical Design of ShaneAO: the Adaptive Optics System for the 3-meter Shane Telescope
Comments: 14 pages, 14 figures, 4 tables. Presented at SPIE Astronomical Telescopes + Instrumentation conference, paper 9148-119
Submitted: 2014-07-30
A Cassegrain mounted adaptive optics instrument presents unique challenges for opto-mechanical design. The flexure and temperature tolerances for stability are tighter than those of seeing limited instruments. This criteria requires particular attention to material properties and mounting techniques. This paper addresses the mechanical designs developed to meet the optical functional requirements. One of the key considerations was to have gravitational deformations, which vary with telescope orientation, stay within the optical error budget, or ensure that we can compensate with a steering mirror by maintaining predictable elastic behavior. Here we look at several cases where deformation is predicted with finite element analysis and Hertzian deformation analysis and also tested. Techniques used to address thermal deformation compensation without the use of low CTE materials will also be discussed.
[6]  oai:arXiv.org:1402.6684  [pdf] - 1203597
APF - The Lick Observatory Automated Planet Finder
Comments: Accepted at PASP. Version with full resolution available at http://oklo.org/Vogt_APF_2014.pdf
Submitted: 2014-02-26
The Automated Planet Finder (APF) is a facility purpose-built for the discovery and characterization of extrasolar planets through high-cadence Doppler velocimetry of the reflex barycentric accelerations of their host stars. Located atop Mt. Hamilton, the APF facility consists of a 2.4-m telescope and its Levy spectrometer, an optical echelle spectrometer optimized for precision Doppler velocimetry. APF features a fixed format spectral range from 374 nm - 970 nm, and delivers a "Throughput" (resolution * slit width product) of 114,000 arc-seconds, with spectral resolutions up to 150,000. Overall system efficiency (fraction of photons incident on the primary mirror that are detected by the science CCD) on blaze at 560 nm in planet-hunting mode is 15%. First-light tests on the RV standard stars HD 185144 and HD 9407 demonstrate sub-meter per second precision (RMS per observation) held over a 3-month period. This paper reviews the basic features of the telescope, dome, and spectrometer, and gives a brief summary of first-light performance.