Latency in the control loop of adaptive optics (AO) systems can severely limit performance. Under the frozen flow hypothesis linear predictive control techniques can overcome this, however identification and tracking of relevant turbulent parameters (such as wind speeds) is required for such parametric techniques. This can complicate practical implementations and introduce stability issues when encountering variable conditions. Here we present a nonlinear wavefront predictor using a Long Short-Term Memory (LSTM) artificial neural network (ANN) that assumes no prior knowledge of the atmosphere and thus requires no user input. The ANN is designed to predict the open-loop wavefront slope measurements of a Shack-Hartmann wavefront sensor (SH-WFS) one frame in advance to compensate for a single-frame delay in a simulated $7\times7$ single-conjugate adaptive optics (SCAO) system operating at 150 Hz. We describe how the training regime of the LSTM ANN affects prediction performance and show how the performance of the predictor varies under various guide star magnitudes. We show that the prediction remains stable when both wind speed and direction are varying. We then extend our approach to a more realistic two-frame latency system. AO system performance when using the LSTM predictor is enhanced for all simulated conditions with prediction errors within 19.9 to 40.0 nm RMS of a latency-free system operating under the same conditions compared to a bandwidth error of $78.3\pm4.4$ nm RMS.

Shack-Hartmann wavefront sensors for both solar and laser guide star adaptive optics (with elongated spots) need to observe extended objects. Correlation techniques have been successfully employed to measure the wavefront gradient in solar adaptive optics systems and have been proposed for laser guide star systems. In this paper we describe a method for synthesising reference images for correlation Shack-Hartmann wavefront sensors with a larger field of view than individual sub-apertures. We then show how these supersized reference images can increase the performance of correlation wavefront sensors in regimes where large relative shifts are induced between sub-apertures, such as those observed in open-loop wavefront sensors. The technique we describe requires no external knowledge outside of the wavefront-sensor images, making it available as an entirely "software" upgrade to an existing adaptive optics system. For solar adaptive optics we show the supersized reference images extend the magnitude of shifts which can be accurately measured from 12% to 50% of the field of view of a sub-aperture and in laser guide star wavefront sensors the magnitude of centroids that can be accurately measured is increased from 12% to 25% of the total field of view of the sub-aperture.

An important factor which affects performance of solar adaptive optics (AO) systems is the accuracy of tracking an extended object in the wavefront sensor. The accuracy of a centre-ofmass approach to image shift measurement depends on the parameters applied in thresholding the recorded image; however, there exists no analytical prediction for these parameters for extended objects. Motivated by this we present a new method for exploring the parameter space of image shift measurement algorithms, and apply this to optimize the parameters of the algorithm. Using a thresholded, windowed centre of mass, we are able to improve centroid accuracy compared to the typical parabolic fitting approach by a factor of 3 in a signal-to-noise regime typical for solar AO. Exploration of the parameters occurs after initial image crosscorrelation with a reference image, so does not require regeneration of correlation images. The results presented employ methods which can be used in real-time to estimate the error on centroids, allowing the system to use real data to optimize parameters, without needing to enter a separate calibration mode. This method can also be applied outside of solar AO to any field which requires the tracking of an extended object.

Numerical Simulation is an essential part of the design and optimisation of astronomical adaptive optics systems. Simulations of adaptive optics are computationally expensive and the problem scales rapidly with telescope aperture size, as the required spatial order of the correcting system increases. Practical realistic simulations of AO systems for extremely large telescopes are beyond the capabilities of all but the largest of modern parallel supercomputers. Here we describe a more cost effective approach through the use of hardware acceleration using field programmable gate arrays. By transferring key parts of the simulation into programmable logic, large increases in computational bandwidth can be expected. We show that the calculation of wavefront sensor image centroids can be accelerated by a factor of four by transferring the algorithm into hardware. Implementing more demanding parts of the adaptive optics simulation in hardware will lead to much greater performance improvements, of up to 1000 times.