The relationship between the peak velocities of high-speed solar wind streams near Earth and the areas of their solar source regions, i.e., coronal holes, has been known since the 1970s, but it is still physically not well understood. We perform 3D magnetohydrodynamic (MHD) simulations using the European Heliospheric Forecasting Information Asset (EUHFORIA) code to show that this empirical relationship forms during the propagation phase of high-speed streams from the Sun to Earth. For this purpose, we neglect the acceleration phase of high-speed streams, and project the areas of coronal holes to a sphere at 0.1 au. We then vary only the areas and latitudes of the coronal holes. The velocity, temperature, and density in the cross section of the corresponding highspeed streams at 0.1 au are set to constant, homogeneous values. Finally, we propagate the associated high-speed streams through the inner heliosphere using the EUHFORIA code. The simulated high-speed stream peak velocities at Earth reveal a linear dependence on the area of their source coronal holes. The slopes of the relationship decrease with increasing latitudes of the coronal holes, and the peak velocities saturate at a value of about 730 km/s, similar to the observations. These findings imply that the empirical relationship between the coronal hole areas and high-speed stream peak velocities does not describe the acceleration phase of high-speed streams, but is a result of the high-speed stream propagation from the Sun to Earth.

Coronal holes are usually defined as dark structures as seen in the extreme ultraviolet and X-ray spectrum which are generally associated with open magnetic field. Deriving reliably the coronal hole boundary is of high interest, as its area, underlying magnetic field, and other properties give important hints towards high speed solar wind acceleration processes and on compression regions arriving at Earth. In this study we present a new threshold based extraction method that incorporates the intensity gradient along the coronal hole boundary, which is implemented as a user-friendly SSWIDL GUI. The Collection of Analysis Tools for Coronal Holes (CATCH) enables the user to download data, perform guided coronal hole extraction and analyze the underlying photospheric magnetic field. We use CATCH to analyze non-polar coronal holes during the SDO-era, based on 193 {\AA} filtergrams taken by the Atmospheric Imaging Assembly (AIA) and magnetograms taken by the Heliospheric and Magnetic Imager (HMI), both on board the Solar Dynamics Observatory (SDO). Between 2010 and 2019 we investigate 707 coronal holes that are located close to the central meridian. We find coronal holes distributed across latitudes of about +/- 60 degree for which we derive sizes between 1.6 x 10 9 and 1.8 x 10 11 km^2 . The absolute value of the mean signed magnetic field strength tends towards an average of 2.9 +/- 1.9 G. As far as the abundance and size of coronal holes is concerned, we find no distinct trend towards the northern or southern hemisphere. We find that variations in local and global conditions may significantly change the threshold needed for reliable coronal hole extraction and thus, we can highlight the importance of individually assessing and extracting coronal holes.

In order to address the growing need for more accurate space weather predictions, a new model named EUHFORIA (EUropean Heliospheric FORecasting Information Asset) was recently developed (Pomoell and Poedts, 2018). We present first results of the performance assessment for the solar wind modeling with EUHFORIA and identify possible limitations of its present setup. Using the basic EUHFORIA 1.0.4. model setup with the default input parameters, we modeled background solar wind (no coronal mass ejections) and compared the obtained results with ACE, in situ measurements. For the need of statistical study we developed a technique of combining daily EUHFORIA runs into continuous time series. The combined time series were derived for the years 2008 (low solar activity) and 2012 (high solar activity) from which in situ speed and density profiles were extracted. We find for the low activity phase a better match between model results and observations compared to the considered high activity time interval. The quality of the modeled solar wind parameters is found to be rather variable. Therefore, to better understand the obtained results we also qualitatively inspected characteristics of coronal holes, sources of the studied fast streams. We discuss how different characteristics of the coronal holes and input parameters to EUHFORIA influence the modeled fast solar wind, and suggest possibilities for the improvements of the model.