We describe a theoretical procedure for analyzing astronomical phased arrays with overlapping beams, and apply the procedure to simulate a simple example. We demonstrate the effect of overlapping beams on the number of degrees of freedom of the array, and on the ability of the array to recover a source. We show that the best images are obtained using overlapping beams, contrary to common practise, and show how the dynamic range of a phased array directly affects the image quality.

Low-noise phased arrays are essential for the next generation of microwave and submillimetre wave astronomy. We analyze their behaviour from a functional perspective, and show that their operation is intimately related to the mathematical theory of frames. No assumptions are made about the orthogonality or linear independence of the synthesised beams. Frame theory allows an unambiguous assessment of whether the outputs of an array can be used to observe a field or brightness distribution within a given class. Image reconstruction is carried out using dual beams. We identify the natural modes of phased arrays, and carry out an analysis of noise. The scheme allows the expectation values, the mean-square fluctuations, and the correlations between fluctuations at the output ports of a phased array to be determined for a source in any state of spatial coherence. Both classical and photon-counting statistics are included. Our model is conceptually powerful, and suggests many simulation and image recovery techniques.

Focal plane arrays of bolometers are increasingly employed in astronomy at far--infrared to millimetre wavelengths. The focal plane fields and the detectors are both partially coherent in these systems, but no account has previously been taken of the effect of partial coherence on array performance. In this paper, we use our recently developed coupled--mode theory of detection together with Fisher information matrix techniques from signal processing to characterize the behaviour of partially coherent imaging arrays. We investigate the effects of the size and coherence length of both the source and the detectors, and the packing density of the array, on the amount of information that can be extracted from observations with such arrays.

Filled arrays of bolometers are currently being employed for use in astronomy from the far-infrared through millimeter parts of the electromagnetic spectrum. Because of the large range of wavelengths for which such detectors are applicable, the number of modes supported by a pixel will vary according to the specific application of a given available technology. We study the dependence of image fidelity and induced polarization on the size of the pixel by employing a formalism in which diffraction due to the pixel boundary is treated by propagating the second-order statistical correlations of the radiation field through a model optical system. We construct polarized beam pattern images of square pixels for various ratios of p/\lambda where p is the pixel size and \lambda is the wavelength of the radiation under consideration. For the limit in which few modes are supported by the pixel (p/\lambda<1), we find that the diffraction due to the pixel edges is non-negligible and hence must be considered along with the telescope diffraction pattern in modeling the ultimate spatial resolution of an imaging system. For the case in which the pixel is over-moded (p/\lambda>1), the geometric limit is approached as expected. This technique gives a quantitative approach to optimize the imaging properties of arrays of planar detectors in the few-mode limit.

Microwave, submillimetre-wave, and far-infrared phased arrays are of considerable importance for astronomy. We consider the behaviour imaging phased arrays and interferometric phased arrays from a functional perspective. It is shown that the average powers, field correlations, power fluctuations, and correlations between power fluctuations at the output ports of an imaging or interferometric phased array can be found once the synthesised reception patterns are known. The reception patterns do not have to be orthogonal or even linearly independent. It is shown that the operation of phased arrays is intimately related to the mathematical theory of frames, and that the theory of frames can be used to determine the degree to which any class of intensity or field distribution can be reconstructed unambiguously from the complex amplitudes of the travelling waves at the output ports. The theory can be used to set up a likelihood function that can, through Fisher information, be used to determine the degree to which a phased array can be used to recover the parameters of a parameterised source. For example, it would be possible to explore the way in which a system, perhaps interferometric, might observe two widely separated regions of the sky simultaneously.