Characterizing the surface material of an asteroid is important for understanding its geology and for informing mission decisions, such as the selection of a sample site. Diurnal surface temperature amplitudes are directly related to the thermal properties of the materials on the surface. We describe a numerical model for studying the thermal conductivity of particulate regolith in vacuum. Heat diffusion and surface-to-surface radiation calculations are performed using the finite element (FE) method in three-dimensional meshed geometries of randomly packed spherical particles. We validate the model for test cases where the total solid and radiative conductivity values of particulates with monodisperse particle size frequency distributions (SFDs) are determined at steady-state thermal conditions. Then, we use the model to study the bulk radiative thermal conductivity of particulates with polydisperse, cumulative power-law particle SFDs. We show that for each polydisperse particulate geometry tested, there is a corresponding monodisperse geometry with some effective particle diameter that has an identical radiative thermal conductivity. These effective diameters are found to correspond very well to the Sauter mean particle diameter, which is essentially the surface-area-weighted mean. Next, we show that the thermal conductivity of the particle material can have an important effect on the radiative component of the thermal conductivity of particulates, especially if the particle material conductivity is very low or the spheres are relatively large, owing to non-isothermality in each particle. We provide an empirical correlation to predict the effects of non-isothermality on radiative thermal conductivity in both monodisperse and polydisperse particulates.

We present a new method for the determination of the surface properties of airless bodies from measurements of the emitted infrared flux. Our approach uses machine learning techniques to train, validate, and test a neural network representation of the thermophysical behavior of the atmosphereless body given shape model, illumination and observational geometry of the remote sensors. The networks are trained on a dataset of thermal simulations of the emitted infrared flux for different values of surface rock abundance, roughness, and values of the thermal inertia of the regolith and of the rock components. These surrogate models are then employed to retrieve the surface thermal properties by Markov Chain Monte Carlo Bayesian inversion of observed infrared fluxes. We apply the method to the inversion of simulated infrared fluxes of asteroid (101195) Bennu -- according to a geometry of observations similar to those planned for NASA's OSIRIS-REx mission -- and infrared observations of asteroid (25143) Itokawa. In both cases, the surface properties of the asteroid -- such as surface roughness, thermal inertia of the regolith and rock component, and relative rock abundance -- are retrieved; the contribution from the regolith and rock components are well separated. For the case of Itokawa, we retrieve a rock abundance of about 85% for pebbles larger than the diurnal skin depth, which is about 2 cm. The thermal inertia of the rock is found to be lower than the expected value for LL chondrites, indicating that the rocks on Itokawa could be fractured. The average thermal inertia of the surface is around 750 $J s^{-1/2} K^{-1} m^{-2}$ and the measurement of thermal inertia of the regolith corresponds to an average regolith particle diameter of about 10 mm, consistently with in situ measurements as well as results from previous studies.

The University of Hawaii Wide-Field Imager (UHWFI) is a focal compressor system designed to project the full half-degree field of the UH 2.2 m telescope onto the refurbished UH 8Kx8K CCD camera. The optics use Ohara glasses and are mounted in an oil-filled cell to minimize light losses and ghost images from the large number of internal lens surfaces. The UHWFI is equipped with a six-position filter wheel and a rotating sector blade shutter,both driven by stepper motors. The instrument saw first light in 2004 in an engineering mode. After filling the lens cell with index matching oil, integration of all software components into the user interface, tuning of the CCD performance, and the purchase of the final filter set, UHWFI is now fully commissioned at the UH 2.2 m telescope.